hydrogen gas analyser Articles

  • Energy and exergy analyses of a steam reforming process for hydrogen production

    Hydrocarbon steam reforming is an important process for hydrogen production. In petroleum refineries, steam reforming is most commonly used for hydrogen production from naphtha and light hydrocarbon gases (methane, ethane and propane). Since the hydrocarbon steam reforming system is one of the highest energy intensive systems in a petroleum refinery it should be directed to a more efficient use ...


    By Inderscience Publishers

  • Technical and economic analyses of a hydrogen-fed gas turbine with steam injection and co-generation

    Enel has been working on a hydrogen programme dealing with both hydrogen production and uses. The first phase deals with a hydrogen-fed, gas turbine-based co-generative cycle, in which steam injection in the gas turbine itself is adopted in order to couple high process efficiencies with very low nitrous oxide emissions. This paper presents the main results of the co-generative cycle thermodynamic ...


    By Inderscience Publishers

  • An Evaluation of Hydrogen as a Carrier Gas in Gas Chromatography: FREE Whitepaper

    Anthias Consulting has collaboratively written an application note on the use of hydrogen as a carrier gasfor the analysis and detection of pesticides in drinking water. The paper evaluates the use of an on-site generated hydrogen carrier gas vs. helium as the carrier gas for USEPA Method 551.1, which analyses the concentration of pesticides in drinking water by liquid-liquid ...


    By Anthias Consulting Ltd.

  • Static gas analyser at United Utilities case study

    About the customer United Utilities, Lancaster, England Equipment GA3000 Location United Kingdom Customer United Utilities Requirement The customer required its own precise, detailed and accurate recording of the concentrations of methane (CH4), carbon ...


    By Geotech

  • Danger and Detection of Hydrogen Sulphide Gas in Oil and Gas Exploration and Production

    A rig worker smells rotten eggs near the well head, rubs his itchy eyes as he investigates the frosty pipe connections. After a few moments, he believes all is fine as he no longer smells the tell-tale hydrogen sulphide odour. In this scenario, we can only hope the worker recognises the danger and quickly leaves the site. Oil fields, especially mature ones, can produce hydrogen sulphide gas ...

  • The technoeconomic assessment of the hydrogen fuel chain

    Options for hydrogen fuel chain are compared with the existing petroleum-based fuel chain for transportation. The criteria used are the life cycle cost (Rs/km), Greenhouse Gas (GHG) emissions (g/km) and Nonrenewable Energy (NRE) consumption (MJ/km). Four hydrogen production methods, one hydrogen transport method, three hydrogen storage methods and two on-board energy conversion methods are ...


    By Inderscience Publishers

  • Silent sentinel role for static gas analyser at United Utilities

    Biogas produced by the United Utilities anaerobic digestion sludge plant at Lancaster (Stodday) waste water-treatment runs a brand new 525kW combined heat and power (CHP) engine generating electricity and now operating 24/7. It joins an existing 325kW engine already in service for three years. In addition to biogas from the Stodday mesophilic anaerobic digester, a new enzymic hydrolyser increases ...


    By Geotech

  • Safety assessment for the deficient operation data in the gas-cooled nuclear power plants for hydrogen production

    The probabilistic safety assessment (PSA) is investigated in the case of the operational data shortage which is characteristic of the passive system in gas-cooled nuclear power plants (NPPs). Therefore, it is difficult to make a quantification of the PSA. One of the solutions is to compare the passive system and the active system. Using this comparison, one can find the priority of the passive ...


    By Inderscience Publishers

  • Case study - Geotech’s first GA5000 landfill gas analyser takes 100,000 readings for SUEZ environnement

    Geotech’s first GA5000 analyser, manufactured three years ago, was recently spotted in the company’s calibration rig.  This portable landfill gas monitor was the first production unit of the newly launched GA5000 gas analyser range and has prompted Geotech to look into the analyser’s life since then. The analyser was on its sixth service since manufacture, under ...


    By Geotech

  • Membrane development for applications in hydrogen production using the sulphur-iodine thermochemical route

    Careful optimisation of a safe and sustainable route for hydrogen production is a pressing need. Thermochemical processes employing water as raw material and nuclear/renewable energies as energy source are believed to be the best possible option in this direction, while alarming issues such as climate change and global warming are being taken into account. Amongst the well-identified cycles, the ...


