hazardous area instrument Articles

  • Classifying Hazardous Areas

    The IEC is composed of approximately 40 countries including the United States. The purpose of the IEC is to establish standards for a wide variety of electrical products with the intent of encouraging international trade. The IEC has assigned a technical committee, TC 31, to develop recommendations covering equipment, testing procedures and classification standards for areas where the potential ...

  • Flammable Hazards

    Flammable Hazards The difference between a gas and a vapor is that vapors arise from liquids, whereas gases are normally in a gaseous state. Flammable vapors present additional sampling concerns (for example, we must prevent vapors from returning to the liquid state during sampling). The 3 Elements of Fire Three elements must be present for a flammable ...

  • Area Monitoring: Diffusion Sampling

    Indoor and outdoor gas hazards that exist in open areas are usually monitored using diffusion-type sensors. A diffusion sensor has no active sample-drawing system; diffusion sensors rely on the ambient air movement and pressure to deliver the sample to the sensing element. Diffusion-type sensors are a reliable and cost-effective way to monitor open area gas hazards. When installing diffusion ...

  • Oxford instruments case study

    Delivering operational efficiency Oxford Instruments specialises in the design, manufacture and support of high-technology tools and systems for industry, research, space, energy, defence and healthcare. Business needs Oxford Instruments needed to improve the management of Health & Safety acrossall locations. A gap analysis identified a number of key ...


    By Rivo Software Ltd.

  • CO2 Gas Hazards in the Brewing Industry

    The hazards associated with CO2 in the brewing industry are well known, yet people still die needlessly every year in tragic and completely avoidable accidents in breweries. Just last year in Germany, which has a good safety record, two workers died in separate incidents at the same brewery. In the first incident, the owner was found dead with his head and torso in a beer mixing tank. It is ...

  • Hazardous waste and not, Baioni-Dicatech system

    The identification, characterization and restoration of contaminated areas now represent a big environmental issue, both at European and national level. In the major industrialized countries the issue of contaminated land has come out in all its gravity in the late seventies when, against a widespread awakening of environmental consciousness, important pollutions events emerged. Consequently, in ...


    By Baioni Crushing Plants Spa

  • Gill Instruments case study featured in AWE International

    AWE International magazine, which is focused on the environmental analysis industry, recently featured Gill Instruments in a case study about environmental monitoring with solid-state meteorological instruments. The case study includes information about all of the products within the Gill Instruments range, with information about their advantages within the environmental analysis field. We have ...


    By Gill Instruments Limited

  • GIS in Petro Gas Pipeline Integrity and Hazard Consequence Analaysis

    GIS APPLICATION FOR PETRO & GAS PIPELINES SYSTEMS The major challenges facing the Petro and Gas pipeline supply and distribution Industry are: Isolated and distant location of operating and service areas from the well drilling locations and source points  Distributed customers with varying patterns of consumption. Variety in plant and equipment with periodic operational and ...


  • Paint booths, or areas using combustible gases: why a requirement for combustible gas monitor might be necessary

    Paint booths save time and ensure a smooth and professional application of paint in a range of industries, including automotive, aerospace, home decor, furniture, and more. Combustible gases and fluids in the paint booth environment can pose a health hazard if something goes wrong. Explore the hidden dangers of paint booth fluids and gases, and learn how a ...

  • Exploring nature-based solutions - The role of green infrastructure in mitigating the impacts of weather- and climate change-related natural hazards

    Natural resource scarcity, climate change impacts, continued employment crises, public budget debts and economic recovery plans are some of the challenges that governments in Europe currently face. Moreover, Member States in the European Union (EU) need to continue building or rebuilding roads, sewage systems, levees, etc. (also known as grey infrastructure). Despite being essential for economic ...

  • Fixed multi-parameter gas detection system can ensure industrial facilities are safe from hazardous or toxic gases

    Industrial workplaces are likely to come across one or more hazardous or toxic gases. Combustible gases such as methane are highly dangerous because they can cause large and fatal explosions when ignited. Other problem areas when working in industry are carbon monoxide (which poisons the cardiovascular system), oxygen deficiency, and elevated levels of other gases and pollutants, depending and ...


