hydraulic power turbine seal Articles

  • Solving waste oil management and removal problems in power generating plants

    If your plant is like most, it is doing a good job of preventing oily water waste and waste oils from escaping into the environment. But at what cost? As labor resources dwindle, operating and maintaining drainage systems, oil separators, and sometimes inadequate oil removal equipment is expensive. Paying higher than needed costs for waste oil disposal, filtration and water treatment due to these ...

    By Oil Skimmers, Inc.

  • Field Performance Testing for Pipeline Pumps

    Significant energy savings can be achieved by optimizing pump operating efficiency. Measuring the exact pump performance with crude oil under realistic conditions in the field is the first step towards improving the pump efficiency in the future. About 20 billion barrels of crude oil were transported through pipelines in 2015. Around the world, there are over one million kilometers of ...

    By Sulzer Management Ltd

  • No Place Is Too Far

    The remote location of hydropower stations is often a great challenge when major repair work is necessary. The refurbishment of a large generator in the Scottish Highlands shows how Sulzer finds cost-effective service solutions even in places miles from nowhere. Much of the UK hydroelectric capacity was built during the 1950s. These installations have performed extremely well, especially ...

    By Sulzer Management Ltd

  • Los Angeles County WRRF Embraces Codigestion

    Technology to produce food waste slurry key to project implementation - and helps generators comply with California organics recycling mandates. The Sanitation Districts’ JWPCP in Carson (CA) treats an average of 280 million gallons/day of wastewater. One of the two anaerobic digestion tanks above has been used for codigestion, with the second serving as the control. Photos ...

    By BioCycle Magazine

  • Overview of Rotating Disc Electrode (RDE) Optical Emission Spectroscopy for In-Service Oil Analysis

    Introduction The basis of modern oil analysis is the use of optical emission spectroscopy (OES) to measure the ppm (parts per million) levels of wear metals, contaminants and additives in oil samples. Whatever else an oil lab may measure, a multi-elemental analysis is the core of in-service oil analysis. This paper gives an overview of Rotating Disc Electrode Elemental Spectroscopy and its ...

    By Spectro Scientific

Need help finding the right suppliers? Try XPRT Sourcing. Let the XPRTs do the work for you