liquid-solid separation system Articles

  • Separation

    Introduction: Ex situ separation can be performed by many processes. Gravity separation and sieving/physical separation are two well-developed processes that have long been primary methods for treating municipal wastewaters. Magnetic separation, on the other hand, is a much newer separation process that is still being tested. Gravity Separation Gravity ...

  • Solid / gas separation with fabric filters

    A myriad of filter media are utilized today for separation of particulate matter in industrial gas filtration applications. These media range from single use (deposable) to semi-permanent media and include fiber, fabric, ceramic, membrane, metal mesh, and sintered metal media. Semi-permanent media are usually cleanable, either on or off-line, and are primarily intended for long-term (up to ...

  • Electrokinetic Separation

    Introduction The principle of electrokinetic remediation relies upon application of a low-intensity direct current through the soil between ceramic electrodes that are divided into a cathode array and an anode array. This mobilizes charged species, causing ions and water to move toward the electrodes. Metal ions, ammonium ions, and positively charged organic compounds move toward the cathode. ...

  • Fundamentals of Multi-Sensor Separation Systems

    This paper gives an overview of the research at the Delft University of Technology in the field of automatic quality control and sorting systems, which are applied for solid bulk materials in the recycling industry. From theory it is known that a simultaneous detection of several features with sensors of different detection principles improves the quality of the classification dramatically. ...

  • Separation principle of decanting centrifuge

    KOSUN DC series decanting centrifuge is used in separating suspension of solids phase with particle diameter(d≥2μm) for drilling mud and fluids handling. Ruggedly built for oilfield and industrial services, it is especially effective in environmentally sensitive areas. It delivers high fluid-recovery rates and ...


  • Oil Water Separator Maintenance

    Oil water separators (OWS) can be co$tly to maintain, $20,000 or more on average per cleaning and if not properly managed, can be very expensive conduits of pollution. Have you taken steps to minimize the effects and consequences on your operating co$t? When was your facility’s last OWS maintenance ...

  • Innovation in Offshore Separation Process

    CLOV is a deep-sea oil production project offshore Angola. Sulzer helped to lower the cost of the floating production, storage, and offloading (FPSO) ship. There, Sulzer’s patented distributor technology and state-of-the-art pumps are brought to life by Total’s innovative wash tank process. This combination achieves significant cost savings on the FPSO design. With a processing ...


    By Sulzer Management Ltd

  • Supported liquid membrane system for Cr(III) separation from Cr(III)/Cr(VI) mixtures

    This paper presents the results of analyses of the chromium(III) transport process from mixtures of Cr(III)/Cr(VI) ions using supported liquid membranes (SLM), in which dinonylnaphthalene sulfonic acid (DNNSA) and di(2-ethylhexyl) phosphoric acid (D2EHPA) were used as carriers. In both cases the membrane worked as a selective barrier for Cr(VI) ions. The increase in both the time of Cr(VI) ...


    By IWA Publishing

  • Source Separated MSW Composting in the US

    MUNICIPAL solid waste composting projects are being launched based on residential separation of the compostable stream from recyclables and trash - quite widespread in Europe and increasingly in Canada. One trend - typically in cities and suburban communities - is to add source separated residential organics to existing yard trimmings collection programs. Composting facilities permitted to ...


    By BioCycle Magazine

  • Liquid-phase non-thermal plasma-prepared N-doped TiO2 for azo dye degradation with the catalyst separation system by ceramic membranes

    This study strived to improve the photocatalytic activity by using liquid-phase non-thermal plasma (LPNTP) technology for preparing N-doping TiO2 as well as to separate/recover the N-dope TiO2 particles by using ceramic ultrafiltration membrane process. The yellow color N-doped TiO2 photocatalysts, obtained through the LPNTP process, were characterized with UV–Vis spectroscopy, X-ray diffraction ...


    By IWA Publishing

  • Monroe Parallel Plate Modules increase oils and solids removal in existing API Separator

    Challenge A silicone manufacturing plant was increasing capacity production and needed to increase the processing of the accompanying wastewater stream containing tramp oils and solids. If possible, the plant wanted to increase the efficiency and capacity of two existing 140,000-gallon API Separators to handle the additional wastewater. The plant required that the water be clean enough to ...