    By PPM Technology

  • The determination of major and minor elements in air filters and urine for hazard assessment, using a new CCD DUAL-VIEWED ICP optical emission spectrometer

    This article describes the application of a new type of CCD-based, dualviewed ICP optical emission spectrometer for the analyses of industrial hygiene types of samples. Several trace elements in air filter media are determined by ICP-OES. Urinary electrolytes and trace elements are determined in a single dilution automatically in both the axial and radial plasma viewing orientations. Results of ...


    By PerkinElmer, Inc.

  • Intrinsically safe ultrasonic wind sensor

    The Gill Instruments Intrinsically Safe WindObserver™ is an ultrasonic wind sensor, developed specifically for use in hazardous areas and in particular for offshore applications. The sensor has no moving parts, utilising Gill Instruments’ advanced ultrasonic measurement technology to accurately monitor wind speed and direction. Approved to EEx ia IIC T5, this ultrasonic wind sensor is a ...


    By Gill Instruments Limited

  • Monitoring DMA level case study

    ABIC, a leading provider of veterinary products chooses MonoScan to monitor the level of DMA (Dimethylamine) tank in one of its plants located in Israel. ABIC, wholly owned by Teva Pharmaceutical Industries Ltd, is Israel's largest veterinary products manufacturer. The company produces a wide range of vaccines for poultry and livestock and other animals. ABIC's plants are equipped with ...

  • Suez SITA - The purchase of a RQ Box measurement network motivated by a fast ROI case study

    The site Non-hazardous waste storage center Located at Villeneuve sur Verberie, France 200.000 tons of waste processed each year Odor control misting system, 1 kilometer long Challenges To recognize and quantify the odors emitted by the rehabilitated area and the fresh waste area To validate the ...


    By Alpha MOS Environment

  • Case study - N°NG1 – Natural gas monitoring – Medor Exp

    Context & Challenges Natural gas used for household consumption typically contains odorant sulfur components for safety reasons. As natural gas is normally odorless, the sulfur components are artificially added. When natural gas is transported between various companies, regions or countries, gas companies have to verify that the sulfur species are present as specified. ...


    By Chromatotec Group

  • Read about Confined Space in Construction and Atmospheric Testing Right Here!

    In 1993, 29 CFR 1910.146 went into effect as the first federal legislation governing entry into permit-required confined spaces in general industry. Because some industries, such as the construction industry, were covered by specific Occupational Safety and Health Administration (OSHA) safety regulations, they were exempt from the confined space entry requirements of the general industry rule. ...


    By Argus-Hazco

  • Case study - Monitoring the oxygen content in bio-methane-to-grid supply

    Since 1984, Orbital has provided advanced technology solutions for the natural gas industry. Orbital’s customers, including the National Grid and the UK's gas distribution networks, rely on its crucial engineering support and specialised knowledge. Its value-added services and innovative products reduce the time it takes to identify, design and begin cost-effective delivery of new ...


    By Systech Instruments Ltd

  • Monitoring the oxygen content in bio-methane-to-grid supply

    Orbital utilise the EC91 ATEX oxygen analyser from Systech Illinois to accurately monitor the oxygen content in the purified bio-methane gas prior to it being injected into the national grid gas network In September 2010, Orbital installed the gas monitoring and treatment plant on the UK’s very first large-scale bio-methane-to-grid production facility. This site was designed specifically to ...


    By Systech Instruments Ltd

  • Industrial operations facility - Tobyhanna army depot

    Client: U.S. Army Corps of Engineers   Completion Date: 1999  Services Provided Design charrette Facility planning Design of facility and processes Shop drawing review Engineering assistance during construction Project Summary This project at Tobyhanna Army ...


    By Burns & McDonnell

Need help finding the right suppliers? Try XPRT Sourcing. Let the XPRTs do the work for you