low calorific gas Articles

  • Low Pressure Separation Membrane: Purification Of Landfill Gas

    Summary: The paper is presenting preliminary results of the on-site trial of the gas purification pilot plant based on membrane separation technology, operating at relatively low pressure- This trial is an initial phase of a bigger project aiming at production of clean and high calorific value gas that could be used as a substitute of fossil fuel. e.g. for powering vehicles. The objectives of the ...


    By Biogas Technology Limited

  • Biofuels Gas Monitoring

    The Customer The Company is one of the world’s leading developers and producers of advanced fuels and green chemicals. The Process The Company uses a gasification process that breaks down wood chips, waste and other feedstock using plasma technology. The process produces a uniform synthetic gas (syngas) that is used to power their turbine engines. ...

  • Natural Gas: Complete Analytical Solution

    Chromatotec® has developed in its Research & Development laboratories, a new instrument for hydrocarbon (C1-C6+) measurements and calorific values as well as WOBBE index computation. This analyzer is based on chromatography principle using a Thermal Conductivity Detector (TCD). The sample will be separated into the column and quantified by the detector. A difference of thermal ...


    By Chromatotec Group

  • Removal of ecologically harmful pyrolysis gas and vapours

    Type     HOFGAS®- IFM4c/1000 Commissioning     August 2002 Site     Waste water treatment plants Situation As a result of new authority requirements, Romag AG set up operation of a plant for the drying and gasification of wastewater sludge. Drying vapours are formed during the sludge drying and pyrolysis gas during gasification. These emissions must be burned in an ecological way, ...


    By Hofstetter BV

  • Biomethane enters the gas grid article for energy world

    The Carbon Plan, published in 2011, aims to reduce UK carbon emissions by a quarter from 1990 levels. With the current policies in place, the UK is on target to reduce emissions by over a third by 2020 and with the introduction of new technologies this should increase to an 80% reduction by 2050. However, currently around half the UK’s carbon emissions result from heat related processes and ...


    By CNG Services Limited

  • An advanced oxidation process using ionized gas for wastewater treatment

    This study on removing non-degradable materials in wastewater focused primarily on advanced oxidation methods such as ozone, ozone/UV and ozone/H2O2. Wastewater treatment using an ionized gas from plasma has been actively progressing. The ionized gas involves reactive species such as O2+, O2− cluster, O radical and OH radical. Since the ionized gas method has such outstanding characteristics as ...


    By IWA Publishing

  • Gas blending process adopts CVA for improved accuracy, economy and environmental performance - Case Study

    Overview Rotork’s innovative CVA electric control valve actuator technology has successfully delivered an improvement in performance with reduced operating costs for the vital gas blending process on a European natural gas distribution network. The Reason Fluxys is the independent operator of the natural gas storage and transmission system in ...


    By Rotork

  • Thermophysical characteristics of the biomass tar from a crop stalk gasification system

    Presently, the biomass gasification and centralised gas-supply system fed by crop stalks is still at the stage of development and research in China. The purifier of the system has some problems such as huge device, low purifying efficiency, and poor disposal of tar causing secondary pollution. For this reason, the distillate range, calorific value, ignition temperature, flash point and viscosity ...


    By Inderscience Publishers

  • Transformations of syngas derived from landfilled wastes using the Gasplasma process

    Abstract The Gasplasma advanced conversion technology is able to efficiently produce a clean syngas and an environmentally stable vitrified product from historically landfilled materials. The syngas is rich in hydrogen and carbon monoxide and possesses high calorific value, and low residual tar levels. While this syngas has traditionally been considered only as a fuel source for power ...


    By Advanced Plasma Power (APP)

  • Environmentally safe combustion of corrosive solvents

    Type     HOFGAS®- IFM4c/350/100 Commissioning     2002 Site     EMS DOTTIKON (Dottikon, CH) Situation By September 2002 EMS Dottikon AG had started the operation of the new production plant for pharmaceutical substances. As a result of the drying process 0..100Nm³/h off-gas is expelled batch wise. The main compound is ...


