hazardous waste incineration kiln Articles

  • Incineration

    Introduction: High temperatures, 870 to 1,200 °C (1,400 to 2,200 °F), are used to volatilize and combust (in the presence of oxygen) halogenated and other refractory organics in hazardous wastes. Often auxiliary fuels are employed to initiate and sustain combustion. The destruction and removal efficiency (DRE) for properly operated incinerators exceeds the 99.99% requirement for hazardous waste ...

  • Hazardous Waste Incineration Slag Optimisation by Additives

     Abstract Rotary kiln incineration combined with the disposal of residual slag on landfills defined by German landfill regulations is the most acceptable treatment for hazardous waste with respect to the environment. The objective of research is to optimize the elution behavior of HWI-slag. Quality-improved slags may be disposed off on cheaper landfill sites still applying to the landfill ...


  • Waste Incineration Upgrades at the Eastman Chemical Company

    INTRODUCTION Eastman Chemical Company, headquartered n Kingsport, TN, is an international supplier of organc chemicals, fibers anci plastics with annual sales of approximately $46 biNion and approximately 5300 customers worldwide. Tennessee Eastman Division, also located in Kingsport, is the company’s largest manufacturing fadllity The nine hundred acre site contains manutacturing facilities as ...


  • Management of Hazardous Wastes

    ' Management of hazardous waste is a growing concern in many countries. The long-term impacts and costs of improper disposal can be very high and the emphasis must be on prevention. A comprehensive management system should include (i) policies, institutions and effective regulations and (ii) adequate and acceptable disposal facilities (either public or private). This note outlines the key ...


    By The World Bank

  • Emission Performance Results for a Liquid Waste Incinerator upgraded to meet the HWC MACT Standards

    Abstract Eastman Chemical Company operates three hazardous waste incinerators at its facility in Kingsport, Tennessee, one liquid waste incinerator and two rotary kilns. The air pollution control systems for these incinerators are being upgraded to meet the MACT standard for existing hazardous waste incinerators. The upgraded air pollution control systems include a vertical, rapid-quench ...


  • Emissions Performance Results for a Liquid Waste Incinerator Upgraded to Meet the HWC MACT Standards

    ABSTRACT Eastman Chemical Company operates three hazardous waste incinerators at its facility in Kingsport, Tennessee, oneliquid waste incinerator and two rotary kilns. The air pollution control systems for these incinerators are beingupgraded to meet the MACT standard for existing hazardous waste incinerators. The upgraded air pollution controlsystems include a vertical, ...


  • Swan Hills Treatment Centre – Canada`s only fully-integrated hazardous waste treatment facility

    Untitled Document Since the enactment of environmental laws and regulations in Canada and the United States in the 1970s and 1980s, many treatment and disposal options for hazardous ...


    By Baum Publications Ltd.

  • Study Charts a Future for Waste-Derived Fuels

    Pointers to possible future EU policy initiatives to give co-incineration facilities burning waste-derived fuels a strategic role in waste management have emerged in a study for the European Commission.1 The report suggests a policy focus on promoting source separation of municipal wastes, active discouragement of mass burn incinerators, and a levelling of the regulatory playing-field for ...

  • Defining solid waste

    Simultaneous to the publication of the final National Emission Standards for Hazardous Air Pollutants for Boilers (the Boiler NESHAP) and the Commercial and Industrial Solid Waste Incinerator (CISWI) Rules, EPA issued a new regulation that for the first time defines what materials are a non-hazardous solid waste when combusted. This rule, Solid Wastes Used as Fuels or Ingredients in Combustion ...


    By Trinity Consultants

  • A STIEFEL project UTO Uvrier case study

    The waste incineration plant UTO Uvrier is situated in the south western part of Switzerland. The Association which controls the plant was established in 1969 and treats waste from 44 municipalities with a combined population of 170,000 inhabitants. The principal task of UTO Uvrier is the thermal heat recovery from urban and industrial waste. Apart from this, UTO also treats other types of waste ...


