geophysical data software Articles

  • Performing CALPUFF Analyses with Pseudo-station Data Derived from MM5 Data

    The U.S. Environmental Protection Agency (EPA) recommends that CALPUFF be used as the preferred model for long-range transport analyses in the proposed “Guideline on Air Quality Modeling” (April 2000). In practice, CALPUFF has been routinely required by the Federal Land Managers (FLM), EPA, and state regulatory agencies for Class I area analyses for several years. These analyses include regional ...

  • Analyzing and representing Downhole information on a daily basis using ESdat and Encom Discover - Case Study

    GHD used ESdat to optimize data collection and analysis and minimize data handling when working with downhole data information. 3D data output was provided by Encom Discover. Overview GHD is an professional services consultancy – 6000+ staff and offices in Australia, Middle East, Asia & Americas.  GIS used extensively within GHD with a ...

  • Case Study - The Oluz Mound Archaeological Site Investigation

    Amasya, Turkey The Oluz Mound is a very important ancient Turkish settlement with a history stretching back 4,500 years BC. Objective To help an on going arcaeological excavations and to show possible structural extensions or new remains on the side by using the Geophysical Electrical Resistivity Tomography (ERT) imaging method. ...


    By Advanced Geosciences, Inc.

  • Identification of Archeological Remnants

    Czorsztyn Castle, Poland 2D Electrical Imaging Objective Study area was within the ruins of the 14th century Czorsztyn Castle, located in the boundaries of Pieniny National Park (southern Poland). The main goal of this research was to check if one of the stone wall residues continues under the ground surface. Additionally, an attempt was ...


    By Advanced Geosciences, Inc.

  • UncerTZ Consortium - Time to Depth Conversion Evolved

    Near the end of 2015 Geovariances committed itself into building a new, sophisticated tool for Time to Depth conversion in Reservoir Characterization. The challenges petitioned by the consortium partners were not easy. It included features such as: more choices in conversion (and less of a “black box”), uncertainty characterization, inclusion of faults in the conversion procedure, ...


    By Geovariances

  • GPR: a new tool for structural health monitoring of infrastructure

    Abstract Recent developments in acquisition methodology, data acquisition systems, post-processing software, and the availability of user friendly high-frequency antennas have enabled the GPR user to generate accurate three dimensional images of the interior of concrete structures. Four case studies are discussed with emphasis on output that is readily understood by the ...


    By SewerVUE

  • S2C2 Inc. utilizes EQuIS, RockWorks and ArcGIS implementing the Triad approach

    When implementing the Triad Approach, S2C2 Inc. (S2C2) relies upon EarthSoft’s EQuIS,ESRI’s ArcGIS and Rockware’s RockWorks software toptimize the management andvisualization of large data sets. The USEPA’s Triad Approach incorporates the following threecomponents: systematic planning, real-time measurements and dynamic work strategies. Theprimary goal of this approach is tstreamline site ...


    By EarthSoft, Inc

  • A Comparison of 2D and 3D IP from Copper Hill NSW

    SUMMARY This paper compares the results from 2D inversion of 2D data, 3D inversion of 2D data and 3D inversion of 3D data from a 3D pole-dipole MIMDAS IP survey conducted near Copper Hill NSW. Six 1.5km lines were laid out over the area of interest at 200m spacings. Data were collected using ‘pole-dipole’ geometry with 100m dipoles. All receiver ...

  • Geotechnical examples

    This is a collection of various cases where the 2D resistivity imaging method pioneered by Advanced Geosciences Inc have been successfully applied. Click on a section below ...


    By Advanced Geosciences, Inc.

Need help finding the right suppliers? Try XPRT Sourcing. Let the XPRTs do the work for you