heat recovery unit Articles

  • Heat recovery from wastewater

    Heat recovery from gray water is particularly important in water-intensive industries such as pulp and paper plants, dairies and breweries. Rather than flushing used water down the drain, consider whether a heat exchanging system can help you put that energy to work in your process again. Most plant operators arc aware of the need to save money and reduce the environmental impact of their plant ...


    By DDI Heat Exchangers Inc.

  • Case study - ABUTEC’s heat recovery unit provides multiple landfill benefits

    ABUTEC Heat Recovery Flare A Pennsylvania-based waste management site needed a solution to burn off harmful gases emitted from decaying waste in their landfill. They also wanted a way to make the most out of the waste that was being burned, so they looked to ABUTEC representatives to devise a plan for combustion. ABUTEC representatives suggested the Heat Recovery Unit to burn off the waste heat ...


    By ABUTEC LLC

  • MLM® vs. Conventional RTO Heat Recovery Media

    Random media, in addition to high pressure drop, are also associated with common operational problems when used as the heat recovery media in RTO units. These problems include settling and nesting which leads to even higher pressure drop ...


    By Lantec Products, Inc.

  • In Situ electromagnetic heating for hydrocarbon recovery and environmental remediation

    Introduction Thermal recovery methods, as applied in heavy oil and oil sand deposits, and in environmental remediation, have the common objective of accelerating the hydrocarbon recovery process. Raising the temperature of the host formation reduces the oil and bitumen viscosity, and, in environmental remediation, increases vapour pressure. These effects assist in sweeping the substances ...


    By McMillan-McGee Corp.

  • Case study - Increasing primary heat recovery

    OVERVIEW Tekra Corporation is a custom coater of plastic films in Wisconsin, where state regulations require over 98% of the Volatile Organic Compounds (VOCs) emitted from their process be destroyed in an oxidizer system. While considering their first oxidizer system, Tekra's Engineers did their homework and invested in an early model Regenerative Thermal Oxidizer (RTO). While at the ...

  • Maximum possible efficiency for energy recovery from low-grade heat sources

    Gas-to-gas heat exchangers are increasingly being used to recover low-grade heat (or cooling) to reduce energy requirements for space heating, drying and other applications. The efficiency of heat recovery is often limited by practical considerations which could – in principle – be reduced or eliminated by development of new materials and technology. However, this paper posits a fundamental ...


    By Inderscience Publishers

  • Heat recovery and energy efficiency, improves profitability and reduces CO footprint

    Using latest technology in combustion of oil and gas can provide significant savings in overall energy consumption. Modern oxygen control that compensates changes in ambient temperature and fuel qualities can increase energy efficiency up to 3%. By adding the usage of hot combustion air another 2-3% can be saved. Modern burner technology without mechanical linkage, operating with accurate ...


    By Oilon Oy

  • Cryogenic Treatment Unit (TU-51) for Recovery of VOCs for Soil Remediation

    A Cryogenic Treatment Unit or TU-51 was developed to apply a cryogenic air treatment process to recover persistent vapor phase volatile organic compounds (VPVOC) having extremely low boiling points. These would include explosive compounds present in the vapor stream. The portable TU-51VPVOC (OEM) operates the following process: vapors are recovered from geologic units via SVE, often from a ...


    By IWA Publishing

  • Case study - Maximizing heat recovery from your oxidizer and reducing operating costs

    More and more, companies operating air pollution control equipment today realize that the initial capital cost of an oxidizer system can be rapidly eclipsed by continued operating expenses if careful attention is not periodically given to the system. Below are ten tips to ensure your oxidizer is operating at peak performance. The first five tips focus on parameters end-users should know about ...

  • Cryogenic Treatment Unit (TU-51) Technology for Recovery of VOCs from Highly Contaminated Environment

    A Cryogenic Treatment Unit or TU-51 Technology was developed to apply a cryogenic air treatment process to recover persistent vapor phase volatile organic compounds (VPVOCs) having extremely low boiling points.  These would include explosive compounds present in the vapor ...