    By Jakob Stiefel GmbH

  • Common Treatment Technologies for Halogenated SVOCs in Soil, Sediment, and Sludge

    Common treatment technologies for halogenated SVOCs in soil, sediment, and sludge include biodegradation, dehalogenation, incineration, and excavation with off-site disposal. All types of biodegradation, both in situ or ex situ, can be considered to remediate soils: in situ bioremediation, bioventing, composting, controlled solid phase, or landfarming. Slurry phase biological treatment is also ...

  • Common Treatment Technologies for Nonhalogenated SVOCs in Soil, Sediment, and Sludge

    Common treatment technologies for nonhalogenated SVOCs in soil, sediment, and sludge include biodegradation, incineration, and excavation with off-site disposal. All types of biodegradation, both in situ or ex situ, can be considered to remediate soils: in situ bioremediation, bioventing, composting, controlled solid phase, or landfarming. Slurry phase biological treatment is also applicable but ...

  • Refuse Derived Fuel, Current Practice and Perspectives

    Untitled Document Summary I OBJECTIVES The objectives of the project were to undertake a survey on the current ...

  • EPA proposes updates to CISWI rules

    On June 4, 2010, the U.S. EPA proposed updates to the Standards of Performance for New Stationary Sources (NSPS) for Commercial and Industrial Solid Waste Incineration (CISWI) Units (NSPS Subpart CCCC) and Emission Guidelines (EG) for Existing CISWI Units (EG Subpart DDDD), collectively referred to as the "CISWI Rules." In order to describe the proposed updates to the CISWI Rules, it is necessary ...


    By Trinity Consultants

  • Pyrolysis

    Introduction: Pyrolysis is formally defined as chemical decomposition induced in organic materials by heat in the absence of oxygen. In practice, it is not possible to achieve a completely oxygen-free atmosphere; actual pyrolytic systems are operated with less than stoichiometric quantities of oxygen. Because some oxygen will be present in any pyrolytic system, nominal oxidation will occur. If ...

  • Dazed and Confused: Alternative fuels and the CISWI definitions rule

    As discussed in ALL4’s December 2008 issue of 4 The Record, the use of alternative and non-traditional fuels for heat and power generation is on the rise, an increase that can be attributed to the price surge and volatility of traditional fossil fuels, as well as to a general desire to use more environmentally friendly materials to reduce greenhouse gas emissions. Alternative fuels have been ...


    By All4 Inc.

  • European Oil and Gas from Exploration to End User

    Made up of a team of senior specialists dedicated to innovation and dependability in the field of combustion technology; CS Combustion Solutions' (CS) staff use their 25 years of expertise in engineering, supplying and commissioning of vertical and horizontal combustors for a wide range of applications to find the best results for each individual requirement. "We are a company that specialises in ...

  • Flux force condensation scrubbing

    Flux force condensation scrubbing technology is used to capture fine (submicron) particulate at extremely high efficiency. It is a preferred method when using wet scrubbing to collect and control dioxins from combustion sources. As an added benefit, through the use of condensation, the water vapor plume commonly associated with a wet scrubbing system can be effectively eliminated. The overall ...


    By Bionomic Industries Inc.

  • Common Treatment Technologies for Fuels in Soil, Sediment, and Sludge

    Common treatment technologies for fuels in soil, sediment, and sludge include biodegradation, incineration, SVE, and low temperature thermal desorption. Incineration is typically used when chlorinated SVOCs are also present with fuel, and not specified for fuel-only contaminated soil, sediment, or sludge. All types of biodegradation, both in situ or ex situ, can be used to remediate soils: ...

  • Final CISWI rule

    On March 21, 2011, in parallel with publication of the Boiler National Emission Standard for Hazardous Air Pollutants (NESHAP) rules and the Non-Hazardous Secondary Material (NHSM) rule, EPA promulgated the final updates to the New Source Performance Standards (NSPS) and Emission Guidelines (EG) for Existing CISWI Units, collectively referred to as the “2011 CISWI Rules.”1 The 2011 ...


    By Trinity Consultants

Need help finding the right suppliers? Try XPRT Sourcing. Let the XPRTs do the work for you