hydrogen trace analysis Articles

  • Two Detector Solution to Analyzing Sulfur

    Sulfur compounds are reactive, corrosive to pipes, and destructive to catalysts in petroleum refineries. Sulfur emission are strictly regulated globally. When released into the atmosphere sulfur dioxide converts to sulfuric acid resulting in adverse effects on human health and the environment. Sulfur detection is found useful in many other industries; therefore, detection of sulfur compounds in ...


    By Restek Corporation

  • Analyzing for Trace CO and CO2 using a Total Hydrocarbon Analyzer

    Untitled Document The purity of Specialty Gases is determined by the measurement of various contaminants including Total Hydrocarbons. Low level measurements of carbon ...


    By MOCON, Inc. - Baseline

  • Biological regeneration of ferric (Fe3+) solution during desulphurisation of gaseous streams: effect of nutrients and support material

    This paper evaluates the biological regeneration of ferric Fe3+ solution during desulphurisation of gaseous streams. Hydrogen sulphide (H2S) is absorbed into aqueous ferric sulphate solution and oxidised to elemental sulphur, while ferric ions Fe3+ are reduced to ferrous ions Fe2+. During the industrial regeneration of Fe3+, ...


    By IWA Publishing

  • Case study - Monitoring landfill gas

    Infrared absorption Infrared absorption is usually the preferred method for measuring methane and carbon dioxide. Most gases absorb radiation in the infrared region. The wavelength of radiation that is absorbed is determined by the natural vibration frequencies of the molecule. These natural frequencies will depend on several factors. Thus different gas molecules have different natural ...


    By Geotech

  • Sequential Extraction Procedure

    Sequential extraction is an analytical process that chemically leaches metals out of soil, sediment and sludge samples. The purpose of sequential “selective” extraction is to mimic the release of the selective metals into solution under various environmental conditions. One commonly used sequential extraction procedure is designed to partition different trace metals based on their ...


  • Case study - Biogen Greenfinch Westwood

    Non-stop clean power generation uses smart machines and state-of-the-art technology to help keep running. Keep it simple - and to keep it profitable, keep CHP engines running. That's just part of the formula for success at the BiogenGreenfinch-designed and run Westwood anaerobic digestion (AD) plant in Northamptonshire. Built and funded by parent company Bedfordia Group plc this £10 ...


    By Geotech

  • Enhanced Bioremediation

    Introduction Enhanced bioremediation is a process in which indigenous or inoculated micro-organisms (e.g., fungi, bacteria, and other microbes) degrade (metabolize) organic contaminants found in soil and/or ground water, converting them to innocuous end products. Nutrients, oxygen, or other amendments may be used to enhance bioremediation and contaminant desorption from subsurface materials. ...

  • Comparing pesticide residues in Amish and commercially grown strawberries and spinach using QuEChERS, Various dSPE Sorbents, and GC-TOFMS

    Abstract QuEChERS extraction, dSPE cleanup, and GC-TOFMS analysis were used to assess pesticide levels in strawberries and spinach from both commercial and Amish growers. Various dSPE cleanup products were compared to determine which were most effective. Good recoveries were obtained for most pesticides; however, low recoveries were observed for some base-sensitive or planar compounds. ...


    By Restek Corporation

Need help finding the right suppliers? Try XPRT Sourcing. Let the XPRTs do the work for you