gas collector Articles

  • Wet Dust Collectors: Options and Operations

    A wet dust collector comes in the choice of three variations and these are: gas/liquid contact, gas/liquid separation and gas humidification. The difference between the three is based on how the dust is collected and separated inside the system. A wet dust collector, also known as a wet scrubber, ...


    By ProVent, LLC

  • Keep your air clean with Wet Dust Collectors

    Wet dust collectors use liquid — often but not always simple water — to capture and separate dust, mist, fumes, and other particulate matter from a stream of flowing gas — often but not always simple air. Some wet dust collectors spray liquid in a sheet across the stream of gas; others bubble the gas through ...


    By ProVent, LLC

  • Filter Your Air with Cartridge Dust Collector

    A cartridge dust collector uses filtering cartridges and is a self-cleaning dust collector. The cartridges it uses are made from synthetic fibers and cellulose that is treated chemically. This ensures the particles are efficiently collected without forming an excessive pressure drop in the system. Structure A cartridge dust collector uses an air-jet cleaning structure to preserve ...


    By ProVent, LLC

  • Application of the Steam Jet Aerosol Collector (SJAC) for differential measurements of organic compounds in the gas vs. particle phase

    A modified Steam Jet Aerosol Collector (SJAC) for semivolatile organic compounds has been investigated. Gas phase and particle phase were investigated separately. The SJAC is based on a water condensational growth sampling system. For determination of gaseous compounds an XAD adsorbent cartridge was applied after particle collection. Collection particle efficiency was examined using hydrophobic ...


    By Inderscience Publishers

  • Uni-wash wet dust collectors reduce industrial dust hazards

    Metal dust — it can be a fabricator’s worst nightmare. In particular, the combination of dry aluminum dust and steel dust is literally a disaster waiting to happen. The National Fire Protection Association has a list of metal dusts and the specific PPM that the air can hold of each before the serious risk of an explosion arises. As a worksite approaches the PPM safety limits of one or ...


    By ProVent, LLC

  • MOL oil & gas refinery

    MOL Hungarian Oil & Gas Plc is the national Oil & Gas company for Hungary, it forms part of the large MOL Group and is by far the largest, in terms of turnover for the Hungarian sector as a whole. The project is a first for the region. API Settlers DEWACO supplied a fully functional sludge removal system comprising of: 6 nos. Chain & Flight type sludge and scum ...


    By Dewaco Ltd

  • Controlling acid gas mists

    Gas cleaning New and strict pollution regulations in metallurgical plants worldwide are restricting particulate and acid gas emissions to extremely low levels. Because of that, sulphuric acid plants are being installed to remove and utilise S02 in gases resulting from the roasting of sulphide ores, smelting of ores, and burning or regeneration of spent acid or acid sludge from ...


    By Beltran Technologies, Inc.

  • The design and installation of the gas collection system

    The designer of gas collection plants has the task to fulfill optimally the important criteria: stability of gas quality efficiency of collection economic viability of the plant The stabilisation of the gas quality helps to solve the problem between the uneven gas production of the landfill on the one side and ...


    By Hofstetter BV

  • What is the Purpose of a Gas Diffusion Layer (GDL)?

    The Gas Diffusion Layer (GDL) plays several critical roles in a typical fuel cell application and is often integrated as part of the Membrane Electrode Assembly (MEA). Typical applications that use GDLs consist of Polymer Electrolyte  ...


    By Fuel Cells Etc

  • Membranes and theoretical modelling of liquid–gas membrane separation for aromatic compounds removal from water: a review

    Liquid–gas membrane separation techniques - namely, vacuum membrane distillation, membrane air–stripping/sweeping and pervaporation - are non–equilibrium membrane separation processes emerging for the removal of aromatic compounds from industrial wastewater and polluted ground waters. This review focuses on polymeric hydrophobic membranes which are commonly employed in the liquid–gas membrane ...


