in-situ remedial method Articles

  • An experimental investigation of thermal methods for In-Situ remediation of MTBE-impacted groundwater

    Presentation Outline Review of MTBE Experiment Objectives Experimental Procedure Experimental Results Implementation of Soil Heating in the Field Conclusions. Properties of MTBE MTBE has a high solubility in water. It is ~ 24 times more soluble in water than Benzene (43,000 to 50,000 ...


    By McMillan-McGee Corp.

  • In Situ electromagnetic heating for hydrocarbon recovery and environmental remediation

    Introduction Thermal recovery methods, as applied in heavy oil and oil sand deposits, and in environmental remediation, have the common objective of accelerating the hydrocarbon recovery process. Raising the temperature of the host formation reduces the oil and bitumen viscosity, and, in environmental remediation, increases vapour pressure. These effects assist in sweeping the substances ...


    By McMillan-McGee Corp.

  • In situ Chemical Oxidation: An Innovative Groundwater Remediation Technology

    A promising new technology, in situ Chemical Oxidation (ISCO), has the potential to supplant the more widely used pump-and-treat groundwater remediation technology by destroying groundwater contamination in situ (in place). ISCO is the process of oxidizing contaminants in the groundwater and soil by injecting water containing high concentrations of an oxidant to the site of the contamination. ...


    By AECOM

  • In situ Remediation of 1,4-Dioxane using Electrical Resistance Heating

    An increasing number of states are establishing enforceable 1,4-dioxane cleanup goals due to recent improvements in analytical detection methods and existing carcinogenic risk information for 1,4-dioxane. Historically, 1,4-dioxane was used as a stabilizer for chlorinated solvents, primarily 1,1,1-trichloroethane. In addition, 1,4-dioxane has been used in a broad range of products including but ...


    By TRS Group, Inc.

  • In-Situ Remediation of Heavy Metals Using Sulfur-Based Treatment Technologies

    The Metal Problem Highly toxic and highly soluble metals are contained in numerous waste streams including those from power, chemical, electronics facilities, general manufacturing plants, and mining facilities. Lead, chromium, arsenic, zinc, cadmium, copper, and mercury are the most common metal contaminants found on remediation project sites (US EPA, October, 2000). Cyanide is a common ...


    By Graus Chemicals, LLC

  • In Situ Solidification/Stabilization

    Introduction Solidification/stabilization (S/S) reduces the mobility of hazardous substances and contaminants in the environment through both physical and chemical means. Unlike other remedial technologies, S/S seeks to trap or immobilize contaminants within their 'host' medium (i.e., the soil, sand, and/or building materials that contain them), instead of removing them through chemical or ...

  • Surfactant enhanced in-situ remediation of DNAPL impacted soil and groundwater - Montreal refinery

    Abstract A Montreal chemical refinery reduced the dichlorobenzene and other dense non-aqueous phase liquid (DNAPL) impacts on the soil and groundwater where a railway line is adjacent to an above ground storage tank farm. Ivey-sol® surfactant mixtures were injected three times during a two week pilot test, into a series of in-situ wells. The soil and groundwater matrix experienced ...


    By Ivey International Inc.

  • Soil Vapor Extraction (In Situ)

    Introduction Soil vapor extraction (SVE) is an in situ unsaturated (vadose) zone soil remediation technology in which a vacuum is applied to the soil to induce the controlled flow of air and remove volatile and some semivolatile contaminants from the soil. The gas leaving the soil may be treated to recover or destroy the contaminants, depending on local and state air discharge regulations. ...

  • The power of precise remediation

    Design matters in in-situ remediation. Just ask Resource Geoscience, Inc. (RGI), a Remediation Products, Inc. BOS 200 approved installer and certified Trap and Treat Consultant. They recently demonstrated that when paired with proper injection design and precise application, BOS 200 can get the job done where others fail. The site:  Contaminated clay site in Colorado ...

  • CASE STUDY - Setup and calibration of a three-dimensional numerical multiphase model for design of in-situ remediation of jet fuel with surfactant

    BACKGROUND Storage and pumping of jet-fuel have caused a severe contamination of soil and groundwater at a military facility in Denmark. The contamination was detected in 2001. The Danish Defence has conducted 3 a series of investigations and set up a skimmer system, that has recovered approximately 25 m of jetfuel. In 2005, the recovery stopped, and the remaining jet-fuel is trapped as a ...


