High Purity Water Articles on Environmental XPRT

Add polish to high purity water

Electrodeionization (EDI) has recently gained widespread acceptance by water treatment companies and end users alike for almost all applications requiring high-purity water. EDI has proven to be a reliable, cost-effective solution for both end users and water treatment companies. End users purchasing capital equipment can eliminate on-site chemical regeneration. Water treatment companies selling ...

Jul. 1, 2010

By Agape Water Solutions, Inc.

Crossflow Membrane Filtration High-Purity Water Systems

INTRODUCTION As the electronics industry continues to provide us with such products as high resolution television, notebook size portable computers and cars with automatic navigation systems, it becomes necessary to produce semiconductors with finer device geometries to allow for efficient placement of more circuits per a given area. This requires increased control of a semiconductor's material ...

Apr. 1, 1991

By GE Water & Process Technologies

High-Purity Water from Wastewater…A “Rare” Opportunity

A cooperative water recycling effort between a major U.S. water/wastewater utility and a large oil refinery will provide significant benefits for both parties and will serve as a blueprint for future cooperative efforts between public agencies and industries.The East Bay Municipal Utility District (EBMUD), located in the eastern portion of the San Francisco Bay Area, is implementing the Richmond ...

Oct. 21, 2006

By Water Environment Federation (WEF)

High purity boiler make-up water for esso thailand

The Facility The Esso refinery is located in Sriracha, Thailand approximately 50 miles south of Bangkok. Due to increased refinery demands, Esso embarked on a facility expansion to more than double the refinery’s production capacity. The Problem The expansion plan required additional high purity water to be used for boiler make-up. With the existing ...

Sep. 14, 2010

By Aquatech International Corporation

Combined ultrafiltration-electrodeionization technique for production of high purity water

Electrodeionization (EDI) is the most common method to produce high purity water used for boiler feed water, microelectronic, and pharmaceutical industries. Commonly, EDI is combined with reverse osmosis (RO) to meet the requirement of EDI feed water, with hardness less than 1 ppm. However, RO requires a relatively high operating pressure and ultrafiltration (UF) as pretreatment which results ...

Mar. 22, 2017

By IWA Publishing

Conductivity Measurement in high purity water samples below 10 microsiems/cm

High Purity Water Resistivity/ Conductivity Measurement Ultra-Pure Water without any chemical impurities will still have a conductivity because of the presence of H* and OH" ions due to the self-ionization of water. Ultra-pure water has a conductivity of 0.055 HSiemens'cm or a resistivity of 18.18 mQ-cm at 25 °C. In order to know the conductivity or resistivity of ultra-pure water it is ...

Jan. 1, 2012

By IC Controls Ltd.

Membrane and System Design Considerations in Producing High Purity Water

The use of membrane technology to produce water of greater and greater purity is rapidly evolving under the pressure of new product quality specifications, including those of the pharmaceutical and beverage industries. Membrane technology is well suited to achieving multi-component water specifications, given the fundamental nature of the separation process. Meeting a resistivity or conductivity ...

Jan. 1, 2000

By GE Water & Process Technologies

High Purity Boiler Water Production Using Municipal Wastewater at a Combined Cycle Gas-Fired Generating Station

The recovery of wastewater for industrial uses presents many challenges for the design and operation of water treatment equipment. Since the term wastewater can be applied to a wide range of water sources from municipal sewage to storm runoff to industrial discharge water, the water characteristics may have great variability. As such, the equipment to treat wastewater must be robust and ...

Apr. 17, 2013

By Eco-Tec Inc.

MSF plants provide over 46 years of reliable high purity water production

The Facility Southern Peru Copper Company’s (SPCC) facility located in Ilo, Peru requires high purity water for boiler make-up at the smelter power plant. Process water for various smelter and mining operations and potable water for the town and Port of Ilo is also needed. SPCC’s first Aqua-Chem ICD long tube multistage flash (MSF) seawater desalination plant producing ...

Sep. 14, 2010

By Aquatech International Corporation

Microelectronics - Lessons learned: the installation of a 300 to 600 GPM Semiconductor High Purity Water System

The life of a high-purity water treatment project may be compared to roll-ing a boulder down a dome-shaped hill (1). The project gets rolling with a fairly small nudge. Once it is rolling, however, it takes a great deal of effort (time and money) to change the direction or go back up the hill. The project to design, build, install, and commission the "E" high-purity water system at VLSI ...

