laboratory air compressor Articles

  • A PFC–based PMBLDCM drive for air–conditioner using half–bridge buck converter

    A diode bridge fed buck half–bridge DC–DC converter fed from single–phase AC mains is used as a single–stage power factor correction (PFC) converter for feeding a voltage source inverter (VSI) based permanent magnet brushless DC motor (PMBLDCM) drive. The PMBLDCM is used to drive a compressor load of an air conditioner through a three–phase VSI fed from a constant DC voltage. The speed of the ...


    By Inderscience Publishers

  • How does the Synthetic Refrigerant Additive (SRA) Affect Maintenance and Wear?

    This document describes how SRA affects the maintenance and wear of an air conditioning system into which it is installed. There are two synthetic catalysts in SRA: The major catalyst is one which removes the oil-fouling plaque. This plaque is extensively described by ASHRAE. The second is an advanced lubricity agent. The advanced lubricity agent is several ...


    By Power Knot LLC

  • Southwest Research Institute® (SwRI®) Technical Report Summary; SwRI Project No. 08.16032.009, “Filter Cleanability Testing”

    This Technical Report Summary presents an overview of laboratory testing conducted at SwRI to evaluate the performance of a Diversi-Tech Green Filter Cleaning Machine under controlled laboratory conditions. In particular, the objective was to measure if and by how much, if any, airflow resistance, efficiency, and dust capacity changed for a given number of dust loading/filter cleaning cycles, ...


    By DiversiTech

  • DuPont LoWave Acoustic Material with Low-Frequency attenuation case study

    A major U.S. manufacturer of laboratory equipment was concerned that one of its newest pieces of equipment would not gain widespread acceptance in the marketplace due to its high overall noise level and unpleasant sound quality. Company officials needed to improve the sound signature of the equipment improving the comfort level of people working around it, without altering product design in a way ...


    By NEVA Associates

  • Green Filter Cleaning Machine case study

    This Technical Report Summary presents an overview of laboratory testing conducted at SwRI to evaluate the performance of a Diversi-Tech Green Filter Cleaning Machine under controlled laboratory conditions. In particular, the objective was to measure if and by how much, if any, airflow resistance, efficiency, and dust capacity changed for a given number of dust loading/filter cleaning cycles, ...


    By DiversiTech

  • All in One Unit for GC Applications

    Leman Instruments is a leading European company, specialised in standard products, OEMs and in custom designed realisations involving high purity H2, N2, zero air, combined solutions for FIDs, GCs, purge air generators, CH4 & CO2 scrubbers, N2 and multigas for LCMS with high level of communications involving Ethernet, USB, RS 485 and ...


    By Leman Instruments SAS

  • Achieving

    Introduction The leak repair requirements, under Title VI Section 608 of the Clean Air Act Amendments of 1990, require that when an owner or operator of an appliance that normally contains a refrigerant charge of more than 50 pounds discovers that refrigerant is leaking at a rate that would exceed the applicable trigger rate during a 12-month period, the owner or operator must take corrective ...


  • Full-scale SVE system operates in tandem with groundwater treatment

    Since 1993, SVE has been implemented using two designs at the TP Industrial, Inc. (TPI) site in Gardena, CA, to treat soil contaminated with chlorinated solvents. The SVE system was modified in 1997 to improve emissions control efficiency by using carbon adsorption units that treat effluent from an air-stripping system for treating site ground water. By the end of 2007, SVE had removed a ...

  • Chlorinated solvents: methylene chloride and TCE

    Introduction This paper presents the results of a scaled and phased approach to source remediation of high concentrations of recalcitrant chlorinated solvent compounds via soil vapor extraction (SVE) and vapor treatment at a Site in Southern California. Phase I began with refrigerated condensation (C3) in order to achieve high mass removal rates to reduce lifecycle costs and time ...

  • Tech update: Plant instrumentation - food engineering

    Sensors and other devices are the foot soldiers in automation architecture, but most food and beverage manufacturers still are looking for full value. You know an equipment category has arrived when it starts getting its own industry-specific center. For the food production sensors that do the heavy lifting in instrumentation technology, that day could arrive earlier rather than ...


    By Hardy Process Solutions

  • Microturbines, Gas Engines Link Biogas to the Grid

    OPPORTUNITIES to produce electricity from methane are being improved continuously as manufacturers introduce new and upgraded equipment to address market needs and varying characteristics of raw biogas. In the renewable energy from organics recycling arena, the two primary types of electricity generation equipment are microturbines and reciprocating gas engines. This article provides a brief ...


    By BioCycle Magazine

  • Sustainable wastewater separation treatment systems coupled with nutrient and water reducing greywater reuse technologies

    Nationally and internationally, pressure is increasing to introduce nutrient reducing, water conserving and recycling measures for sustainable residential and small community water/wastewater systems. Reports of inadequate water quality and quantity are being reported daily. Over the past thirty years the federal government and State of Alaska have invested over 4 billion dollars installing piped ...


    By Equaris Corporation

  • Water quality is key to the success of Cardiff Bay

    Water quality has been a central theme in a redevelopment project that began with the creation of the Cardiff Bay Development Corporation in April 1987. This article will examine the role that water quality has played in the remarkable transformation that has taken place in Cardiff and explain how monitoring technology has developed to the stage whereby any person, anywhere in the world, can view ...

  • Renewable energy marketplace

    ALLU Group markets two types of equipment for use in biomass energy operations. The ALLU Screener Crusher bucket attaches to a front-end loader. The bucket is designed to aerate, crush, screen and mix at one time. The Screener Crusher has a rigid steel frame, onto which horizontally rotating screening and crushing drums are mounted. All the drums rotate in the same direction. There are several ...


    By BioCycle Magazine

Need help finding the right suppliers? Try XPRT Sourcing. Let the XPRTs do the work for you