    By Ivey International Inc.

  • Enhancing in-situ chemical oxidation performance

    In this edition of Peroxygen Talk, guest authors Matt Burns and Bob Pirkle discuss the benefits of compound specific isotope analysis (CSIA) to optimize delivery and monitor performance of ISCO applications. Mr. Burns is a Senior Project Director at WSP Environment & Energy, a leading environmental, energy and sustainability consultancy with over 1,000 people in 65 global locations. He has more ...

  • F4 Spill In Situ Bioremediation Applications

    F4 Completed an in situ water bioremediation program of Bio-ReClaim in northern Alberta; a pipeline leaked crude oil over a 14 hectare area in muskeg. Alberta Environment (AEP) allowed the in situ water application of Bio-Reclaim by F4 Environmental. Keeping in mind the application was performed without any ground disturbance and extremely cost effective compared to the ...


    By F4 Environmental Inc.

  • Insitu Soil Remediation case study

    A burst storage tank resulted in severe pollution beneath a building. Using EU70 and added nutrients the contractor was able to use insitu remediation techniques to very quickly reduce the contaminates to levels well below those required by the authorities. Additional benefits were the minimal disturbance to property and access and the ability to provide a complete solution. This could not ...


    By Bio Systems Europe

  • CH#954 - Diesel/Gasoline Remediation

    SITE OWNER: A Truck and Fueling Plaza SITE SURVEY: A tank area that had contained both diesel and gasoline tanks was discovered to have several leaks. The tanks from the pit area were removed. Definition and characterization revealed that not only the tank area was contaminated, but the contaminate plume had migrated under an area where a new building ...

  • GCW as a means of efficiently remediating contaminated groundwater

    With the conventional 'Pump & Treat' method, groundwater is normally extracted from one or several wells, cleaned above ground and disposed off to the either groundwater or surface water. Even when extraction and injection wells are combined, predominantly higher perme-able areas are preferentially penetrated and more fine-grained structures are circumflowed. The bulk of contaminants are ...


    By IEG Technologie GmbH

  • DEC offer Advanced In-situ Immobilisation and Capping Technique for Polluted Sediments

    In the July 2002 issue dedicated to environmental dredging of World Dredging Mining & Construction, DEC present its newly developed in-situ immobilisation and capping technique for polluted sediments, the 3SI-technique. DEME Environmental Contractors N.V. (DEC), a Belgium-based company specialising in remediation and recycling or disposal of water bottom sediments, is offering a vast range ...

  • CH#955 - Fuel Remediation, Difficult Location

    SITE OWNER: A Petroleum Jobber SITE SURVEY: Site and geological surveys had revealed a contaminated area down a gradient from the existing fuel tanks. If was further determined that the contamination was not from the existing tanks through precision testing. The borings described the contamination as resting between the 14 and 20 foot level below the ...

  • In-situ stabilization using Shallow Soil Mixing and Deep Soil Mixing

    Of the currently emerging technologies for site remediation, one of the most attractive and economical is in-situ stabilization and/or in-situ fixation of contaminated soils by Shallow Soil Mixing (SSM) or Deep Soil Mixing (DSM). Actually, the soil mixing process is not new. It has been in use as a geotechnical construction process for over two decades. However, its use as a treatment for ...


    By Geo-Con, Inc.

  • Consideration of the Effects of Remediation Technologies on Natural Attenuation.

    ABSTRACT: We have long understood and continue to improve our understanding of the geochemical conditions that favor biodegradation of petroleum hydrocarbons. Over the last several years our understanding of the conditions that are necessary for and/or promote reductive dechlorination of chlorinated hydrocarbons has improved substantially. Over this time in situ remediation technologies have ...


    By Regenesis

  • Spolchemie site remediation and NanoRem field site application

    Site Remediation The Spolchemie site was chosen as one of the NanoRem case study sites, to test two types of nanoparticles (NPs) (zerovalent iron - nZVI and iron oxide NPs) for in situ remediation of BTEX (Benzene, Toluene, Ethylbenzene, and Xylenes) contamination. Nanoremediation was seen as an opportunity to enhance the in situ biodegradation of the BTEX contaminants and to reduce the ...


    By NANO IRON s.r.o.

Need help finding the right suppliers? Try XPRT Sourcing. Let the XPRTs do the work for you