Jan. 1, 1999

By Advanced Water Treatment Technologies Services (AWTS) Inc.

High Purity Boiler Water Production Using Municipal Wastewater at a Combined Cycle Gas-Fired Generating Station

Abstract The recovery of wastewater for industrial uses presents many challenges for the design and operation of water treatment equipment. Since the term wastewater can be applied to a wide range of water sources from municipal sewage to storm runoff to industrial discharge water, the water characteristics may have great variability. As such, the equipment to treat wastewater must be robust ...

Mar. 24, 2014

By Eco-Tec Inc.

Producing High-Purity Recycled Water for Industrial Applications with Microfiltration and Reverse Osmosis: Lessons Learned

ABSTRACTThe East Bay Municipal Utility District (District), with the assistance of Black & Veatch, studied the feasibility of treating secondary and tertiary effluents using microfiltration (MF) followed by reverse osmosis (RO) to produce high-purity, recycled water for use as boiler make-up water at a local refinery. A pilot-scale test program was developed to demonstrate the ability of the ...

Oct. 22, 2006

By Water Environment Federation (WEF)

Lessons Learned: The Installation of a 300 to 600 gpm Semiconductor High-Purity Water System

The life of a high-purity water treatment project may be compared to roli¡ng a boulder down a dome-shaped hill (1). The project gets rolling with a fairly small nudge. Once ¡t ¡s rolling, however, ¡t takes a great deal of effort (time and money) to change the direction or go back up the hill. The projectto design, build, instali, and commission the “E” high-purity ...

Sep. 1, 1999

High purify water systems for utility use

Companies in the utility business have a need for high purity water for their operations such as in diesel generator cooling systems and in turbine generator makeup water. Often, utilities can not depend on the city water as the quality is not pure enough and purchasing local water may be expensive. To gain operational and economic advantages, water purification equipment can be added. These ...

Jan. 6, 2009

By LIFESTREAM Watersystems Inc.

A new method estimates TEG purity versus reconcentrator temperature at different levels of pressure in gas dehydration systems

There are several processes and principles for obtaining high triethylene glycol (TEG) purity in gas dehydration process. All methods are based on the principle of reducing the effective partial pressure of water in the vapour space of the glycol reboiler, and hence obtaining a higher glycol concentration at the same temperature. One of the most common methods for enhancement of the glycol ...

Dec. 2, 2013

By Inderscience Publishers

A high-performance electropositive filter

Reverse osmosis (RO) membranes have become the industry standard for purification of any feed water source. They are used extensively for producing high-purity, low-conductivity process water. They are also used for producing ultrapure water from fresh water because RO is presumed to be the ultimate purifier. Because RO filters are readily fouled by colloidal particles and biofilms, some method ...

Jun. 1, 2006

By Argonide Corporation

Case study - High reactivity Metakaolin utilized in high performance Virginia bridge

The Virginia Department of Transportation and Marshall Concrete Products have included Headwaters Resources’ HRM modified concrete as one of the high performance concrete mixes for the Virginia DOT “Smart Road” research project. Unlike most research that investigates one item on a limited scale in a laboratory, the Smart Road is a $35 million combined construction and research ...

Mar. 19, 2015

By Headwaters, Inc.

Evolved gas analysis - a high sensitivity study of a solvent of recrystallisation in a pharmaceutical

Introduction Thermogravimetric Analysis (TGA) of materials is commonly used to provide information on the weight loss as a sample is heated or held isothermally. Pharmaceutical materials often show weight losses associated with the loss of solvent/ water, desolvation or decomposition of the sample. This information is then used to assess the purity and stability of the material and its ...

Mar. 12, 2012

By Hiden Analytical Ltd.

Water Sustainability

I7.1 | Water Optimization – 30% Groundwater Use Reduction Tabatha Pellerin, Senior Program Manager, AECOM AECOM assisted the Entergy Lewis Creek gas/coal fired electric power plant with water conservation efforts prompted by a goal of 30% ...

Nov. 6, 2011

By Energy, Utility & Environment Conference (EUEC)

UltraPure water: systems for microelectronics

The burgeoning electronics industry Electronics are the heartbeat of the products and services of many industries – including aerospace, communications, entertainment, defence, and health – and, as a consequence, the global electronics market is valued at US$1 trillion worldwide. ...

Jun. 1, 2006

Subscribe to our eBulletins

Add Supplier Profile