laboratory gas generator manufacturer Articles

  • Divestment of a food manufacturing plant

    Client: Confidential Location: Somerset, Southwest England, UK Services: Strategic Advice on Brownfield Development, Site Investigation, Risk Assessment Summary: ESI was able to identify options for managing land contamination to maximise the value of site divestment, based on high quality site investigation and risk ...

  • Manufacturers face challenges with pharmaceutical impurities

    Pharmaceutical manufacturers may face various challenges when attempting to meet the United States Pharmacopeia (USP) requirements for residual solvents (volatile organic chemicals).Residual solvents in pharmaceuticals are trace level impurities of volatile organic compounds in final products or excipients. In general, residual solvents originate from manufacturing processes related to the ...


  • BTEX monitor, equal performances to laboratory chromatographs

    Environnement S.A leveraged its technical leadership in this field with an extensive experience, being one of the first companies creating its first BTEX analyser almost 20 years ago. The VOC72M third generation of ...


    By Environnement S.A

  • METH: THE NEW MOLD - New Markets in Clandestine Laboratory Clean-up

    Untitled Document Intro Clandestine labs have become prevalent across America. They are used for the ...


    By EMSL Analytical, Inc.

  • Materials Testing Laboratory Provides Cutting Edge Contamination Testing Solutions

    Many industries have extremely tight parameters for any contamination of parts that are used in their manufacturing process.  Testing for contamination and quality control is an integral part of these companies’ final products. At EMSL Analytical, the Materials Testing Laboratory has extensive experience in providing highly detailed analytical services to assist manufacturers in ...


    By EMSL Analytical, Inc.

  • Sample Handling Strategies for Accurate Lead-In-Soil Measurements in the Field and Laboratory

    ABSTRACT The inhomogenous lead-in-soil matrix can present serious obstacles to accurate sample collection and handling. In typical lead-in-soil measurement, particle size related errors in sampling and sample handling often exceed all other sources of error. The magnitude of error can vary widely depending on the particulate nature of the lead contaminant and the effectiveness of control ...

  • PureAire Makes Oxygen Monitor for Nitrogen Generators

    Nitrogen generators are most commonly used in areas where on-demand nitrogen is preferred rather than, storing liquid nitrogen (LN2) in cylinders.  Nitrogen generators have a lower cost of operation, and can be used where smaller amounts of nitrogen are needed. Nitrogen generators are used in the pharmaceutical industry, testing laboratories, cryogenic facilities, welding manufactures, and ...

  • Case study - ElectraTherm generates power from low temperature geothermal

    Site: Florida Canyon, Nevada, USA Gross Power Output: up to 75kWe Hot Water Input Range: 225-230F Hot Water Flow: 150 GPM Thermal Heat Input: 660kWt Air Cooled Condenser ElectraTherm successfully commissioned its Green Machine at the Florida Canyon Mine in Imlay, Nevada. ElectraTherm marked the occasion at Florida Canyon Mine with a commissioning ceremony including officials ...


    By ElectraTherm

  • Microturbines, Gas Engines Link Biogas to the Grid

    OPPORTUNITIES to produce electricity from methane are being improved continuously as manufacturers introduce new and upgraded equipment to address market needs and varying characteristics of raw biogas. In the renewable energy from organics recycling arena, the two primary types of electricity generation equipment are microturbines and reciprocating gas engines. This article provides a brief ...


    By BioCycle Magazine

  • Environics - Reducing calibration gas cost by up to 60%

    EPA's appendix 'M' 40 CFR 51 reduces calibration gas cost by 60%By: Terrence P. Dunn, President of EnvironicsOn May 30, 1995, the EPA published the final version of Method 205 for inclusion in Appendix M of 40 CFR Part 51 entitled, 'Verification of Gas Dilution Systems for Field Instrument Calibrations.' Continuous emissions monitoring systems (CEMS) require ...


    By Environics, Inc.

