infrared gas meter Articles

  • The Drumbeat on infrared thermal imaging

    Drumbeat Energy regards infrared (thermal) imaging as an amazingly useful tool in the quest for greater energy efficiency. It has the ability to define non-invasively and with uncanny speed and accuracy where heat is leaking from a building. Never was the expression “A picture paints a thousand words” ...


    By Drumbeat Energy Limited

  • A novel spectrometer design for process and handheld infrared spectral measurements

    Introduction Infrared spectroscopy offers many unique advantages for measurements within an industrial environment. Historically, the technique has been used for a broad range of applications from the composition of gas and liquid mixtures to the analysis of trace components for gas purity analysis. In cases where a well-defined method of analysis is involved, such as the measurement of ...


    By CIC Photonics, Inc.

  • Comparing TGA, FTIR and fixed filter infrared analyzers for measuring soot levels in in-service lubricants

    Measuring soot in diesel engine oil has become more important as soot levels get higher due to exhaust gas recirculation. As soot isone of the key indicators for the condition of the oil, diesel engine maintenance programs performing regular soot checks can realize cost savings by extending drain periods and reducing used oil disposal. TGA (Thermal Gravimetric Analysis) is the traditional method ...


    By Spectro Scientific

  • Wastewater Treatment Plant Monitors Greenhouse Gas Emissions

    Globally, little attention is paid to gaseous emissions from wastewater treatment processes. This contrasts greatly with the regulatory monitoring that is applied to the quality of water emissions from such facilities. However, in Helsinki, Finland, a large municipal wastewater treatment facility continuously monitors its emissions of greenhouse gases (GHGs) to help in the city’s efforts to ...


    By Gasmet Technologies Oy

  • Safety Systems Depend on Reliable Field Sensors (Emphasis on Fire and Gas Detectors)

    Abstract Because not all hazards are the same, identifying and quantifying the hazard is the starting point in choosing sensing technology. Not all detectors are the same, and they should be selected according to their ability to detect the hazard. This paper gives a broad summary of technologies that provide users reliable responses to hazardous conditions, that minimise false ...

  • A Comparison of Point Sensors and Open Path Monitors For Toxic Gas (esp. HF) Monitoring

    Point Sensors Ion Mobility Spectroscope (IMS) – a gas sample is ionized by a radioactive source (Ni63). Differences in ion drift under the influence of an applied electric field produce a spectrum that is dependent on the mass, charge, and shape of the component ions. The detector signal and strength is tuned to the drift time of the ion of interest (in this case HF) and signal strength is ...


    By Boreal Laser Inc.

  • Pioneer 3D simulation of volcanic eruption

    On 30 September 2007, between 11:30 and 12:00 UTC (14:30 and 15:00 local time), Jebel al-Tair, a small volcanic island in the Red Sea erupted for the first time since 1883. The western part of the island suffered a collapse following the eruption and lava flows and fire fountains were observed. 3 military personnel lost their lives. Satellite imagery showed just a small plume of ash, indicating ...

  • Detection of early PFA seals (perfluoroalk-oxyethylene) degradation exposed to process gases inside a reactor chamber

    Problem Statement Replacement of PFA seals inside the reactor chamber is performed according scheduled maintenance and life expectancy of the seals. Early degradation of seals goes completely undetected until there is a complete failure of the seal, letting atmospheric contaminants inside the reactor and forcing an unscheduled reactor downtime. IRGAS ...


    By CIC Photonics, Inc.

  • Monitoring the performance of moisture purifiers for process gases

    Problem Statement Moisture purifiers are a big aid in keeping moisture levels under control inside a process chamber. They are provided by manufacturers with certain life expectancies, which vary depending on the moisture content of the gas being purified. As a result, it is difficult to determine which gases have a high moisture content and which moisture purifier is becoming ...


    By CIC Photonics, Inc.

  • Continuous monitoring of moisture present inside a process chamber

    Problem Statement Moisture inside a process chamber is a big silent killer during wafer production. When production yield goes down, it is hard to pinpoint the source of the problem. Most of the time wafers need to be sent to labs for analysis, while production is stopped. If the problem is related to a high level of moisture inside the reactor, there are several factors that can cause ...


    By CIC Photonics, Inc.

  • Detection and measurement of toxic gases from destructive testing of batteries

    Problem Statement New formulations of organic-compound-based batteries for vehicle use must be tested for release of potentially harmful and toxic gases if crushed in accidents. Potential gases include hydrocarbons, fluorocarbons, and hydrogen fluoride, released within seconds of an incident. Actual time-resolved and quantitative data are required from destructive testing to ascertain ...


    By CIC Photonics, Inc.

  • Common Treatment Technologies for Fuels in Soil, Sediment, and Sludge

    Common treatment technologies for fuels in soil, sediment, and sludge include biodegradation, incineration, SVE, and low temperature thermal desorption. Incineration is typically used when chlorinated SVOCs are also present with fuel, and not specified for fuel-only contaminated soil, sediment, or sludge. All types of biodegradation, both in situ or ex situ, can be used to remediate soils: ...

  • CO2 vs. VOC Sensors for IAQ - What`s the Difference

    People sometimes ask about the differences between VOC (Volatile Organic Compounds) sensors and CO2 sensors. While both can be used to measure indoor air quality (IAQ), these sensors are not interchangeable. They measure very different things. CO2 sensing technology by IR (infrared) is stable and is not subject to the short-term, random drift found in air quality sensors. Most IR carbon ...


    By CO2 Meter, Inc.

  • Reaching underground resources

    Accessing critical resources such as geothermal energy and natural gas requires drilling — an expensive, energy-intensive, messy process with today's technology. An MIT team has been looking into a more elegant approach. Instead of grinding rock to bits, they would use a continuous beam of energy to vaporize it and then blow out the tiny particles that form with a high-pressure stream of ...

  • These fires are huge, hidden and harmful. What can we do?

    Smoldering peat gives off massive quantities of carbon dioxide and other pollutants, but the search for solutions is on. As forest fires devastated Fort McMurray, Alberta, last month, a different sort of fire may have started beneath the ground. Peat, a carbon-rich soil created from partially decomposed, waterlogged vegetation accumulated over several millennia and the stuff ...


    By Ensia

  • Intelligent electric valve actuation on China’s West-East Pipeline - Case Study

    Overview The West-East Pipeline (WEPP) network is described as the largest and most significant gas industry project ever planned in China. Intended for the development of the western regions in China, the project involves construction of four gas pipelines connecting the eastern markets of China with the western resources. Thousands of kilometres of pipelines travel along varied terrains ...


    By Rotork

  • Tech update: Plant instrumentation - food engineering

    Sensors and other devices are the foot soldiers in automation architecture, but most food and beverage manufacturers still are looking for full value. You know an equipment category has arrived when it starts getting its own industry-specific center. For the food production sensors that do the heavy lifting in instrumentation technology, that day could arrive earlier rather than ...


    By Hardy Process Solutions

  • Sorting and Recycling Municipal Solid Waste (MSW) in Xiamen City, China - Case Study

    TOMRA Sorting Recycling is playing a pivotal role in the implementation of automatic sorting at the MSW plant in Xiamen Background The city of Xiamen, renowned for its natural beauty, is located on China's southeast coast, in Fujian Province. Its famous seascape and clean natural environment are a magnet for tourists, and the city government wants to keep things ...


    By TOMRA Sorting (TITECH)

Need help finding the right suppliers? Try XPRT Sourcing. Let the XPRTs do the work for you