in-stack testing cell Articles

  • Engineers Benefit from Geotube Stacking Technology & Analysis - Case Study

    Stacking Geobag units makes projects previously thought impossible, possible. Since 1962, Geotube  technology has protected countless shorelines and provided low cost, high volume dewatering solutions to companies all over the world. Starting off as a single layer unit designed for shoreline erosion protection, Geotube structures have been developed and improved for more than 40 ...

  • Case study - Engine cell exhaust: Catalytic oxidizer

    Overview Endurance testing of outboard motors for boats has typically been done in lakes and sometimes on barges. This testing was time consuming, presented logistic problems and removed the testing from the R & D department and the factory. When a company in Oklahoma decided to build their own endurance test cell area, the Environmental Protection Agency required them to control the ...

  • Gas cell selection for analysis of electronic gases

    APIMS and FTIR remain the preferred analytical tools for monitoring impurities in the electronic  specialty gases used by the semiconductor industry, although other tools such as CRDS are currently finding application in selected cases. FTIR spectroscopy offers the advantage of the simultaneous measurement of all gaseous species that exhibit dipole moment changes during vibrations at ...


    By CIC Photonics, Inc.

  • Coming In Out of the Cold: Hybrids Put to the Test

    Untitled Document Point Roberts, WA, Delta B.C.- May 25, 2004 With gas prices reaching an all time high and not much promise of an end in sight, hybrid technology is falling under the lens of some careful ...


    By Investorideas.com

  • Enrichment and application of nitrifying activated sludge in membrane bioreactors

    In this study, nitrifying bacteria were enriched in a membrane bioreactor (MBR, R1) and their bioaugmentation effectiveness was evaluated in another two MBRs (R2 and R3). Nitrifying activated sludge (NAS) with high nitrification activity of up to 3,000 mg-N/(L·d)−1 was successfully enriched in R1. The results showed that chemical oxygen demand concentration of 100–200 mg/L had no negative ...


    By IWA Publishing

  • A New Simple Shear Apparatus

    A new simple shear device capable of measuring a complete set of stresses during simple shear deformation is described. This simple shear device tests a cuboidal specimen whose lateral sides are surrounded by a rubber membrane reinforced by a stack of Teflon® coated aluminum plates. One of the aluminum plates is used as a transducer to determine the lateral stresses on planes normal and parallel ...


    By ASTM International

  • Membrane Electrode Assembly (MEA) Activation Procedures

    Why is an activation procedure or break-in necessary for a membrane electrode assembly (MEA)?  A large reason for performing an activation procedure or break-in is to properly humidify the membrane portion of the MEA that was dried out during the hot press stage of the membrane electrode ...


    By Fuel Cells Etc

  • In-situ continuous emissions monitoring & regulatory compliance

    As environmental scrutiny has risen and regulation has tightened in recent years, the importance of having accurate information on the environmental performance of your power plant has increased. After all, if you want to manage something, you need to be able to measure it. The analogy is obvious; you wouldn't start a diet without first investing in a set of scales. So it is with Continuous ...

  • Infrared differential absorption Lidar (DIAL) measurements of hydrocarbon emissions

    We report the application of an infrared (IR) differential absorption Lidar (DIAL) system (also capable of ultra violet measurements) built at the National Physical Laboratory (NPL), UK, to field measurements of total site emissions (controlled and fugitive) from petrochemical and landfill installations. The validation of the IR-DIAL was carried out via a series of controlled field experiments ...

  • New laser-based dust emission monitoring system

    Abstract A new generation of continuous particulate matter concentration monitoring instruments is presented, covering a measuring range of 0 to 1000 mg/m3. The laser-based scattered light instrument gives an improved stability as well as excellent resolution in the low range. This enables high concentration measurement as well as especially low emission monitoring down to 0.01 mg/m3 with a ...


