low temperature waste heat Articles

  • Marketing Analysis of Low Temperature Waste Heat Boiler

    Environmental pollution brought by the burning of fossil fuels and improper energy use structure have became big problems of boiler manufacturer like ZG. To need the market demand for the development of new energy and renewab ...


  • Seawater desalination utilising waste heat by low-temperature evaporation

    Utilisation of waste heat is one of the ecofriendly ways to produce low-cost desalted water. Keeping this in mind, Low-Temperature Evaporation (LTE) desalination technology utilising low-quality waste heat in the form of hot water (as low as 50?C) or low-pressure steam (0.13 bar) has been developed to produce high-purity water (conductivity ...


    By Inderscience Publishers

  • Utilizing Waste Heat For Power

    Continuous duty gen-sets provide base-load power generation in diverse applications around the globe. However, high fuel costs and engine maintenance are pain points felt by operators. A low-maintenance path to significant fuel savings and lower emissions is what the U.S. Department of Defense (DOD) had in mind when they approached ElectraTherm to integrate the company’s Green Machine waste ...


    By ElectraTherm

  • 100 Simple Ways To Save Water

    To improve water conservation install a rain sensor, it turns off your irrigation when it rains. Use a weather-based controller. The use of smart controllers can reduce water usage 24% a year on average. Learn about available rebate programs ...


    By Jain Irrigation, Inc

  • Low temperature microwave and conventional heating pre-treatments to improve sludge anaerobic biodegradability

    This paper presents the results of lab-scale experiments on low temperature thermal pre-treatment (less than 100 °C) prior to anaerobic digestion of sewage sludge. Two heating ways, microwave heating (MH) and conventional heating (CH), and two types of sludge, primary and waste activated sludge, were compared under the same experimental conditions. The degree of solubilisation produced by ...


    By IWA Publishing

  • Case study - Waste heat generates steam and savings

    OVERVIEW A coil coating facility purchased a new a 15,000 SCFM Regenerative Thermal Oxidizer (RTO) which had a nominal heat transfer efficiency rate of 90% thermal energy recovery. It was designed with supplemental fuel injection (SFI) which is used during low VOC loading conditions, to help save fuel cost.  The facility was looking for additional ways to decrease their exhaust ...

  • Experience feedback on operation of low-temperature vacuum evaporation-based desalination plant integrated with CIRUS

    CIRUS is a 40 MWth, heavy water-moderated, light water-cooled and natural uranium-fuelled research reactor located at Trombay, Mumbai. The reactor has been in operation since 1960 with an average availability factor of about 70% for about three decades. During the early 1990s, the reactor exhibited signs of ageing. It was refurbished and put back into operation at high power in 2003. Bhabha ...


    By Inderscience Publishers

  • Nuclear desalination by waste heat utilisation in an advanced heavy water reactor

    The use of thorium for nuclear power generation is an important element of the Indian atomic energy programme. The design and development of the Advanced Heavy Water Reactor (AHWR) is a step in this direction. Intensive design activity is underway to set up a 300-MWe AHWR. The design of the AHWR incorporates several features to simplify the design and to eliminate certain systems and components, ...


    By Inderscience Publishers

  • Low emission combustion of Oilgas

    Type     HOFGAS®- IFM4c/2300/150 Commissioning     June 2001 Site     Cistierna (ES) Situation Enervisa SA in Cistierna own a plant for the recycling of old oils. The oil is evaporated and condensed into high-grade fuel. The reclaimed fuel is used in diesel engines for production of electricity as well as in burners for the ...


    By Hofstetter BV

  • Case-study - Utilising waste heat for water production and climate control

    Water purification is needed to produce high quality water for consumption, agriculture and industrial needs. Conventional water treatment processes, like distillation and reverse osmosis, consume vast amounts of energy. However, there is a large potential for significant reductions in energy consumption and CO2 emissions in this sector. It can be achieved by the exploitation of waste heat for ...


