mact emission Articles

  • Bionomic Boiler MACT Emission Control Technologies

    Introduction Bionomic Industries' extensive line of field-proven, cost effective wet and dry scrubber and electrostatic technology choices can easily and economically help you achieve compliance with EPA Boiler MACT regulations for hydrochloric acid, particulate or mercury control. Bionomics' wide range of equipment enables selection of the best control technology to remove a specific or ...


    By Bionomic Industries Inc.

  • Proposed boiler MACT sets aggressive emission limits

    On June 4, 2010, U.S. EPA proposed National Emission Standards for Hazardous Air Pollutants (NESHAP) for industrial, commercial, and institutional boilers and process heaters at both major and area sources of hazardous air pollutants (HAP) emissions.  EPA proposed separate rules for units at major sources of HAP emissions (greater than 10 tons per year [tpy] of any single HAP and/or greater ...


    By Trinity Consultants

  • Cementing the PC MACT

    On September 9, 2010, the U.S. EPA promulgated the final amendments to the National Emissions Standard for Hazardous Air Pollutants from Portland Cement Manufacturing Industry (40 CFR 63 Subpart LLL), also known as the PC MACT. EPA’s self-proclaimed “historic” rulemaking includes some important implications for cement manufacturers and other sources that may be subject to ...


    By Trinity Consultants

  • Utility MACT and HAPs

    C 6.1  | The Utility MACT Rule: An Industry Perspective Michael  Rossler |  Manager, Environmental Programs, EEI EPA is proceeding with the Utility MACT rulemaking for coal- and oil-based EGUs. The ...

  • Standing on the MACT Floor

    ABSTRACT Three MACT standards have impacted manufacturing operations at the Boeing Philadelphia site. These standards apply to Aerospace Manufacturing and Rework, Halogenated Solvent Cleaning, and Chromium Anodizing. In order to meet the requirements imposed by the standards, qualifications programs were established and conducted by the Materials and Process Engineering group to approve ...


    By Weston Solutions, Inc

  • To MACT and Beyond case study

    In the 1970s, FMC Corp., a chemical manufacturer headquartered in Philadelphia, began operating a high-efficiency thermal destruction facility to dispose of hazardous liquid wastes at its Baltimore pesticide manufacturing plant. The facility used a thermal oxidizer with a rapid quencher and packed tower scrubber to remove air pollution emissions. The system was upgraded in the early ’80s ...


    By Bionomic Industries Inc.

  • EVALUATION OF STRATEGIES FOR MERCURY MACT COMPLIANCE

    On December 15, 2003, the United States Environmental Protection Agency (U.S. EPA) proposed a rule with two alternatives to permanently reduce mercury (Hg) emissions from power plants. Under one alternative, which is the focus of this paper, the utilities would install controls known as Maximum Achievable Control Technologies (MACT) under section 112 of the Clean Air Act (CAA). The proposed rule ...


    By Trinity Consultants

  • The MACT for petroleum refinery FCCs is a fraud!

    This paper is a continuation of the author's research on the MACT regulation for abating pollution from Petroleum Refinery FCCs in the US. This paper highlights the flaws in the recently promulgated MACT for NSPS and non-NSPS FCC units. It details the inadequacies and the potential for perversity in the New Source Performance Standards (NSPS) that are an integral part of the FCC MACT. It ...


    By Inderscience Publishers

  • EPA Proposed “Franken-MACT” for Utilities

    EPA published the highly anticipated proposed Maximum Available Control Technology (MACT) Standard for the utility sector (40 CFR 63 Subpart UUUUU). When considered together with the growing list of proposed and final rules impacting the utility sector (Transport Rule/Cross-State Rule, Coal Combustion Byproducts Rule, Cooling Water Intake Rule, Regional Haze Rule, revised National Ambient Air ...


    By Trinity Consultants

  • The Area Source Mact/Gact Challenge

    Dozens of new federal rules, regulating over 180 Hazardous Air Pollutants for relatively small sources, present a new and unique challenge for the air pollution profession. Over the past two decades, a large number of federal regulations have been adopted to control Hazardous Air Pollutants (HAPs) originating from a wide range of source categories from the corner dry cleaner to petroleum ...

