gas turbine system Articles

  • Exergetic analysis of gas turbine plants

    An exergetic analysis was performed for a 116-MW gas-turbine power plant. Mass and energy conservation laws were applied to each component of the system. Quantitative exergy balance for each component and for the whole system was considered. In this study, the exergy of a material stream is decomposed into thermal, mechanical and chemical exergy and an entropy-production flow. The effect of a ...


    By Inderscience Publishers

  • Turbine Inspection

    Recent advances in natural gas exploration and extraction technology have led to skyrocketing projections of the amount of recoverable natural gas within US borders. This energy boom will result in the expanded use of gas-fired power plants to provide electricity to US homes and businesses over the coming decades. Not only does this mean cleaner and more abundant energy for the US environment and ...


    By RF System Lab.

  • Exergy analysis of gas-turbine systems with high fogging compression

    Gas-turbine cycles with high fogging compression could offer enhanced efficiency and low complexity. Whereas compression power and heat rates decrease when small amounts of water (up to 2% of air flow by mass) are injected at the machine inlet, increased injection amounts could allow implementation of regeneration, further decreasing the heat rate. In this study, an exergy analysis is carried out ...


    By Inderscience Publishers

  • Thermodynamic evaluation of gas turbines for cogeneration applications

    In this paper, the first and second laws of thermodynamics have been utilised to evaluate the performance of intercooled reheat regenerative gas turbine cogeneration plant. The effects of overall pressure ratio, cycle temperature ratio, pressure losses, and process steam pressure on energetic and exergetic efficiencies have been investigated. The results indicate that most of the exergy ...


    By Inderscience Publishers

  • Exergy analysis of a gas turbine system with evaporative cooling at compressor inlet

    This paper deals with the thermodynamically modelled gas turbine consisting of Media Evaporative Cooling System (MECS) at compressor inlet for investigating the generated power, second law efficiency, and entropy generation number. The parametric study using this model shows effects of ambient conditions, compressor and turbine inlet temperature, and pressure ratio on the gas turbine power and ...


    By Inderscience Publishers

  • Sensitivity analysis of component efficiencies on performance of a gas turbine cogeneration system

    The performance of a 1000 kW gas-turbine cogeneration system was evaluated in terms of performance measures, such as net power, exergy efficiency of the system, and the unit costs of electricity and steam. The efficiencies of some components that have a significant affect on the performance were taken as physical variables. Sensitivity was evaluated by introducing parameters, defined as the ratio ...


    By Inderscience Publishers

  • Gas turbine compliance emissions test case study

    CKwas retained by Lake Road Generating Company, LP (Lake Road) to conduct a compliance emissions test program on three combustion turbine and heat recovery steam generators (CT/HRSG). The purpose of this program is to demonstrate that emissions from the CT/HRSGs are within the emission limits specified in the operating permit issued by the Connecticut Department of Environmental Protection ...


    By CK Environmental, Inc.

  • Gas turbine performance enhancement by intake air cooling

    In this work, the influence of air cooling intake on the gas turbine performance is presented. The proposed system, together with the gas turbine, is described. A mathematical model of ACIGT (Air Cooling Intake Gas Turbine) is derived and formulated in dimensionless form from which the constraint multivariable optimisation problem was formulated. To demonstrate the effectiveness of the proposed ...


    By Inderscience Publishers

  • Regenerative Turbine Aeration Technology

    In order to acquire precise control of input and output fluid/gas parameters, wastewater managers and technicians can utilize a regenerative turbine pump, which fully optimizes the gas dissolution process that properly treats wastewater, time after time. Once such parameters have been completely controlled, a well-designed wastewater treatment system should be able to initiate all necessary ...

  • DAF Regenerative Turbine Aeration

    Rogue Pump Company describes in detail the science and application of the MAX RGT regenerative turbine pump technology for dissolved air flotation or DAF systems.  Whether Operator, Manager or Owner you will come away with an understanding of how the MAX RGT pump works to full advantage.  The author first educates the reader on the precise mechanisms of dissolving a gas (air- nitrogen ...


    By Rogue Pump Company, LLC

  • Energy and exergy analysis of reverse Brayton refrigerator for Gas Turbine power boosting

    In this study the use of Reverse Brayton cycle to boost up the power of gas turbine power plants operating in hot humid ambiance is analysed by the energy and exergy methods. The gas turbine inlet temperature is reduced by mixing the chilled air from Brayton refrigeration cycle and the main intake air stream reaching low intake temperatures. In this paper the effect of irreversibilities in the ...


