ion selective monitoring Articles

  • Determining Nitrate and Nitrite Sequentially Using a Nitrite Ion Selective Electrode

    ABSTRACT Reliable analysis for NO3- and NO2- contained in wastewater, soils and reclaimed water is extremely important as these constituents can easily leach into ...


  • Two Detector Solution to Analyzing Sulfur

    Sulfur compounds are reactive, corrosive to pipes, and destructive to catalysts in petroleum refineries. Sulfur emission are strictly regulated globally. When released into the atmosphere sulfur dioxide converts to sulfuric acid resulting in adverse effects on human health and the environment. Sulfur detection is found useful in many other industries; therefore, detection of sulfur compounds in ...


    By Restek Corporation

  • Determination of VOCs in water using static headspace GC/MS with simultaneous full scan and selective ion recording

    The combination of static headspace sample introduction and gas chromatography/mass spectrometry (HS/GC/MS) provides the analyst with a powerful, fully automated technique for the determination of trace volatile organic compounds (VOCs) in water. Samples may be hermetically sealed in the headspace vial at the point of sampling. This approach avoids errors due to glassware cross-contamination and ...


    By PerkinElmer, Inc.

  • Analysis of Organophosphorus and Organonitrogen herbicides in water using GC/MS with selected ion recording

    Laboratories monitoring trace level pesticides and herbicides by gas chromatography/mass spectrometry (GC/MS) frequently utilize Selected Ion Recording (SIR) techniques to maximize analytical sensitivity for quantification. With analytical standards, precision is limited to a large extent only by the autosampler and other instrumental effects. However, real-world samples pose a greater challenge. ...


    By PerkinElmer, Inc.

  • CO2 adsorption over ion-exchanged zeolite beta with alkali and alkaline earth metal ions

    The need to reduce anthropogenic CO2 emissions has been the driving force to consider new approaches and novel ideas for CO2 management, and carbon capture and storage (CCS) are considered to potentially be the most effective means to alleviate the problem. The most common method for CO2 capture is via gas absorption, with monoethanol amine (MEA) being the most widely used solvent. The current ...


    By Hiden Analytical

  • What’s the big deal about ion mobility mass spectrometry?

    Ion mobility spectrometry (IMS) is a technique that differentiates ions based on their size, shape, charge, and mass. While often used in small, portable devices at airports and remote locations for rapidly detecting small molecules whose mobility is known (for example, certain narcotics and explosives) when coupled with liquid chromatography-mass spectrometry (LC/MS), IMS provides an orthogonal ...


    By Waters Corporation

  • Gas cell selection for analysis of electronic gases

    APIMS and FTIR remain the preferred analytical tools for monitoring impurities in the electronic  specialty gases used by the semiconductor industry, although other tools such as CRDS are currently finding application in selected cases. FTIR spectroscopy offers the advantage of the simultaneous measurement of all gaseous species that exhibit dipole moment changes during vibrations at ...


    By CIC Photonics, Inc.

  • Real-Time Membrane Fouling Monitoring

    The Port Hueneme Water Agency (PHWA) has been operating a municipal drinking water treatment plant designed to be a Brackish Water Reclamation Demonstration Facility. The facility consists of 3 separate side-by-side full scale systems or trains, each representing a major membrane separation process: nanofiltration (NF), reverse osmosis (RO) and electro dialysis reversal (EDR). Both the NF and RO ...


    By MASAR Technologies, Inc.

  • Air Monitoring for the Gulf Oil Spill

    Ambient air monitoring is a priority in the ongoing efforts to contain and manage the oil spill from the Deepwater Horizon in the Gulf of Mexico. The following provides information about the kinds of airborne contaminants that are currently being monitored in the Gulf, how they are collected and how they are analyzed. For a given project, a suitable sampling plan – developed by ...


  • Improved HF monitoring in Primary Aluminium Smelters with Laser Gas Detectors

    Primary aluminium smelting generates large amounts of hydrogen fluoride gas (HF). Concerns for worker safety and ambient air quality require that HF be monitored at several locations in smelters. Historically, a variety of methods have been used for HF monitoring. Cassette samplers and wet chemistry techniques, coupled with complex and expensive ...


    By Boreal Laser Inc.