  • Boiler mact - what the new emissions limits on industrial boilers mean for you

    Generically known as “Boiler MACT”, the new possible industrial boiler limits directly address emissions of Hazardous Air Pollutants (HAPs) from industrial boilers and indirectly address the way that industrial sources operate their boilers. This white paper explains how Boiler MACT affects you and how to maintain operating flexibility while addressing compliance issues. The most ...

  • PC MACT proposal may signal widespread change

    On May 6, 2009, EPA proposed amendments to the National Emission Standards for Hazardous Air Pollutants from the Portland Cement Manufacturing Industry (PC MACT) in response to numerous petitions and court mandates. The proposed revisions present significant challenges to the portland cement industry by establishing a new lower maximum achievable control technology (MACT) floor that would require ...


    By Trinity Consultants

  • Risk Assessment: Refinery MACT 1 and 2

    Section 112(f)(2) of the Clean Air Act (CAA) requires the U.S. EPA to determine for source categories subject to Maximum Achievable Control Technology (MACT) standards whether the emission standards provide an ample margin of safety to protect public health.  This assessment is carried out by the U.S. EPA in a two-step ...


    By All4 Inc.

  • New boiler MACT and affiliated rules proposed

    EPA proposed three related rules (with final rules expected by December 16, 2010), intended to reduce the emission of hazardous air pollutants (HAPs) from industrial, commercial, and institutional boilers and process heaters as well as commercial and industrial solid waste incinerators. Simultaneously, it also proposed a definition of solid waste that could potentially affect some units currently ...


    By Trinity Consultants

  • Proposed Settlement Extends Some MACT Hammer Deadlines

    USEPA and the Sierra Club revised their settlement agreement regarding submittal of Part 2 applications for facilities with affected units in source categories subject to pending Maximum Achievable Control Technology (MACT) standards for Hazardous Air Pollutants (HAPs).**  Under the terms of a November 26, 2002 proposed settlement (which revises the previously proposed settlement), Part 2 ...


    By AECOM

  • Legal lookout: Court sides with EPA on MACT

    On June 6, 2008, the US Court of Appeals for the District of Columbia denied the Natural Resources Defense Council's (NRDC) petition for review of EPA's 2006 national emissions standards for hazardous air pollutants (NESHAP) for the synthetic organic chemical manufacturing industry (SOCMI). Background The NRDC challenged EPA's residual-risk rulemaking and their periodic review of emission control ...


    By Bergeson & Campbell, P.C.

  • The Wait Is Over; The New Boiler MACT Is Here

    The Wait Is Over; The New Boiler MACT Is Here    April 29, 2010 was a busy day for U.S. EPA and marked the culmination of months and years of background effort and planning related to air toxic emissions from boilers.  U.S. EPA has released pre-publication versions of four (4) proposed rules on their website that, when finalized, will impact thousands of ...


    By All4 Inc.

  • MACT Monitoring, Recordkeeping, and Reporting - The Hidden Requirements

    ABSTRACT The maximum achievable control technology (MACT) standards established under the national emission standards for hazardous air pollutants (NESHAPs) of 40 CFR 63 may include easily overlooked, sometimes onerous and questionably appropriate requirements incorporated by reference to the MACT General Provisions of 40 CFR 63, Subpart A. These requirements are easily overlooked during the ...


    By Weston Solutions, Inc

  • Refinery MACT II Compliance – Are We There Yet?

    Refinery MACT II, 40 CFR Part 63 Subpart UUU, was published in Federal Register on April 12, 2002 by the U.S. Environmental Protection Agency (EPA). This rule, as a subpart of the National Emission Standards for Hazardous Air Pollutants (NESHAP), controls hazardous air pollutants from catalytic cracking units (CCU), catalytic reforming unit (CRU), sulfur recovery units (SRU), and bypass lines ...


    By Trinity Consultants

  • Emission Performance Results for a Liquid Waste Incinerator upgraded to meet the HWC MACT Standards

    Abstract Eastman Chemical Company operates three hazardous waste incinerators at its facility in Kingsport, Tennessee, one liquid waste incinerator and two rotary kilns. The air pollution control systems for these incinerators are being upgraded to meet the MACT standard for existing hazardous waste incinerators. The upgraded air pollution control systems include a vertical, rapid-quench ...


Need help finding the right suppliers? Try XPRT Sourcing. Let the XPRTs do the work for you