  • Chlorine Dioxide gas detection: A comprehensive guide

    Introduction Some years agoago, the bleaching process in the paper industry was changed from using Chlorine (Cl2) as bleaching agent to Chlorine dioxide (ClO2). This was a challenge forThis posed a major challenge to industrial hygienists, as there were no sensors or detectors available that were specific to Chlorine dioxide: There was no sensor technology for gas detectors available that ...

  • A Guide to Gas Detector Tubes. Your Questions Answered

    Gas detector tubes are easy to use, are low cost, and the method is intrinsically safe, allowing it to be deployed in all industries. Because detector tubes don’t require calibration, users see the benefits of this technology over electronic gas detectors due to their ease of ...


    By a1-cbiss

  • Primary Standard Gas Flow Calibration—The Only Guarantee of Accuracy

    At Sierra, we have a saying: “An instrument’s accuracy is only as good as its calibration.” The accuracy of your mass flow controller (MFC) is essential in assuring the efficiency, performance, and quality of your flow meter. In many cases, if your instrumentation is not calibrated, then a decline in performance is possible due to ...


    By Sierra Instruments, Inc.

  • Columbus, Georgia`s High-Efficiency, Low Cost, Digester-Gas-Fired Power Plant

    ABSTRACTGrowing concern over the cost of power and long-term availability of limited fossil fuel resources for the production of electricity have caused electrical utilities and governments to promote “green” or renewable power. Solar, wind, geothermal, biomass, biogas, and low-impact hydroelectricity are current acceptable green-power sources. Digester gas is a renewable, green energy resource ...

  • Not All Hazards are the Same: Design considerations for matching flame and gas hazards to detector technologies

    Not all flame and gas hazards in facilities are the same, therefore the detection technology chosen should be specific to the type of hazard to be detected. How do users select technologies to see certain fires or detect certain gases? The intent of this paper is to give a broad introduction to the selection and use of flame and gas detector technologies. We will answer questions such as these: ...

  • Success story: How we solved the bench space equation in a lab!

    Problem Overview Nowadays laboratories are equipment intensive and require as much bench space as possible. Recently, our company has being challenged by a lab manager of a primary Italian food industry to find a solution for his saturated lab bench. Among several devices, about 13 GC-FID’s are working with several gas generators. The initial choice for having on-site gas ...


    By LNI Swissgas

  • Mobile Stationary Source Emissions Testing, Coming to a Facility Near You?

    Last week, Antea Group had the unique opportunity to perform a RATA (relative accuracy test audit) of the emissions from a thermal oxidizer at an ethanol production facility located in Minnesota using a state-of-the-art mobile testing laboratory. During this RATA audit, actual stack emissions levels (including NOx, SOx, CO2, CO, O2, flow rate, temperature, velocity and pressure) from the ...


    By Antea Group - USA

  • Unmanned remote and wireless CDM monitoring case study

    Remote and wireless monitoring technology to meet CDM requirements is in its infancy in Europe. Carbon trading is driving it globally, especially in North and South America. That experience and technology is now finding a demand in Europe and Asia in landfill, biogas from food and animal waste in digesters and water treatment sludge digestion. Methane recovery from landfill and anaerobic ...


    By Geotech

  • OTM 17: Determination of Metal Concentrations Using Filters and Solid Sorbents in XRF Analyisis case study

    Eli Lilly and Company (Lilly) operates a waste incineration system located at the Tippecanoe Laboratories in Lafayette, Indiana. This incinerator system includes an Xact multi-metals continuous emissions monitoring system (Xact-CEMS, manufactured by Cooper Environmental Services, LLC) for demonstrating attainment with the Hazardous Waste Combustor MACT for semi-volatile metals, low-volatile ...


    By Cooper Environmental

  • Borosilicate Glass: A brief history

    From the laboratory standpoint, there are three main tyeps of glass used today; borosilicate, quartz and soda lime or flint glass. What is borosilicate glass, how is it different from other glasses, and why is it used so widely in laboratory research?  The formation of glass and glass products goes back to the beginnings of recorded history. The invention of borosilicate glass is usually ...


    By Ace Glass, Inc.

Need help finding the right suppliers? Try XPRT Sourcing. Let the XPRTs do the work for you