hydraulic power plant location Articles

  • Case Study - 6MW Non-Condensing Power Plant

    Lihir Island, Papua New Guinea – 2003 First Geothermal Power Station in PNG: Press Release, April 16, 2003 Lihir Gold Limited “Gold company Lihir Gold Limited is turning its vast geothermal resource into an opportunity. In April, the company started commissioning a 6MW geothermal power station, the first in Papua New Guinea to use natural geothermal ...

  • Largest power plant in philippines uses membrane desalination for purified WA

    The Facility Ilijan Plant, developed by KEILCO-KEPCO Ilijan Corporation, is located in the Island of Luzon, about 100 miles south of Manila, Philippines. It is a combined cycle power plant and at 1,200 MW generating capacity, is the largest power plant in the Philippines. The plant consists of two power blocks, which share a common membrane based Seawater Desalination system for ...

  • Solving waste oil management and removal problems in power generating plants

    If your plant is like most, it is doing a good job of preventing oily water waste and waste oils from escaping into the environment. But at what cost? As labor resources dwindle, operating and maintaining drainage systems, oil separators, and sometimes inadequate oil removal equipment is expensive. Paying higher than needed costs for waste oil disposal, filtration and water treatment due to these ...


    By Oil Skimmers, Inc.

  • Cost effective boiler makeup system using membrane desalination for power plant in dominican republic

    The Facility Andres Power Plant, developed by Caribbean Thermal Electric LLC, is located in Boca Chica, near Santo Domingo, Dominican Republic. It is a 300 MW gas fired combined cycle power plant and is one of the largest IPP power plants in the Dominican Republic and will supply electricity to Corporacion Dominicana de Electricidad. The plant consists of two power blocks, which ...

  • Combined cycle power plant in southern india uses membrane desalination for boiler feed

    The Facility PPN, a 330 MW combined cycle power plant developed by PPN Power Generating Company, is located in Pillaiperumalnallur about 320 kilometers south of Chennai, India. It is one of the largest IPP power plants developed by an international consortium in India under a 30 year PPA with the state electricity board. The plant consists of a single dual fuel power block and ...

  • Optimizing Water Management in Hydraulic Fracturing for Shale Oil and Gas Production

    Centralized treatment of wastewater is emerging as a viable solution for long-term efficiency in managing water sourcing and wastewater treatment in hydraulic fracturing. The number of hydraulic fracturing (fracking) shale oil and gas wells in the United States continues to increase. Within the Bakken Shale formation alone, in North Dakota and Montana, upwards of 15,000 hydraulic fracturing ...


    By WesTech Engineering, Inc.

  • Optimizing water management in hydraulic fracturing for shale oil and gas production

    Centralized treatment of wastewater is emerging as a viable solution for long-term efficiency in managing water sourcing and wastewater treatment in hydraulic fracturing. The number of hydraulic fracturing (fracking) shale oil and gas wells in the United States continues to increase. Within the Bakken Shale formation alone, in North Dakota and Montana, upwards of 15,000 hydraulic fracturing ...


    By WesTech Engineering, Inc.

  • Polish CEMEX cement plant relies on WEIMA - Case Study

    In the eastern Polish town of Chelm, not far from the Ukrainian border, the waste recycling company EkoPaliwa recently successfully commissioned their new plant for the production of alternative fuels. Two WEIMA PowerLine 3000 single-shaft shredders with a powerful hydraulic drive used in secondary shredding absolutely take center stage here. The main buyer of the produced Refuse Derived Fuel ...


    By WEIMA

  • Upgrading an existing wastewater treatment plant based on an upflow anaerobic packed-bed reactor

    Upgrading a wastewater treatment plant (WWTP) may be necessary to meet the existing effluent quality and/or to meet the stricter future effluent quality requirements and/or to increase its capacity because of population growth or sewerage expansion to serve more areas. Inability to meet the existing effluent quality may result from lack of proper plant operation and maintenance, inadequate plant ...


    By University of Tehran

  • Upgrading an existing wastewater treatment plant based on an upflow anaerobic packed-bed reactor

    Upgrading a wastewater treatment plant (WWTP) may be necessary to meet the existing effluent quality and/or to meet the stricter future effluent quality requirements and/or to increase its capacity because of population growth or sewerage expansion to serve more areas. Inability to meet the existing effluent quality may result from lack of proper plant operation and maintenance, inadequate plant ...