  • Teledyne Scientific Instruments - Direct Sampling MS and MS/MS for Real Time Air Monitoring

    Presented at the 44th ASMS Conference on Mass Spectrometry, May 12-16, 1996 Portland, OR. Published in the Proceedings of the 44th ASMS Conference on Mass Spectrometry May 12-16, 1996 Portland, OR, in press. DIRECT SAMPLING MS AND MS/MS FOR REAL TIME AIR MONITORING C. Remigi, P.T. Palmer, Dept. of Chemistry & Biochemistry, SF State University, SF, CA ...


    By Environics, Inc.

  • Phosphate detection in water - a potential amperometric approach

    Excess phosphorus causes eutrophication (excess of nutrient promoting a proliferation of plants, (especially algae) inecosystems. Consequently, the monitoring of phosphate in waste, drinking and natural water is of major importance.There is a strong interest in a method alternative to the standard molybdate colorimetric method, which is not well suited to continuous monitoring under field ...


  • GC-MS Analysis Agricultural Pesticides on the SLB-5ms

    This application illustrates the analysis of 29 different agricultural pesticides of different classifications and functionalities, using the SLB-5ms, 30 m x 0.25 mm I.D., 0.25 μm  The analysis was done by GC-MS using selected ion monitoring (SIM) to allow detection of all compounds at 100 µg/L. The standard solution was made in toluene to increase it stability and enhance response ...


    By Sigma-Aldrich Co., LLC

  • GC/MS-SIM-An option for lower detection limits

    Select Ion Monitoring mode (GC/MS-SIM) is a technique used to perform low level GC/MS measurements of organic compounds. GC/MS-SIM can reduce reporting limits 10-100 fold and can minimize the effects of matrix interferences.                                                   ...

  • Comparison of behaviour and fate of tetrabromobisphenol A (TBBPA) in membrane bioreactors and conventional activated sludge process

    Research was completed on the behaviour and fate of tetrabromobisphenol A (TBBPA) in pilot-scale membrane bioreactors and conventional activated sludge (CAS) process at the City of Guelph Wastewater Treatment Plant. Emphasis was on the physicochemical processes, biological transformation and sorption kinetics. Measurement of TBBPA at the environmental level can be challenging, so the main focus ...


    By IWA Publishing

  • Analysis of TNT, RDX, and CL-20 by APCI LC/MS/MS

    IntroductionThe detection and characterization of explosives has gained the interest of various analytical laboratories and researchgroups around the world.For the forensic community, trace analysis of explosive residues after arson and terrorism is of critical interest.Biologists and environmentalists monitor biotransformation of these high energy compounds when evaluating ...


  • Sustainable water management with multi-quality recycled water production: the example of San Luis Potosi in Mexico

    This paper presents and discusses the performance, reliability of operation, socio-economic and environmental aspects and benefits of the Tenorio Project in San Luis Potosi. This is the first project in Mexico making possible the production of multi-quality recycled water for planned water reuse for different purposes, including industrial cooling in a power plant, agricultural irrigation, ...


    By IWA Publishing

  • Methods of Water Purification

    This article is excerpted from 'Pure Water Handbook' published by Osmonics®, Inc. of Minnetonka, Minnesota USA and is printed with permission of Osmonics, Inc. Water treatment can be defined as any procedure or method used to alter the chemical composition or natural 'behavior' of a water supply. Water supplies are classified as either surface water or groundwater. The majority of public or ...

  • On-Line Nitrate/Nitrite Probes for BNR Process Control

    ABSTRACTReal time nitrogen monitoring plays an increasingly important role for the successful biological nutrient removal at wastewater treatment plants. Though traditionally dissolved oxygen has been the main process control parameter a greater understanding of the biological mechanisms and process conditions like nitrite/nitrate concentrations to achieve lower effluent values becomes necessary, ...

  • Analysis of Anionic Contamination & General Quality Testing in Water from Sewage Treatment Plants and Industrial Discharge & Effluents by Colorimetry

    Problem The high concentration of Industry, Agriculture and People in and around the United States has changed the “nature” of our environment. There are Toxic Metals coming from various metallurgical processes; Plating, Foundry, Smelting, Milling, etc., which are readily determined by Atomic Absorption Spectroscopy (AAS). Volatile Organics from the many Petrochemical-based operations are ...


    By Buck Scientific Inc

Need help finding the right suppliers? Try XPRT Sourcing. Let the XPRTs do the work for you