    By SIGRIST - PHOTOMETER AG

  • Odor Control Advances at Composting Facility

    The Rockland County (New York) Cocomposting Facility began operations in February, 1999, processing biosolids from the five publicly owned treatment works (POTWs) in the county. The Rockland County Solid Waste Management Authority (RCSWMA) owns the facility, but contracted with Waste Management of New York to design, build and operate (DBO) the 110 wet tons/day agitated bin composting facility ...


    By BioCycle Magazine

  • Reducing Odor and VOC Emissions

    The Montgomery County Regional Composting Facility (MCRCF) in Silver Spring, Maryland is designed to process 400 wet tons/day of lime amended biosolids from the Blue Plains Wastewater Treatment Plant (WWTP) in Washington, D.C. Recently, political pressures forced operations to cease at the MCRCF. Although the aerated static pile composting plant’s fate has not been completely decided, its owner, ...


    By BioCycle Magazine

  • Harnessing The Power Of Microbes

    University researchers are advancing both the understanding and scalability of a biological process where bacteria living under anaerobic conditions consume organic waste and generate electrons and protons that are tapped for electricity production.IMAGINE a self-sustaining battery that never runs out of juice. While the notion may sound far-fetched, Dr. Leonard Tender at the Naval Research ...


    By BioCycle Magazine

  • Total solution: Gas and particulate analysis in Cement industry

    Cement plants are increasingly required to install continuous emission monitoring systems (CEMS). While these represent a significant financial outlay, a range of other factors also need to be considered when selecting a suitable CEMS. To the inexperienced, selecting a suitable CEM can mistakenly be considered as simply ensuring that the applicable national regulations (eg MACT in the USA, ...


    By Environnement S.A

  • Global solution: Gas and particulate analysis in Cement industry

    Cement plants are increasingly required to install continuous emission monitoring systems (CEMS). While these represent a significant financial outlay, a range of other factors also need to be considered when selecting a suitable CEMS. To the inexperienced, selecting a suitable CEM can mistakenly be considered as simply ensuring that the applicable national regulations (eg MACT in the USA, ...


    By Environnement S.A

  • An EHS Checklist for Low-Risk Technology Facilities

    For environment, health and safety (EHS) managers at technology companies, identifying, assessing and prioritizing potential risks in a lower-risk environment - from offices to call centers - is part of the job. And when it comes to EHS programs, compliance is just the start. The following EHS checklist can serve as an assessment guide for EHS managers of low-risk ...


    By Antea Group - USA

  • Biofilter Applications in the Coatings Industry.

    Soaring energy costs and the high cost of ‘end-of-pipe’ pollution control equipment has caused companies and regulatory agencies to re-evaluate ‘unconventional’ means of achieving VOC and HAP emissions control. The coatings industry is an excellent candidate for alternative, unconventional controls, as VOC and HAP reductions have not been as strident as has been the case in many other industries. ...


  • Application of Membrane Technology for the Recovery and Reuse of Water

    Abstract As water and sewer costs are expected to increase over the next decade, membrane technology will continue to be a viable and economical option in the recovery and reuse of water. This paper describes the mechanism of membrane effected separation (specifically reverse osmosis, ultrafiltration and microfiltration), membranes commercially available, membrane element configurations, and how ...


  • Smart Series-Odor Management

    Tackling odors at composting facilities is a manageable task made simpler by inventorying and treating all sources and tapping into technology advances. Perhaps one of the most difficult realities that had to be faced 15 to 20 years ago by the composting universe is that the phrase, “odor-free” - at least when it comes to composting - is probably an oxymoron. Feedstocks that biodegrade within the ...


    By BioCycle Magazine

  • Drought Forces Push to Recycle, Reuse and Potential in Brackish Water for Oil & Gas Industry: Interview with BioLargo CEO

    UPTICK Interview: BioLargo's AOS Filter Delivers Abundant Clean Water Even In Drought The headlines are full of discussion on water shortages and drought with few options consistently noted beyond the need to conserve and manage the precious resource. To gain perspective on the problem and explore viable solutions UPTICK Newswire interviewed ...


    By Biolargo, Inc.

Need help finding the right suppliers? Try XPRT Sourcing. Let the XPRTs do the work for you