    By University of Tehran

  • Remote controlled `Pit Hog™` dredge removing sludge from aeration lagoons at Los Alisos, California, Waste Water Treatment Plant

    The Los Alisos Water District Water Reclamation Plant is removing raw sewage solids, decayed algae and microorganisms, and algae-laden sludge from its aeration lagoons using a Liquid Waste Technology (LWT) remote controlled lagoon dredging system. The tertiary wastewater treatment plant treats four million gallons per day. Officials of the Lake Forest, California facility initiated the buildup ...

  • Case study - pumping inerts

    Location: Spain Year: 2009 Working Context description In northern Spain the high speed railway system is developing fast. Due to the conformation of the ground the project involves the construction of bridges and tunnels. Material extracted during tunnel excavation is recovered in treatment plant to be further processed. ...


    By Dragflow North America

  • Case Study - Pumping inerts

    Location: Spain Year: 2009 Working Context description In northern Spain the high speed railway system is developing fast. Due to the conformation of the ground the project involves the construction of bridges and tunnels. Material extracted during tunnel excavation is recovered in treatment plant to be further processed. The ...


    By Dragflow S.r.l.

  • Utilizing unconventional water sources for industrial reuse

    Reclamation and reuse of unconventional wastewater sources for plant raw water, cooling water and process pre-treatment has increased substantially due to increases in the cost of drinking water, recurring water shortages that can impact business operations, and tightening government regulation. Water is required in almost every industrial sector for the processing and manufacture of products. ...


    By WesTech Engineering, Inc.

  • Oil and water don`t mix

    Small spots of motor oil on your driveway look tacky enough. Leaks of hydraulic oil from the hydro turbine of a big pumped-storage plant are not only more noticeable, but they also could end up in the facility's sump or in its reservoir, as well. At the Blenheim-Gilboa Pumped Storage Power Project in New York's Catskill Mountains, there's another reason leaks are unacceptable. The New York Power ...


    By Abanaki Corporation

  • 4 Key Design Criteria for Jet Mixers

    Jet mixers are widely used in both municipal and industrial wastewater treatment facilities to blend the plant influent and suspend light organic solids in circular equalization tanks.  Other applications for these powerful hydraulic mixers include mixing anoxic tanks and anaerobic reactors with the latter application being for industrial waste streams only. Jet ...


    By KLa Systems, Inc.

  • ENEL launches a new LWT automated PLC controlled dredge in Guatemala

    Enel Latin America asked Liquid Waste Technology, LLC to design a LWT Pit Hog dredge equipped to excavate the main pond’s sediment from the Santa Maria River automatically. Enel Latin America needed a solution for removal of sediment accumulating in the power generation water supply at its Greenfield El Canada Power Plant in western Guatemala at Zunil. Enel Latin America asked Liquid Waste ...

  • Ten top growth markets in air, water and energy

    For suppliers of products and services for the air, water, and energy industries there are some substantial double-digit growth opportunities. Ten of these have been identified as the most promising by the McIlvaine Company These are ranked based on potential market size. #1 Shale Gas There is a very large continuing investment in extraction of gas from shale in the U.S. The ...


    By The McIlvaine Company

  • Higher pumping efficiencies for medium-duty applications

    Climbing power prices, particularly for new mine sites in remote locations, have sparked an increasing global demand for power savings solutions in the mineral processing industry. Over the years, plants have been using heavy-duty slurry pumps in applications where they are more powerful than needed. Because no plant should pay out increased energy costs for under-used pumps in medium-duty ...


    By FLSmidth KREBS

  • Hydroflo diaphragm pumps help reduce boiler corrosion and maintenance costs

    ABTCo, located in Alpena, Michigan, is a decorative wood paneling producer using three boilers to generate 7 MW of electricity – half the power needed in the plant plus steam for pulp processing. As in many boiler operations, the main enemy is corrosion, which can destroy system components and lead to boiler failure. Although internal boiler surfaces are protected by a film of magnetic ...

Need help finding the right suppliers? Try XPRT Sourcing. Let the XPRTs do the work for you