gas engine control Articles

  • Reduced Emissions for Landfill Gas Installations

    The use of landfill gas as a source of renewable energy is increasing. For environmental and safety reasons, the owners of the waste storage sites have to strictly monitor and control the construction, operations, and emissions generated. Sulzer offers solutions to control these emissions within the limits given by the government. Landfill gas is similar to natural gas, but it is created by ...


    By Sulzer

  • Taking Control of Gas Engine Issues

    In an effort to gain maximum engine performance and stay within the local exhaust emission limits over a wide range of engine load and ambient conditions, operators at the County Sanitation Districts of Los Angeles County’s Joint Water Pollution Control Plant wastewater treatment plant near downtown Los Angeles have installed Continental Controls Corp. ECV5 ...

  • New White Paper on FTIR multigas analysis

    Quantitech has announced the publication of a free White Paper on the simultaneous measurement of multiple gases in a wide variety of applications using FTIR (Fourier Transform InfraRed) technology. With the ability to measure almost any gas, FTIR monitoring technology is employed in an enormous variety of applications including Continuous Emissions Monitoring, Stack Testing, Process Control, ...


    By Quantitech Ltd

  • Controlling acid gas mists

    Gas cleaning New and strict pollution regulations in metallurgical plants worldwide are restricting particulate and acid gas emissions to extremely low levels. Because of that, sulphuric acid plants are being installed to remove and utilise S02 in gases resulting from the roasting of sulphide ores, smelting of ores, and burning or regeneration of spent acid or acid sludge from ...


    By Beltran Technologies, Inc.

  • Emissions Test Report - Gas Compressor Engines

    INTRODUCTION In 2004, Northeast Texas Air Care (NETAC) commissioned a pilot project to demonstrate the effectiveness of available ...


    By DCL International Inc.

  • Microturbines, Gas Engines Link Biogas to the Grid

    OPPORTUNITIES to produce electricity from methane are being improved continuously as manufacturers introduce new and upgraded equipment to address market needs and varying characteristics of raw biogas. In the renewable energy from organics recycling arena, the two primary types of electricity generation equipment are microturbines and reciprocating gas engines. This article provides a brief ...


    By BioCycle Magazine

  • Gas Monitoring for Ventilation Control and Energy Management

    The growing demand for underground and enclosed parking and maintenance garages (resulting from limitations on land availability) has increased the awareness and need for proper ventilation and control systems. In addition, increased health and safety programs have only added to the concerns of toxic and combustible gases in confined or enclosed spaces. Historically, ventilation and make-up air ...


    By Arjay Engineering Ltd.

  • Catalytic Exhaust Emission Control of Small Internal Combustion Engines

    ABSTRACT Gaseous emissions present in the engine exhaust of on-road motor vehicles are subject to stringent exhaust emission 2ontrol standards for carbon monoxide (CO), hydrocarbons, and ...


    By DCL International Inc.

  • Can a gas engine use diesel fuel with less pollution?

    Anyone concerned with rising oil prices and pollution from fossil fuel might like to know about a new technology, which addresses both problems. Its application will put an end to the days of sooty smoke seen from accelerating diesel trucks and buses. The ...


  • Generation using gas-fuelled engines in South Africa – an overview

    Most gas engines are Otto cycle spark ignition internal combustion reciprocating engines using natural gas as the primary fuel. Smaller models utilise stochiometric combustion while the larger engines are lean burn engines with pre-chamber ignition systems. The engines are coupled with packaged generator sets, ...


    By Clarke Energy

  • Laser Engineering // The Valuable Technology

    In this seminar we will introduce the Laser engineering as the valuable and modern technology, which can be implemented within the various commercial fields: such as the civil, mechanical, gas & petroleum, chemical, communication, weather inspector, and arms as well as for the arts and medical treatments. The Laser promotion was due to its high velocity, accuracy of sub-micron space, and fine ...


  • Ethylene Plant Treatment Hydrocarbon Engineering

    Ethylene is the most commonly produced petrochemical product. The bulk of annual commercial ethylene production is based on thermal cracking of hydrocarbon feedstocks with steam. Usual raw materials for pyrolysis are refinery gas, liquid petroleum gas (LPG), natural gas liquids (NGL), naphtha or gas oil. The production of ethylene is a very complex process, including cracking, cooling, ...


    By Kurita

  • New engines: Time to clear the air

    In response to new federal emission standards that went into effect Jan. 1, 2010 in the U.S. and Canada, engine manufacturers selected one of two choices to achieve a reduction in emissions of oxides of nitrogen (NOx). They either provide an in-cylinder approach through increased exhaust gas recirculation (EGR) only, or an engine aftertreatment approach using selective catalytic reduction (SCR) ...


    By Waste Advantage Magazine

  • ABUTEC and Venture Engineering Create and Customized System Specific for Processing Natural Gas Liquids - Case Study

    While ABUTEC operates across various industry segments providing the highest efficiency control of waste gas, a majority of the projects and applications ABUTEC participates in lie within the oil industry. Recently, ABUTEC along with experienced process-engineering firm Venture Engineering, was commissioned to create a custom NGL (natural gas liquid) Adsorption system for a natural gas production ...


    By ABUTEC LLC

  • New Approach allows Subscribers to Reach the Summit of the Mountain of Information on Gas Turbine and Reciprocating Engine Technology

    The available information on combustion, flow control, treatment and environmental compliance for gas turbines and reciprocating engines is doubling every few years. It is now more challenging than climbing Mt. Everest to find the most current and relevant information. Rapid developments include zero liquid discharge (ZLD) technologies, repairable valves, high efficiency air inlet filters, ...


    By The McIlvaine Company

  • Material Matters - An Engineering and Fabrication Challenge

    The world of engineering is a very large and diverse universe which ranges from electrial, mechanical and civil to environmentaland structural. It is true that their varied disciplines have many qualities in common, e.g. the mixture of logic, creativity, awareness of cost /benefit ratio etc., are requirements of all engineering. It is equally true that each discipline has its own mind set, ...


    By Fabricated Plastics Limited

  • Gas-to-Energy plant; production of electricity with landfill gas

    Type     Degassing installation HOFGAS®-C7/1000 + HOFGAS®-Ready 600 Commissioning      May 2002 Site     Landfill of Iles Les Meldeuses Situation The landfill is being degassed by a plant we supplied in 1998. For the planned extension phase Hofstetter France Sarl was committed to work out a concept for the enhancement ...


    By Hofstetter BV

  • Gas-to-energy plant; production of electricity with landfill gas

    Type      Degassing installation HOFGAS®- Ready 600 Commissioning      January 2002 Site      Landfill of Bovenfeld (NL) Situation The 9ha large landfill site Bovenfeld is located 150km northeast of Amsterdam. The resulting landfill gas has to be cleaned, in accordance with the local legislation. A degassing ...


    By Hofstetter BV

  • Natural Gas Compressor

    Reciprocating engines come in all sizes, from a tiny, 10cc piston engine that powers a model airplane, to the massive Wartsila RTA 96-C, with each of its 14 cylinders displacing 1,820,000 cc. While our borescopes won’t be much help on the model airplane engine, if you work on any medium or large size reciprocating engine, the chances are good that we have a video borescope that can make ...


    By RF System Lab.

Need help finding the right suppliers? Try XPRT Sourcing. Let the XPRTs do the work for you