    By Climate-KIC

  • Performance of the low-emission flare

    Job report / Elbisgraben (Bale / Switzerland) The summer of 1992 had finally arrived. The 5MW low emission furnace in the district heating station Liestal was ignited, supplied with landfill gas from Elbisgraben landfill. Since then the plant has been running continuously and the comprehensive measurements taken, verify that all targets aimed at have been achieved: plant ...


    By Hofstetter BV

  • Heat Pumps – FAQs

    1. What is a Heat Pump? To put it simply; ground source heat pumps and geothermal heat pumps produce high grade heat from low grade heat which is found in the earth and our atmosphere.2. How does a Heat Pump Work?Heat pumps work in exactly the same way as air conditioners or refrigerators, but in reverse! Heat pumps capture latent energy which is stored in sources such as air, water and earth. ...


    By ICS Cool Energy Ltd.

  • Temperature Dependence of Soil Water Potential

    To understand the process of coupled heat and water transport, the relationship between temperature and soil water potential must be known. Two clays, Avonlea bentonite and Lake Agassiz clay, are being considered as the clay-based sealing materials for the Canadian nuclear fuel waste disposal vault. Avonlea bentonite is distinguished from Lake Agassiz clay by its high sealing potential in water. ...


    By ASTM International

  • Using biogas for combined heat and power

    An integral part of the majority of anaerobic digestion facilities across the world is the CHP combined heat and power (CHP) engine. For the first time builder of a biogas plant, it is often neglected as the focus is on reducing the capital costs ...


    By Clarke Energy

  • Using biogas for combined heat and power

    An integral part of the majority of anaerobic digestion facilities across the world is the CHP combined heat and power (CHP) engine. For the first time builder of a biogas plant, it is often neglected as the focus is on reducing the capital costs ...


    By Clarke Energy

  • Combined Heat and Power – Questions and Answers

     1. What are the benefits of CHP for business?   combined heat and power (CHP) is a well-proven technology, recognised worldwide as a cleaner alternative to traditional centralised generation. Its long-term future in the global energy markets is secured by CHP's ability to provide a multitude of financial, ...


    By ENER-G

  • Oxidation characteristics of A588 steel and its applicability to high-heat-load nuclear waste package designs

    The ASTM A588 steel is proposed as the outer wall material for second-generation nuclear waste package designs (Armijo et al., 2006; Kar, 2006). Oxidation weight-gain kinetics was evaluated for the A588 steel by thermal-gravimetric method at a range of temperatures (475°C to 600°C). Isothermal oxidation tests were conducted in dry air. Oxidation at lower temperatures followed parabolic kinetics ...


    By Inderscience Publishers

  • A road map for emerging low-exergy HVAC systems

    An exergy-conscious life cycle costing algorithm was developed. This algorithm establishes a reference tool to compare conventional air conditioning systems with alternative HVAC systems, which can directly operate with low-exergy alternative energy resources. The cost of exergy waste in conventional heating, ventilating, and air-conditioning systems (HVAC) is included in terms of the difference ...


    By Inderscience Publishers

  • Green machine generates power from waste heat at biogas facility in the Czech Republic

    Biogas/Heat-to-Power Application on Two MWM Internal Combustion Engines Site: Brno, Czech Rep. Engine Max Power: 980kWe (currently limited to 900 kWe) Green Machine Gross Power Output Avg:  32-39 kWe Thermal Input to the Green Machine: 375-500kWt Hot Water Input Range: 86 - 92°C Hot Water Flow: 35 m3/hour Ambient Temperature: 0-25°C ElectraTherm’s ...


    By ElectraTherm

  • Case study - Green Machine generates power from waste heat at biogas facility in the Czech Republic

    Biogas/Heat-to-Power Application on Two MWM Internal Combustion Engines Site: Brno, Czech Rep. Engine Max Power: 980kWe (currently limited to 900 kWe) Green Machine Gross Power Output Avg:  32-39 kWe Thermal Input to the Green Machine: 375-500kWt Hot Water Input Range: 86 - 92°C Hot Water Flow: 35 m3/hour Ambient Temperature: 0-25°C Date Commissioned: Q2 ...


    By ElectraTherm

Need help finding the right suppliers? Try XPRT Sourcing. Let the XPRTs do the work for you