laser gas monitor Articles

  • Laser gas detector systems for greenhouse gas emissions monitoring

    Two types of portable laser based gas detector for measuring emissions of the greenhouse gases carbon dioxide (CO2) and methane (CH4) from oil and gas operations are described. A scanning open path detector was developed within a Cooperative Research and Development Agreement (CRADA) with the USEPA. This system scans multiple paths across an area source in rapid succession, enabling calculation ...


    By Boreal Laser Inc.

  • Improved HF monitoring in Primary Aluminium Smelters with Laser Gas Detectors

    Primary aluminium smelting generates large amounts of hydrogen fluoride gas (HF). Concerns for worker safety and ambient air quality require that HF be monitored at several locations in smelters. Historically, a variety of methods have been used for HF monitoring. Cassette samplers and wet chemistry techniques, coupled with complex and expensive ...


    By Boreal Laser Inc.

  • Portable laser gas detector systems for landfill CH4 and CO2 monitoring

    There has recently been a marked increase in interest in detecting and quantifying emissions of the greenhouse gases (GHG) carbon dioxide (CO2) and methane (CH4) from landfills in North America and Europe. The primary drivers for this increased interest are: new and pending legislation requires demonstrated reductions in GHG emissions; permits to expand existing facilities require more accurate ...


    By Boreal Laser Inc.

  • Laser gas detection is now cheap, fast and reliable

    Laser based gas detectors are now being used in a wide variety of applications for process and quality monitoring, and safety and environmental compliance. The reasons are that laser detectors are more reliable and less expensive than alternative solutions. Laser detectors combine semiconductor tunable diode lasers (TDL) and optical fibres developed by the telecommunications industry with ...


    By Boreal Laser Inc.

  • New laser-based dust emission monitoring system

    Abstract A new generation of continuous particulate matter concentration monitoring instruments is presented, covering a measuring range of 0 to 1000 mg/m3. The laser-based scattered light instrument gives an improved stability as well as excellent resolution in the low range. This enables high concentration measurement as well as especially low emission monitoring down to 0.01 mg/m3 with a ...


    By Sigrist-Photometer AG

  • Introducing LaserGas III SP CO – a combustion analyzer for rough environments

    NEO Monitors unveils the industry’s most compact CO combustion analyzer suitable for the most demanding environments. LaserGas III CO includes measurement of CH4, H2O and temperature in one single unit designed to reduce risk. Based on decades of experience and customer feedback, NEO Monitors has designed an Ex-d certified tunable diode laser (TDLS) analyzer. The instrument is ...


    By NEO Monitors AS

  • Low level moisture measurement in Natural gas using a Lunable diode laser absorption spectroscopy (tdlas) based laser case study

    Introduction The measurement of water vapor in natural gas has long been of industrial importance, and has been addressed by a variety of analytical techniques over the years. Chief among these techniques has been the quartz crystal microbalance (QCM) based analyzers. The QCM technology is still the workhorse for production and pipeline applications, and the technique is considered by most ...

  • Case study - Monitoring landfill gas

    Infrared absorption Infrared absorption is usually the preferred method for measuring methane and carbon dioxide. Most gases absorb radiation in the infrared region. The wavelength of radiation that is absorbed is determined by the natural vibration frequencies of the molecule. These natural frequencies will depend on several factors. Thus different gas molecules have different natural ...


    By Geotech

  • FTIR gas monitor for diverse applications

    QUANTITECH, a leading supplier of environmental monitoring instrumentation, has recently supplied EURO Environmental Services in Ireland with a transportable Gasmet FTIR multiparameter gas analyser which EURO Environmental's Managing Director Geoff Fitzpatrick says, “is proving invaluable in many varied applications across a broad selection of industries.” With headquarters in Drogheda in Ireland ...


    By Quantitech Ltd

  • Greenhouse gas emissions and reduction studies using a portable TDL gas monitor

    Boreal Laser's GasFinder is a portable open path gas monitor based on laser technology. GasFinder is uniquely suitable for studies of greenhouse gas emissions. It is specific to the gas of interest, provides one second response and has a broad dynamic range. GasFinder is permanently calibrated and is very small and light (less than 5kg). Alignment is easy and stable. No on-site electronic tuning ...


    By Boreal Laser Inc.