    By IWA Publishing

  • Continuous measurement of Process oxygen for Claus sulfur recovery unit (sru) start-ups and shut-downs case study

    During start-up and shut-down, any time a sulfur recovery unit (SRU) transitions from ambient temperature through fuel gas warm up to the introduction of acid gas, measurement of 02 stoichiometry is critical. Historically, operators have manually taken samples using a portable electrochemical type Os analyzer. While giving more or less satisfactory results, the requirement for more stringent ...

  • Case study - Oxidizer energy recovery options

    Overview The mainstream media today is full of allusions to energy awareness and conservation. Just as visible these days are media references to astronomical dollar figures that can boggle the mind. This article does not seek to break out of that mold, but rather to conform to it – as Oxidizer Stack Heat Recovery offers a tremendous opportunity for both energy conservation and ...

  • Application of Membrane Technology for the Recovery and Reuse of Water

    Abstract As water and sewer costs are expected to increase over the next decade, membrane technology will continue to be a viable and economical option in the recovery and reuse of water. This paper describes the mechanism of membrane effected separation (specifically reverse osmosis, ultrafiltration and microfiltration), membranes commercially available, membrane element configurations, and how ...


  • The HogMag Eddy Current Separator - Metal Recovery with Ease

    Why a HogMag? To benefit the customer and the environment the HogMag Eddy Current Separator is fitted with energy saving motors which generates a higher level of speed being achieved increaseing productivity, reducing maintenance and operation costs and improving overall up to 100% metal recovery depending on material. What is A HogMag Eddy Current Separator? ...


    By EcoHog Ltd

  • Ashford STC Expansion, United Kingdom

    Southern Water 10.5 tons dry solid per year (TDS/yr) The Client Southern Water provides water supply and sewerage services in the counties of Kent, East and West Sussex, Hampshire and the Isle of Wight, and small parts of Wiltshire, Berkshire and Surrey. The Client's Needs The purpose of the works was to ...


  • Case study - Waste heat generates steam and savings

    OVERVIEW A coil coating facility purchased a new a 15,000 SCFM Regenerative Thermal Oxidizer (RTO) which had a nominal heat transfer efficiency rate of 90% thermal energy recovery. It was designed with supplemental fuel injection (SFI) which is used during low VOC loading conditions, to help save fuel cost.  The facility was looking for additional ways to decrease their exhaust ...

  • Qualifying Combined Heat and Power (CHP) activity

    The EU 2002 draft and 2004 final CHP Directives propose qualifying CHP activity with the quality norm. This norm benchmarks the energy efficiency of CHP plant outputs on external reference power and heat efficiencies. Because the quality norm amalgamates cogeneration and condensing activity its application entails particular perverse effects for high-quality and adapted scale investment in CHP ...


    By Inderscience Publishers

  • Improving and maintaining the performance of your Heat Exchanger or Condenser.

    The usage of Heat Exchangers or Condensers is common in many processes across a wide range of industries. The Energy sector is no different, either in the Thermal Power Generation, Upstream and Downstream of the Oil and Gas including Petrochemical and Chemical plants; Heat Exchangers are used to cool of the steam or to pre-heat different liquid needed in the processes. The recurrent problem of ...

  • Mercury recovery from industrial waste and toxic residues of natural gas drilling

    econ's client in the east of Germany is one of the few specialised companies in Europe for the treatment of mercury contaminated waste. Typical input material for this type of treatment is sludge from the natural gas industry or other residues from chemical processes, i.e. contaminated filter cake from waste water treat-ment. Among their most important clients are Shell, ExxonMobil, Wintershall ...


    By econ industries GmbH

  • Drilling oil recovery from drill cuttings case study

    By econ industries VacuDry indirect heated thermal desorption Drill cuttings are an increasing waste stream worldwide, econ industries addressed the challenge by developing a process that cleans the waste and at the same time recovers valuable drilling oil. The VacuDry plant started the successful processing of drill cuttings in autumn 2013. Our client, a medium-sized recycling company, was new ...


    By econ industries GmbH

Need help finding the right suppliers? Try XPRT Sourcing. Let the XPRTs do the work for you