gas turbine service Articles

  • Reduced Emissions for Landfill Gas Installations

    The use of landfill gas as a source of renewable energy is increasing. For environmental and safety reasons, the owners of the waste storage sites have to strictly monitor and control the construction, operations, and emissions generated. Sulzer offers solutions to control these emissions within the limits given by the government. Landfill gas is similar to natural gas, but it is created by ...


    By Sulzer

  • Turbine Inspection

    Recent advances in natural gas exploration and extraction technology have led to skyrocketing projections of the amount of recoverable natural gas within US borders. This energy boom will result in the expanded use of gas-fired power plants to provide electricity to US homes and businesses over the coming decades. Not only does this mean cleaner and more abundant energy for the US environment and ...


    By RF System Lab.

  • Gas turbine compliance emissions test case study

    CKwas retained by Lake Road Generating Company, LP (Lake Road) to conduct a compliance emissions test program on three combustion turbine and heat recovery steam generators (CT/HRSG). The purpose of this program is to demonstrate that emissions from the CT/HRSGs are within the emission limits specified in the operating permit issued by the Connecticut Department of Environmental Protection ...


    By CK Environmental, Inc.

  • New Approach allows Subscribers to Reach the Summit of the Mountain of Information on Gas Turbine and Reciprocating Engine Technology

    The available information on combustion, flow control, treatment and environmental compliance for gas turbines and reciprocating engines is doubling every few years. It is now more challenging than climbing Mt. Everest to find the most current and relevant information. Rapid developments include zero liquid discharge (ZLD) technologies, repairable valves, high efficiency air inlet filters, ...


    By The McIlvaine Company

  • In situ weld repair of blade tenon of steam turbine in a power plant

    During one of the routine inspections in a nuclear power plant, it was found that a tenon of one of the third-stage blades of the Low-Pressure (LP) turbine had been worn/broken off the turbine blade, leaving only the remaining tenon riveted to the shroud piece. With only one of the two tenons remaining, the blade was at risk of getting freed from the shroud piece. Hence, it was necessary to ...


    By Inderscience Publishers

  • SGBI opinion article: shale gas

    Government perceives electric vehicles to be a panacea that will solve problems surrounding air quality and CO2 emissions simultaneously. The EV has two main selling points: reduced CO2 emissions and high efficiency. However, these are only valid at a superficial level and the argument disintegrates under any level of scrutiny. In terms of CO2 emissions, EVs replace ‘average’ cars to ...


    By CNG Services Limited

  • Microturbines, Gas Engines Link Biogas to the Grid

    OPPORTUNITIES to produce electricity from methane are being improved continuously as manufacturers introduce new and upgraded equipment to address market needs and varying characteristics of raw biogas. In the renewable energy from organics recycling arena, the two primary types of electricity generation equipment are microturbines and reciprocating gas engines. This article provides a brief ...


    By BioCycle Magazine

  • The Power of Digester Gas, A Technology Review from Micro to Megawatts

    The County Sanitation Districts of Los Angeles County (Districts) operate and maintain both a regional wastewater treatment and a solid waste management system that provide services to approximately five million people in Los Angeles County. This involves treating approximately 520 million gallons a day of wastewater and managing the final disposal of half of the 40,000 tons per day of ...

  • Annual European Union greenhouse gas inventory 1990–2014 and inventory report 2016

    ES.1 Background information on greenhouse gas inventories and climate change The European Union (EU), as a party to the United Nations Framework Convention on Climate Change (UNFCCC), reports annually on greenhouse gas (GHG) inventories for the years between 1990 and the current calendar year (t) minus two (t–2), for emissions and removals within the area covered by its Member ...

  • Heavy Duty 126 MW GT upgrade for aerodynamic performance improvement

    Scope of the Project Turbine Services Ltd. , a supplier of replacement parts for GE Large Frame Gas Turbines, has worked with SoftlnWay's engineering team on the redesign of the third stage of the GE Frame 9E heavy duty gas turbine. The scope of this project included the redesign of the third stage vanes and blades to create components competitive with the GE Advanced ...


    By SoftInWay Inc.

  • Pushing the Limits of Reengineering

    Cutting-edge turbine technology enables more efficient and cleaner power generation. However, the service of advanced gas turbines is challenging—especially when parts need to be replaced. The example of a blade replacement project shows how Sulzer establishes innovative reengineering processes and contributes to a secure energy supply that causes less carbon emission. A Sulzer ...


    By Sulzer

  • Methane as an energy source for the 21st century

    Today, fossil fuels supply about 80% of global primary energy. The consequences are severe for human health from indoor and regional air pollution, acidification due to sulphur and nitrogen oxide emissions and climate change due to rapidly growing greenhouse gas emissions. Therefore, there is a clear need to improve the efficiency and the environmental compatibility of fossil technologies, shift ...


    By Inderscience Publishers

  • Energy recovery potential using micro hydropower in water supply networks in the UK and Ireland

    The supply and treatment of water is a highly energy intensive process, resulting in large amounts of greenhouse gas emissions as well as incurring large economic costs. Both governments and water service providers worldwide recognise the need for more sustainable water supply systems. In recent years, the use of hydropower turbines within water supply networks has been shown as a viable option ...


    By IWA Publishing

  • Notus Clean Energy LLC – Cape Cod, MA - Case Study

    The owners of a Falmouth, MA industrial park parcel saw the potential in 2004 for a utility-scale wind turbine sited in a large, well-elevated location. A large turbine could supply electricity for the complex and create surplus power that could be delivered back to a regional utility. Despite receiving more than 100 letters of support from residents and businesses, the proposal required five ...

  • Clarke Energy & GE`s Distributed Power Collaborate on On-Site Power Plant to Boost Mozambique`s Local Grid - Case Study

    GE Supplying 10 of its J624 Jenbacher Gas Engines for the Kuvaninga Energia Project 40 MW On-Site Power Plant to provide More Reliable Electricity to Grid in Southern Mozambique Clarke Energy Contract Marks First Jenbacher Gas Engine Order in Mozambique Liverpool, UK—GE Power & Water’s Distributed Power business (NYSE: ...


    By Clarke Energy

  • Unbeatable Proximity

    When it comes to refurbishing a rotor in a power plant, delivery time and shipping costs play a major role. Because of its nearby service center, Sulzer was able to make an unbeatable offer to an Indonesian customer and even bring a retired rotor back into operation. Indonesia contains large oil reserves, e.g., at the Duri Field in Sumatra. There, a cogeneration power plant ...


    By Sulzer

  • Industrial Maintenance for Compressor Stations

    Transporting natural gas via pipelines is very safe and cost-efficient. However, in order for the transportation process to work properly it is imperative that the natural gas be kept at the correct pressure. To accomplish this compressor stations are needed at regular intervals. Let’s take a look at some key components of compressor stations as well as industrial maintenance needs. The ...


    By STI Group, Inc.

  • What`s New? Biogas Power

    Technologies that connect the biogas line to the power line include cooling and clean up components, microturbines and reciprocating gas engines and control systems. TOP BILLING on the biogas to electricity stage typically goes to the microturbines and reciprocating gas engines. But in the theater of renewable energy from organics recycling, the show can’t go on without the supporting cast of gas ...


    By BioCycle Magazine

  • The performance characteristics of rubber expansion joint

    Rubber Expansion Jointsmainly use the unique properties of rubber , such as high flexibility, high air tightness, chemical resistance and radiation resistance , high strength , thermal stability and strong polyester composite ply bias with the candidate , by high pressure , crosslinked molded high temperature , the internal high ...

Need help finding the right suppliers? Try XPRT Sourcing. Let the XPRTs do the work for you