heated hydrocarbons analyser Articles

  • PetroSense hydrocarbon sensors and their applications

    The increasing concern about hydrocarbon contamination of process water and produced water has created an increasing need for in-situ, real time, and accurate low cost instrumentation that can provide rapid detection and easily usable in the field. PetroSense sensors [1,2] represents “best in breed” technology for the detection of total petroleum hydrocarbons (TPH). PetroSense sensors ...


    By PetroSense, Inc

  • Petrol and heating oil bioremediation using EU70 (case study)

    As a result of an accident a tanker lost its load of petrol and heating fuel. A large quantity of fuel approximately 2000 litres soaked into the soil. Analyses revealed that the average level of hydrocarbons present was in the order of 0.55 %. The pollution affected an area of 100 m2 and to a depth of 0.6 m. Our goal was to reduce hydrocarbon levels to the lowest possible value in order to ...


    By Bio Systems Europe

  • The Portable FID for Stack Emissions: lightweight, compact, ergonomic, safe

    POLLUTION S.r.l. manufactures POLARIS FID analyser, a cutting-edge technology for the measurement of total hydrocarbons in ambient air and stack emission monitoring in accordance with EN 13526 and EN 12619. This analyser is based on Flame Ionization Detection (FID), a reference method technique to measure total hydrocarbons (THC, VOC, TOC). Polaris FID is a very handy instrument because it allows ...


    By Pollution Srl

  • Stack gas VOC monitoring

    POLLUTION S.r.l. manufactures POLARIS FID analyzer, a cutting-edge technology for the measurement of total hydrocarbons in ambient air and stack emission monitoring in accordance with EN 13526 and EN 12619. This analyser is based on Flame Ionization Detection (FID), a reference method technique to measure total hydrocarbons (THC, VOC, TOC). Polaris FID is a very handy instrument because it allows ...


    By Pollution Srl

  • Plastic Housewraps (Air Barriers) a Life Cycle Analysis of Their Environmental Benefits

    The use of air barriers in the construction of residential housing in North America has increased markedly during the last decade. The most commonly used air barriers have been particular plastic materials applied to the exterior of a home behind the finishing of brick or siding. The paper analyses, using life cycle techniques, the conservation of energy resulting from the use of these barriers ...


  • Combustion, performance and emission analysis of diesel engine fuelled with methyl esters of Pongamia oil

    The methyl esters of vegetable oils, known as biodiesel are increasingly becoming popular because of their low environmental impact and potential as a green alternative fuel for diesel engine, and that they would not require significant modification of existing engine hardware. Methyl ester of Pongamia oil (PME) is derived through transesterification process. Experimental investigations have been ...


    By Inderscience Publishers

  • Composition and Contaminant Loads of Residual Household Waste Part III: Physico-Chemical Properties and Contaminant Concentrations

    Abstract. Physico-chemical properties of residual waste are key factors for disposal standards. Reliable input data for treatment plants (MSWI) need to consider the heterogeneity and variability of waste composition. This requires thoroughly designed sampling schemes, a consistent separation of bulk waste into uniform fractions, and adequate methods for sample preparation and analysis. The ...


    By Oracle Crystal Ball GBU

  • Methanol blending is alternative fuel of the future

    The main objective of “alcohol fuel power” field is increase of fuel resources for transport by using right alternative  such as ethanol and methanol blending with gasoline, which unlike pure oil fuel, are characterized renewable and have unlimited sources of raw materials. Margin of oil (valuable hydrocarbonic raw materials for petrochemical productions) and also a power ...


    By GlobeCore Blending

  • Generation using gas-fuelled engines in South Africa – an overview

    Most gas engines are Otto cycle spark ignition internal combustion reciprocating engines using natural gas as the primary fuel. Smaller models utilise stochiometric combustion while the larger engines are lean burn engines with pre-chamber ignition systems. The engines are coupled with packaged generator sets, ...


    By Clarke Energy

  • Large Volume Splitless Injection Using an Unmodified Split/Splitless Inlet and GC-TOFMS for Pesticides and Brominated Flame Retardants

    Abstract Large volume splitless injection for gas chromatography typically requires a special injection port, for example, a programmable temperature vaporizer (PTV), but an alternative setup using concurrent solvent recondensation–large volume splitless injection (CSR-LVSI) and a split/splitless injection port has been reported. This technique was used here, both with and without ...


    By Restek Corporation

  • Hydro Polymers: Searching for a More Sustainable PVC

    Over the last five years, the European PVC industry has been forced to reassess the environmental impact of its products in the face of continuing pressure from environmental groups, governments and end users. Hydro Polymers, one of two PVC manufacturers in the UK, is forging ahead of its competitors through a partnership with sustainability consultancy The Natural Step. The company is launching ...

  • How Can TO-15 Help You Solve Your Next IAQ Problem?

    Untitled Document Have you ever been asked to investigate unpleasant odors in a home or at the workplace? Are occupants developing headaches or a feeling of nausea? ...


    By EMSL Analytical, Inc.

  • Assessment of the Environmental Impact of Military Activities During the Yugoslavia Conflict

    1. Executive Summary Assessment Method:The study was carried out over a period of ten days by a team of expert staff from the Regional Environment Center for Central and Eastern Europe (REC) and other contracted country experts. A framework was prepared by REC headquarters and the REC's country offices in the five selected countries gathered information and data. Additional ...

  • Performance of the low-emission flare

    Job report / Elbisgraben (Bale / Switzerland) The summer of 1992 had finally arrived. The 5MW low emission furnace in the district heating station Liestal was ignited, supplied with landfill gas from Elbisgraben landfill. Since then the plant has been running continuously and the comprehensive measurements taken, verify that all targets aimed at have been achieved: plant ...


    By Hofstetter BV

  • Why high temperature combustion of landfill gas?

    Due to the accumulation of knowledge and the tightening of environmental law, the landfill technology has increasingly become concerned with the management of trace compounds in landfill gas. With landfill gas, contamination is through sulphur, chlorine, fluorine, halogenated hydrocarbons and heavy metals. Other trace elements such as volatile organic compounds (VOC), impose environmental ...


    By Hofstetter BV

Need help finding the right suppliers? Try XPRT Sourcing. Let the XPRTs do the work for you