  • A Comparison of Point Sensors and Open Path Monitors For Toxic Gas (esp. HF) Monitoring

    Point Sensors Ion Mobility Spectroscope (IMS) – a gas sample is ionized by a radioactive source (Ni63). Differences in ion drift under the influence of an applied electric field produce a spectrum that is dependent on the mass, charge, and shape of the component ions. The detector signal and strength is tuned to the drift time of the ion of interest (in this case HF) and signal strength is ...


    By Boreal Laser Inc.

  • Safety Monitoring in HF Alkylation Units

    How GasFinder works Boreal Laser’s GasFinder & GasFinder MC are open-path gas detectors that use an integrated transmitter/receiver unit and a remote, passive retro-reflector. In GasFinder (see below) the transceiver also houses the laser diode, drive electronics, detector module and micro-computer subsystems. The transceiver unit is contained in an IP65 enclosure and has connectors for power ...


    By Boreal Laser Inc.

  • The Application of a Laser Based Open-Path Spectrometer for the Measurement of Fugitive Emissions and Process Control.

    ABSTRACT In this paper examples of field operations are presented explaining the application of a new laser based spectrometer and incorporating real-time dispersion modeling techniques to measure fugitive emissions from land fills, gas processing facilities, chemical plants, aluminium smelters, etc. Whilst open-path FTIR spectrometers can measure a variety of gases, ...


    By Boreal Laser Inc.

  • TDLAS Gas Detection Instrumentation

    PKL Technologies Inc. manufactures tunable diode laser (TDLAS) based gas detectors and monitors. Spectra-1 open path gas sensors are used in a variety of environmental and safety remote sensing applications. Spectra-1 gas sensors have been designed in a compact, easy to use, robust and portable format. Spectra-1 has been developed using proprietary hardware and software, to produce a low cost ...


    By PKL Technologies Inc.

  • Continous Emission Monitoring (CEMs)

    Presented in Track B1: CEMs at EUEC 2011,January 31 Phoenix, Arizona   B1.1  | Particulate CEM for wet FGD plant William Averdieck |  Managing ...

  • High sensitivity CO2 monitor for CO2 geological sequestration efficiency monitoring

    Canadian prosperity is currently linked to revenue generated from processes that produce large volumes of greenhouse gasses as a by-product. Under evidence that the human fingerprint on our planet is in direct correlation to global climate change, the monitoring and control of greenhouse gas emissions has become a subject of recent focus among many sciences. Recently, legislation has been imposed ...


    By Boreal Laser Inc.

  • Complete HF Monitoring Solutions for Primary Aluminum Smelters

    Aluminium smelting generates large amounts of hydrogen fluoride gas (HF). Worker safety and ambient air quality concerns require that HF be monitored at several locations in smelters. Historically, a variety of methods have been used for HF monitoring. Cassette samplers and wet chemistry techniques, coupled with complex and expensive sampling manifolds have monitored roof-line and scrubber duct ...


    By Boreal Laser Inc.

  • Argon Gas, 3D Printing, and How to Stay Safe

    For the average person, Argon gas is not a topic of daily conversation, or, for that matter, any conversation, ever. It may be surprising to learn that argon is the third most common gas in the earth’s atmosphere, though most people know little about it. The word argon itself comes from a Greek word meaning ‘inactive’ because of its lack of chemical reactions. Argon is ...

  • Total solution: Gas and particulate analysis in Cement industry

    Cement plants are increasingly required to install continuous emission monitoring systems (CEMS). While these represent a significant financial outlay, a range of other factors also need to be considered when selecting a suitable CEMS. To the inexperienced, selecting a suitable CEM can mistakenly be considered as simply ensuring that the applicable national regulations (eg MACT in the USA, ...


    By Environnement S.A

  • Global solution: Gas and particulate analysis in Cement industry

    Cement plants are increasingly required to install continuous emission monitoring systems (CEMS). While these represent a significant financial outlay, a range of other factors also need to be considered when selecting a suitable CEMS. To the inexperienced, selecting a suitable CEM can mistakenly be considered as simply ensuring that the applicable national regulations (eg MACT in the USA, ...


    By Environnement S.A

Need help finding the right suppliers? Try XPRT Sourcing. Let the XPRTs do the work for you