    By Hofstetter BV

  • Practical guide to alternative fuel utilisation

    Today’s business environment for the cement producers is becoming more challenging. Rising production costs and environmental regulations are only two of the main limiting factors. Therefore the cement industry is using alternative fuels. In most cement kiln processes today, the conventional fuels (primary fuels) are gas, fuel oil, various coals and petcoke. The required calorific values can be ...

  • Case study - Environmentally friendly vapor combustors, flares and incinerators

    Today’s industry requires innovative, cost competitive solutions to meet the ever growing and changing needs in the market. ABUTEC has developed a full line of “Environmentally Friendly” Vapor Combustors, Flares and Incinerators to meet these demands. The HTF (High Temperature Flare) and MTF (Medium Temperature Ground Flare) offer a flexible and scalable solution to clients in a ...


    By ABUTEC LLC

  • AVA Technology for Hazardous Waste Treatment - Case Study

    AVA has developed systems for pre-treating hazardous waste prior to incineration, which leads to higher throughput performance in combination with lower construction and maintenance costs and additional low pollution emissions, in comparison to conventional techniques. The system is based on the principal that constant gross calorific values and regular piece sizes together with consistency of ...


    By AVA - Huep GmbH u. Co. KG

  • CHP efficiency for biogas

    Combined heat and power plant efficiency is a function of the conversion efficiency of the energy in the fuel gas to useful energy in the form of electricity and heat. A combined heat and power (CHP) plant is typically a reciprocating gas engine that uses the energy in the gas to drive a crank shaft. The crank shaft turns an alternator to ...


    By Clarke Energy

  • Impact of CO2 Emission Trading Schemes on Residual Waste Management

    ABSTRACT The EU-Emission trading scheme (ETS) in its current design hardly affects residual waste management directly: methane from landfill-sites is not included although it is one of the “Green-House-Gases” (GHG) of the Kyoto Protocol, CO2-emissions from waste incineration plants are generally exempted from the regulation of the directive and emissions from combustion of landfill-site gas can ...


    By ORBIT e.V.

  • Bolivar wastewater treatment plant cogeneration facility to be Installed by Clarke Energy - Case Study

    The Bolivar Wastewater Treatment Plant (WWTP) is the largest wastewater treatment plant in the Adelaide region, processing almost 70% of Adelaide’s metropolitan wastewater. The South Australian Government has approved a $25.8 ...


    By Clarke Energy

  • Refuse Derived Fuel, Current Practice and Perspectives

    Untitled Document Summary I OBJECTIVES The objectives of the project were to undertake a survey on the current ...

  • High density polyethylene (HDPE) pyrolysis plant

    Thermal degradation of plastic polymers is becoming an increasingly important method for the conversion of plastic materials into valuable chemicals and oil products. In this work, virgin high-density polyethylene (HDPE) was chosen as a material for pyrolysis. A simple pyrolysis reactor system has been used to pyrolyse virgin HDPE with an objective to optimize the liquid product yield at a ...

  • CEMS: An Overview

    We've written an overview to where CEMS are required, types of site that require CEMS and future requirements. Continuous Emissions Monitoring Systems are used to continuously collect, record and report data from industrial process operators that produce emissions to air. CEMS are used as a means to comply with ...


    By a1-cbiss

  • Study Charts a Future for Waste-Derived Fuels

    Pointers to possible future EU policy initiatives to give co-incineration facilities burning waste-derived fuels a strategic role in waste management have emerged in a study for the European Commission.1 The report suggests a policy focus on promoting source separation of municipal wastes, active discouragement of mass burn incinerators, and a levelling of the regulatory playing-field for ...

Need help finding the right suppliers? Try XPRT Sourcing. Let the XPRTs do the work for you