in-situ stack measurement Articles

  • In-situ continuous emissions monitoring & regulatory compliance

    As environmental scrutiny has risen and regulation has tightened in recent years, the importance of having accurate information on the environmental performance of your power plant has increased. After all, if you want to manage something, you need to be able to measure it. The analogy is obvious; you wouldn't start a diet without first investing in a set of scales. So it is with Continuous ...

  • An analysis of extinction coefficients of particles and water moisture in the stack after flue gas desulfurization at a coal-fired power plant

    Two important factors that affect in-stack opacity—light extinction by emitted particles and that by water moisture after a flue gas desulfurization (FGD) unit—are investigated. The mass light extinction coefficients for particles and water moisture, kp and kw, respectively, were determined using the Lambert-Beer law of opacity with a nonlinear least-squares regression method. The ...

  • Air emissions impact measurements at a perchloroethene remediation site

    As part of an U.S. EPA time critical removal action, an air monitoring system was established to measure real-time impacts of perchloroethene (PCE) on the surrounding areas. The soils and groundwater beneath the site (located in West Fargo, North Dakota) were treated using in situ heating of soil and groundwater, with the produced vapors collected using conventional vapor extraction. In order ...


    By VOC Technologies

  • Improved HF monitoring in Primary Aluminium Smelters with Laser Gas Detectors

    Primary aluminium smelting generates large amounts of hydrogen fluoride gas (HF). Concerns for worker safety and ambient air quality require that HF be monitored at several locations in smelters. Historically, a variety of methods have been used for HF monitoring. Cassette samplers and wet chemistry techniques, coupled with complex and expensive ...


    By Boreal Laser Inc.

  • Full-scale SVE system operates in tandem with groundwater treatment

    Since 1993, SVE has been implemented using two designs at the TP Industrial, Inc. (TPI) site in Gardena, CA, to treat soil contaminated with chlorinated solvents. The SVE system was modified in 1997 to improve emissions control efficiency by using carbon adsorption units that treat effluent from an air-stripping system for treating site ground water. By the end of 2007, SVE had removed a ...

  • Global solution: Gas and particulate analysis in Cement industry

    Cement plants are increasingly required to install continuous emission monitoring systems (CEMS). While these represent a significant financial outlay, a range of other factors also need to be considered when selecting a suitable CEMS. To the inexperienced, selecting a suitable CEM can mistakenly be considered as simply ensuring that the applicable national regulations (eg MACT in the USA, ...


    By Environnement S.A

  • Total solution: Gas and particulate analysis in Cement industry

    Cement plants are increasingly required to install continuous emission monitoring systems (CEMS). While these represent a significant financial outlay, a range of other factors also need to be considered when selecting a suitable CEMS. To the inexperienced, selecting a suitable CEM can mistakenly be considered as simply ensuring that the applicable national regulations (eg MACT in the USA, ...


    By Environnement S.A

  • Pollution monitoring in Cement Industry

    The rising use of waste based fuels in the cement industry, both for economic and Environmental objectives, combined with the strengthening of air emission regulations around the world is pushing many operators to face a wider list of pollutants to monitor this, with associated costs. The design of appropriate solutions meeting local regulation is the key to maximize the cost benefit of the fuel ...


    By Environnement S.A

Need help finding the right suppliers? Try XPRT Sourcing. Let the XPRTs do the work for you