    By Inderscience Publishers

  • Optimisation of micro gas turbine by exergy, economic and environmental (3E) analysis

    This research proposes a new method for optimisation of a power generation system based on exergy fuel cost and external social cost of air pollution. A thermodynamic model is provided to estimate the outlet mass flow rates of CO2, CO, NO and NO2 for a gas turbine based on maximising the first and second law efficiencies and minimising the objective function. Results show that inclusion of the ...


    By Inderscience Publishers

  • Risk-based maintenance of gas expansion turbines in steel plant

    Unexpected failures, loss of production, higher maintenance costs and down time associated with the failures of equipment are major problems in any plant. Adopting the risk-based maintenance (RBM) approach helps in designing an alternative strategy to minimise the loss resulting from these breakdowns or failures. The methodology consists of four modules: system definition, risk assessment, risk ...


    By Inderscience Publishers

  • Thermodynamic analysis of a hybrid gas turbine/thermoacoustic heat pump/refrigeration engine

    Possible performance enhancement of small gas turbine power plants through the application of thermoacoustic systems is examined. The thermoacoustic subsystem is powered only by the waste heat of the gas turbine. Two different gas turbine configurations are considered: a Thermoacoustic refrigerator assisted gas turbine (TRG) and a Combined thermoacoustic heat pump and refrigeration assisted gas ...


    By Inderscience Publishers

  • The effect of elevated inlet air temperature and relative humidity on Gas Turbine cogeneration system: exergy assessment

    This research aims to quantify the exergy destructions of Gas Turbine (GT) cogeneration system under different inlet air temperatures and humidity. Three different cogeneration schemes were examined in this research: conventional GT, GT-Single Pressure HRSG and GT-Dual Pressure HRSG. A parametric study was carried out in terms of exergy destruction and second-law efficiency. The exergy ...


    By Inderscience Publishers

  • PRME Naturally Gas Systems

    Your PRME Naturally produced biogas will come from biomass – not fossil fuels. Technically speaking, you will be firing gas produced by the thermal gasification of biomass. PRME’s NaturallyGas process design is not experimental or “under development”, but has been commercially firing industrial boilers for over eighteen years. PRME’s NaturallyGas Systems are ...


    By PRM Energy Systems, Inc.

  • Co-production of synthesis gas and power by integration of Partial Oxidation reactor, gas turbine and air separation unit

    A new synthesis gas production process based on partial oxidation (POX) of natural gas is investigated. Synthesis gas and mechanical power are generated in a plant that integrates a POX reactor, a synthesis gas turbine and an air separation unit. The synthesis gas is expanded in the turbine which runs the air separation unit. By means of an exergy analysis, it is shown that the synthesis gas ...


    By Inderscience Publishers

  • Animation: How Wind Turbines Work

    The windmill, which converts wind into rotational energy to mill grain or pump water, has been around since antiquity. It’s even been claimed that Ancient Babylonians planned to harness wind as early as almost 4,000 years ago, as part of a scheme for one of Hammurabi’s ambitious irrigation projects. By the end of the 19th century, wind energy took on a whole new meaning as engineers ...


    By GLOBE Foundation

  • Combined fuel cell?gas turbine plant for highly efficient power generation from renewable energy sources

    The impact of renewable energy sources on today's energy supply substantiates the importance of hydrogen as an energy carrier. Hydrogen can be directly produced from solar energy and is considered a promising technology for temporary storage of electrical energy from wind turbines and photovoltaic systems. The generation of electrical energy from stored hydrogen requires highly efficient systems ...


    By Inderscience Publishers

  • Exergy analysis of a combined fuel cell and Gas Turbine Power Plant with intercooling and reheating

    This paper presents a comparative exergy study of the performance of various gas turbine power generation plants and a high temperature Solid Oxide Fuel Cell (SOFC). The overall system is analysed and its exergy efficiency and exergy destruction are obtained, as well as individual models of each component. The results for selected operating conditions are compared against past literature data. ...


    By Inderscience Publishers

Need help finding the right suppliers? Try XPRT Sourcing. Let the XPRTs do the work for you