geophysical logging Articles

  • Borehole Log Interpretation

    While employed with Conoco, Inc. analyzed and correlated well-log data in order to produce geologic structural maps of subsurface horizons in Louisiana and Oklahoma, for the purpose of oil and gas prospect generation. Analyzed and correlated well-log data in order to map the top of a highly permeable subsurface formation that was utilized as an injection zone for the disposal of brines generated ...


    By ECA Geophysics

  • Borehole logging case study

    Corozal, Puerto Rico GeoView was tasked to conduct borehole geophysical logging of at a groundwater extraction well in the rural area of the Municipality of Corozal, Puerto Rico. Prior groundwater tests indicated possible contamination of the groundwater. The study area was primarily underlain by stratified, mostly dark gray basaltic tuff, andesite and basalt porphyry rocks assigned to ...


    By GeoView, Inc.

  • Vertical disparity in electrical conductivity of groundwater: inferring water-bearing fractures in granitic aquifer

    A detailed study was conducted in hard rock terrain for delineating water-bearing fractures using electrical conductivity (EC) logs. The EC logs of groundwater were taken both in pre- and post-monsoon seasons of the year 2001; in 25 borewells in a small granitic watershed at an interval of 1 m right from the water table (though narrow spacing wherever required) till the depth to bottom of the ...


    By Inderscience Publishers

  • Case Study - Remedial Investigation - Former Vickers Refinery, Potwin, Kansas

    MWH carried out this comprehensive investigation in order to characterize soil, geology, surface water, and groundwater and identify possible source areas and potential contaminant migration pathways. Additionally, this investigation evaluated hydraulic pathways and the interaction between aquifers, evaluate the performance of the recovery wells, and evaluate groundwater and surface water ...


    By EI LLC

  • A GIS-based methodology to delineate aquifer recharge areas

    A GIS-based methodology to delineate risk areas for contamination of groundwater resources is presented by identifying recharge conditions to the aquifer. Identifying the recharge areas is based upon surface and subsurface geologic conditions that may control the risk of potential oil spill contaminants into the aquifer. This study uses the Chicot aquifer system in southwest Louisiana as a pilot ...


    By Inderscience Publishers

  • ASC Tech Services

    Environmental contamination is risky business, to access risk, high-tech and unique geophysical site characterization methods can be employed. By utilizing these high tech gadgets that describe the ground and detail exactly what can’t be seen. Just like the Silicon Valley, new methods have surfaced and now more than ever it is easy to characterize the subsurface using direct push tools. ...


    By ASC Tech Services

  • Managanese study: Severn Trent

    Severn Trent Water operates a number of boreholes which abstract water from the underlying Sherwood Sandstone aquifer in the West Midlands.  Prior to 2000, manganese concentrations at one of these sources were reported to be <5µg/l but by 2002 were found to be significantly higher than this.  This posed a possible threat to the source.  Further sampling in 2007 suggested ...

  • A New Approach to Measuring Dilatancy in Saturated Sands

    The determination of in situ properties of sand has proven to be a difficult objective, especially when it includes assessing volume change characteristics like dilatancy. Difficulty in obtaining representative undisturbed specimens as well as problems with extrapolating laboratory test results to the field has caused many to place increased reliance on in situ testing. One such test that is ...


    By ASTM International

  • Shield Environmental Assoc. Defeats Bedrock Contamination with BOS 200® at Truck Stop

    Shield Environmental Associates (Lexington, KY) has faced some daunting challenges over many years of successful service to their clients, but this one was remarkable. The Problem: A 320 foot long dissolved BTEX plume in both shallow and deep zones in lithology very unfriendly to direct push sampling or injections. The Team: Shield Environmental Associates ...

  • In Situ Chemical Oxidation Remediation Pilot Study Of A Karst Bedrock Aquifer Contaminated With Chlorinated Solvents

    ABSTRACT A pilot study to evaluate an innovative in situ treatment technology was implemented at Letterkenny Army Depot, Chambersburg, Pennsylvania, for a limestone bedrock aquifer contaminated with chlorinated solvents. This technology destroys VOCs in groundwater, utilizing a network of injection points to deliver a solution of hydrogen peroxide (50%), catalysts, and surfactants. The ...


    By Weston Solutions, Inc

  • Engineering Geology

    This is a collection of various cases where the 2D resistivity imaging method pioneered by Advanced Geosciences Inc have been successfully applied. Click on a section below and you will be shown a full 2D resistivity imaging brochure detailing the ...


    By Advanced Geosciences, Inc.

  • Assessing the transport and fate of MTBE

    Untitled Document ...


    By Solinst Canada Ltd.

  • Multilevel Systems

    Untitled Document Introduction A multilevel system is a groundwater monitoring device which allows ...


    By Solinst Canada Ltd.

  • Low-Flow (Minimal Drawdown) Ground-Water Sampling Procedures

    Untitled Document Background The Regional Superfund Ground Water Forum is a group of ground-water ...


    By Solinst Canada Ltd.

  • Multilevel Groundwater Assessment of Confining Unit in a Bedrock Sequence near Sarnia, Ontario

    Untitled Document INTRODUCTION Two sites in southern Ontario were studied through instrumentation ...


    By Solinst Canada Ltd.

Need help finding the right suppliers? Try XPRT Sourcing. Let the XPRTs do the work for you