  • Simple design criteria and efficiency of hydrodynamic vortex separators

    Vortex separators still draw attention from specialists investigating the process of removing particles suspended in liquids. The devices are locally applied for waste water treatment in different systems – from storm waste water sewerage to water circulation in fish ponds. However, the methods for separator design presented in the literature are questionable. The paper presents two ...


    By IWA Publishing

  • Air Separation Plants and the Use of Oxygen Monitors

    Air separation plants are critical for many different industries, from clean energy to manufacturing. Nowadays, cryogenic is the most common type of distillation used to separate air into its component gases - nitrogen, oxygen, and inert gases including helium and argon. If your industry relies on air separation for product development or manufacturing, then knowing how the process works is ...

  • Possibilities of chromium (III) separation from acid solution using the double-carrier supported liquid membrane (DCSLM)

    This paper describes the problem of recovery and reusing chromium from aqueous solutions. The authors studied a novel double-carrier supported liquid membrane system (DCSLM) with di(2-ethylhexyl) phosphoric acid (D2EHPA) and bis(2,4,4-trimethyl) phosphinic acid (Cyanex272) as a carrier of Cr(III) ions as a method to separate chromium (III) from acid solutions. As a result, they confirmed that ...


    By IWA Publishing

  • Membranes and theoretical modelling of liquid–gas membrane separation for aromatic compounds removal from water: a review

    Liquid–gas membrane separation techniques - namely, vacuum membrane distillation, membrane air–stripping/sweeping and pervaporation - are non–equilibrium membrane separation processes emerging for the removal of aromatic compounds from industrial wastewater and polluted ground waters. This review focuses on polymeric hydrophobic membranes which are commonly employed in the liquid–gas membrane ...


    By Inderscience Publishers

  • Simple Separation: Diverting Wood And Cardboard at Construction Sites

    Diverting Wood And Cardboard At Construction Sites Residential home construction in Wisconsin generates 128,000 tons of residuals annually, according to a 1998 study by Camp, Dresser & McKee. Ten builders are participating in a project to demonstrate how easily major components of this waste stream can be recycled. The Metropolitan Builders Association (MBA) of Greater Milwaukee, the ...


    By BioCycle Magazine

  • Packed Cyclone Separator Removes Dust Particles While Recycling Process Liquids; New Solutions to Plant Problems

    Problem: The Monomeros Colombo Venezolanos plant in Barranquilla, Colombia, jointly operated by the South American countries of Colombia and Venezuela, produces caprolactam for the textile industry and various chemical fertilizers for agricultural use. Recently agricultural plant capabilities were increased with the addition of process units to improve the production and quality ...


    By CR Clean Air Group, LLC

  • Mud desanders and desilters used in solids control system

    Mud desander is the second stage in the operation of drilling solid control equipment, commonly used is 10"and 12" cyclones. Oilfield mud desander is mainly used for the separation of solid particles in drilling fluid to particle size 45-74 microns in diameter. According to the processing capability, the ...


  • Oil Water Separator - Klargester has a specialist team who provide technical assistance in selecting the appropriate Separator for your application

    Klargester Separators - EN858 compliant, with full Environment Agency Approval (PPG3) To specify a nominal size Klargester Bypass Separator, the following information is needed:- The calculated flow rate (NS) or the drainage area served. Our designs are based on the assumption that any interconnecting pipework fitted elsewhere on site does not impede flow into or out of the separator ...


    By Kingspan Environmental Ltd

  • Particle separation from road runoff by a decentralised lamella system – laboratory tests and experiences in the field

    A new decentralised settling system based on the principle of lamella separation was developed for the treatment of road runoff. Two different laboratory test methods, the DIBt (Deutsches Institut für Bautechnik) procedure and our own approach, were applied in order to evaluate the efficiency of the system based on the separation of fine mineral particles and a mixture of mineral and organic ...


    By IWA Publishing

Need help finding the right suppliers? Try XPRT Sourcing. Let the XPRTs do the work for you