    By Inderscience Publishers

  • Laboratory, pilot and industrial-scale validation of numerically optimized reverse-flow gas cyclones

    This paper addresses the experimental validation of the optimum design of reverse-flow gas-cyclones, obtained through the solution of a numerical non-linear optimization problem, viz. maximizing cyclone collection. The simulation model is based on the predictive properties of a finite diffusivity model, where the particles' turbulent dispersion coefficient is estimated through an empirical ...

  • Optimal anaerobic digestion of high BOD waste with an acclimatised and fresh seed culture combination

    With rising energy costs and increasing environmental pollution, this paper looks at how treatment of biological waste is emerging as a cost-effective solution towards both these problems.Keywords: anaerobic digestion, biological waste, environmental pollution, autohydrolysate, biogas, biochemical oxygen demand, BOD, chemical oxygen demand, COD, digestion, effluent, fatty acids, gas collector, ...


    By Inderscience Publishers

  • Animalistic heat

    Rearing animals requires a lot of patience, dedication and above all, constant warmth. Since this very year, a farmer from Schrozberg, Germany, relies on cost cutting technologies, namely solar thermal heating and wood chip heating. A constant temperature of 45 degrees Celsius is crucial to breed piglets. Enormous costs were the result of utilizing gas heating to provide a constant temperature ...


    By TiSUN GmbH

  • Hurricane and ReCyclone® systems: Modelling and application to emission control and value added product recovery

    The development of high efficiency Hurricane® and ReCyclone® systems allows their application either to emission control or to value added product recovery. The purpose of this paper is to present not only the performance of these systems, but also a model to predict in a more realistic way the collection efficiency of a gas cyclone with or without partial recirculation. ReCyclone® ...

  • Particulate matter, halogen and aerosols - Case Study

    Example: Production of anodes for aluminium smelters as well as electronic industry (TFT-LCD) Similar tasks: Carbon and graphite industry, smelting of aluminium, coating of metals An anode producer has several ring furnaces to stabilise the anodes by carbonization for later processing in a melting bath. The hot exhaust gases pass through double walls in between the anodes where the gases ...

  • Pilot and Industrial-Scale Experimental Investigation of Numerically Optimized Cyclones

    A new geometry of reverse-flow gas cyclones obtained by numerical optimization was shown at the laboratory scale to be significantly more efficient than other high-efficiency designs. However, it is usually recognized that experimental results obtained with laboratory-scale or sampling cyclones cannot be extrapolated to pilot or industrial scales. The present paper confirms, at these larger ...

  • On rooftops worldwide, a solar water heating revolution

    The harnessing of solar energy is expanding on every front as concerns about climate change and energy security escalate, as government incentives for harnessing solar energy expand, and as these costs decline while those of fossil fuels rise. One solar technology that is really beginning to take off is the use of solar thermal collectors to convert sunlight into heat that can be used to warm ...


    By Earth Policy Institute

  • Wet electrostatic precipitators: A preferred technology for emission control

    The basic science behind electrostatic precipitators is as familiar and as simple as static cling. But today, this elemental force has been harnessed to a technology that is helping to remove millions of tons of toxic chemicals from our atmosphere; saving billions of dollars annually in pollution-related physical damage; and averting costly impacts on health and mortality rates for millions of ...


    By Beltran Technologies, Inc.

  • Casebook New Scrubber Technology reduces installation costs case study

    A100,0000-actual-cubic-feet-per-minute (acfm) RotaBed scrubber recently supplied to Tri-Gen Biopower for sulfur dioxide (S02) control at Gilman Paper, St. Mary's, Ga., saved the company an estimated $150,000 in installation costs-Installation of a heavier packed tower would have required extensive reinforcement of an existing steel support structure, said Ken Schifftner, product/district manager ...


    By Bionomic Industries Inc.

  • Innovative Dryer and Emission Control System at a Particleboard Installation

    In 1989, Bohemia Corporation installed a new primary drying system and also air pollution control equipment at their particleboard plant in Eugene, Oregon. The drying system was composed of a Westec America triple-pass rotary drum dryer fired by a Coen sanderdust burner. The primary and secondary particulate collectors installed were also of a Westec America design. The tertiary air pollution ...

Need help finding the right suppliers? Try XPRT Sourcing. Let the XPRTs do the work for you