    By Inderscience Publishers

  • Performance assessment of an integrated absorption cooling–hydrogen liquefaction system using geothermal energy

    An integrated geothermal based triple effect absorption cooling and Linde–Hampson system for hydrogen gas liquefaction is proposed and analysed thermodynamically. The effect of various operating conditions and parameters on the system performance is studied. The results show that the mass of hydrogen gas pre–cooled by the absorption system per unit mass flow rate of geothermal water flowing ...


    By Inderscience Publishers

  • A new Rankine cycle for hydrogen-fired power generation plants and its exergetic efficiency

    A novel power generation cycle is proposed in this paper taking hydrogen as fuel and using steam generated by hydrogen firing as working fluid. The progress of the development work and side issues such as the application of hydrogen combustion turbines to environmentally clean fossil fuel power plants for early commercialisation of the system are reviewed. We propose the hydrogen-fired Rankine ...


    By Inderscience Publishers

  • Stack gas VOC monitoring

    POLLUTION S.r.l. manufactures POLARIS FID analyzer, a cutting-edge technology for the measurement of total hydrocarbons in ambient air and stack emission monitoring in accordance with EN 13526 and EN 12619. This analyser is based on Flame Ionization Detection (FID), a reference method technique to measure total hydrocarbons (THC, VOC, TOC). Polaris FID is a very handy instrument because it allows ...


    By Pollution Srl

  • Analyses of Permanent Gases, Light Hydrocarbons, and Light Polar Compounds, Using Packed Column GC

    GC columns containing Carboxen-1000 packing separate mixtures of permanent gases (nitrogen, hydrogen, oxygen/argon, carbon monoxide, carbon dioxide) and C1-C3 light hydrocarbons (methane, acetylene, ethylene, ethane, propyne, propylene, and propane). A 15’ x 1/8” column will separate the permanent gases and C1 and C2 hydrocarbons in less than 25 minutes. A 2’ x 1/8” column ...


    By Sigma-Aldrich Co., LLC

  • Determination of TOC in stack through the innovative FID analyser easy to carry - Case Study

    PROBLEM: The industrial chimney's emissions of Volatile Organic Compounds (VOCs) are becoming issues of global importance and to have an accurate knowledge about how to test VOC turns into a strategic issue. VOC emissions are quantified and monitored according to standard EN 12619, using FID analyzer which uses hydrogen and other reference gases in ...


    By Pollution Srl

  • Case study - Monitoring landfill gas

    Infrared absorption Infrared absorption is usually the preferred method for measuring methane and carbon dioxide. Most gases absorb radiation in the infrared region. The wavelength of radiation that is absorbed is determined by the natural vibration frequencies of the molecule. These natural frequencies will depend on several factors. Thus different gas molecules have different natural ...


    By Geotech

  • Analysis of Natural Gas Products by GC / TCD / FID

    The complex mixture of condensible hydrocarbons and permanent gases in a natural gas product has historically been separated on gas chromatographs equipped with dual columns and a switching valve. The light gases are separated from heavier compounds on a molecular sieve column, which is then backflushed onto a suitable column to separating the rest of the mixture. The Buck Scientific Model 910 ...


    By Buck Scientific Inc

  • Fixed Versus Portable Gas Detection – Which Is Better?

    Did you know that workers are needlessly injured every year as a result of leaking toxic or combustible substances? Such incidents are known to involve a wide range of hazardous gases (including ammonia, carbon monoxide, chlorine, hydrogen sulfide, hydrocarbon vapors and so on). The sad reality is that most of these accidents are avoidable if only the workplace is adequately monitored. This leads ...

  • Gas cell selection for analysis of electronic gases

    APIMS and FTIR remain the preferred analytical tools for monitoring impurities in the electronic  specialty gases used by the semiconductor industry, although other tools such as CRDS are currently finding application in selected cases. FTIR spectroscopy offers the advantage of the simultaneous measurement of all gaseous species that exhibit dipole moment changes during vibrations at ...


    By CIC Photonics, Inc.

  • Generation using gas-fuelled engines in South Africa – an overview

    Most gas engines are Otto cycle spark ignition internal combustion reciprocating engines using natural gas as the primary fuel. Smaller models utilise stochiometric combustion while the larger engines are lean burn engines with pre-chamber ignition systems. The engines are coupled with packaged generator sets, ...


    By Clarke Energy

Need help finding the right suppliers? Try XPRT Sourcing. Let the XPRTs do the work for you