mechanical sealing system Articles

  • Monitoring vibrations, mechanical seals, and bearings for safety and performance

    With more than 70 years of experience in plastics processing, Switzerland-based Quadrant Group is a leading expert in a wide range of polymer materials and technologies for polymer conversion. In order to maintain a high level of quality in the production process, Quadrant's heat-transfer pumps must work safely and reliably. These pumps are commonly subjected to high loads. At the same time, ...


    By ALLWEILER GmbH

  • Development of a sealing material and robot for automatic socket rehabilitation of grey cast iron pipes in drinking water supply systems

    The project DeWaLoP, led by Vienna Water, aims to develop a robot that is able to apply a sealing system to repair the joint sockets of pressure operating water pipes measuring about 1 m in diameter. To do this, a modification of the sealing material for inner surface application will be developed and a complex robot system will be designed to perform various tasks, such as inspecting, cleaning ...


    By IWA Publishing

  • Exterior coatings producer blends abrasives with no shaft seal wear

    Since its founding in 1987, contractors have applied over 100 million square feet of Master Wall Inc. products — stucco, coatings, and exterior insulation and finish systems (EIFS) — on residential, commercial and industrial buildings. Master Wall founder and president Steve Smithwick says the company's Aggre-flex EIFS system is "one of the most common commercial cladding in the ...

  • An inflatable tunnel seal stops flooding of world`s largest undeveloped uranium mine

    The Cigar Lake Mine, located in the Athabasca Basin of Northern Saskatchewan, Canada, is sitting on the world's largest undeveloped high-grade uranium deposit in the world. Operated and majority-owned by Cameco Corporation, Cigar Lake is expected to eventually provide more than 10% of the world's mined uranium. But to extract the uranium ore, Cameco has to overcome significant technical ...


    By Petersen Products Company

  • Building Sustainable Sanitation Systems

    A low cost system of resource management such as composting toilets is helping to mitigate many of Haiti’s social and ecological challenges. The Caribbean Republic of Haiti — the poorest, most environmentally degraded country in the Western Hemisphere with a population of about 10 million — is a case study in forestry and soil fertility mismanagement. A colonial ...


    By BioCycle Magazine

  • Weigh batching: the benefits of an automated system

    In many plants that batch-blend bulk products, weigh batching is a manual, time-consuming operation in which ingredients are weighed individually before being charged to a blender or other process vessel. A significant number of such plants could benefit from the installation of an automated weigh batching system. For small as well as large operations, an automated weigh batching system can pay ...


    By Flexicon Corporation

  • The design and installation of the gas collection system

    The designer of gas collection plants has the task to fulfill optimally the important criteria: stability of gas quality efficiency of collection economic viability of the plant The stabilisation of the gas quality helps to solve the problem between the uneven gas production of the landfill on the one side and ...


    By Hofstetter BV

  • Crossflow Membrane Filtration High-Purity Water Systems

    INTRODUCTION As the electronics industry continues to provide us with such products as high resolution television, notebook size portable computers and cars with automatic navigation systems, it becomes necessary to produce semiconductors with finer device geometries to allow for efficient placement of more circuits per a given area. This requires increased control of a semiconductor's material ...

  • High-Resolution Site Characterization with Multilevel Systems

    Within the last few years, the U.S. EPA added a new focus area on high-resolution site characterization (HRSC) to their Contaminated Site Clean-Up Information (CLU-IN) website. The U.S. EPA’s definition of HRSC is: “High-resolution site characterization (HRSC) strategies and techniques use scale-appropriate ...


    By Solinst Canada Ltd.

  • New developments of vibratory feeders for large bulk material reclaim systems

    Summary The efficient economical storage, movement, control and blending of large tonnages at coal handling installations such as mines, power plants and port facilities require new and improved designs of vibratory equipment. Environmental and investment impact as well as operational advantages must be considered in the development of any new reclaim system. ...


    By General Kinematics

  • Fully automatic prime/re-priming system handles air/liquid mixtures with ease

    Cornell’s Redi-Prime® system addresses the fundamental requirement of customers to have pumps that are easy to operate, re-prime under lift condition, and eliminate carry-over issues of liquids when priming the pump.  Repriming becomes important when entrainment (due to a snore condition) or vortexing occurs. The vacuum pump is always running, so when the liquid ...


    By Cornell Pump Company

  • Introduction to Decentralized Packaged Wastewater Treatment (PWWT) Systems - PDH Article

    Learning Objectives After reading this article, you should understand: Functions and processes of a decentralized PWWT system; Design considerations of a PWWT system. Overview "Clean water will be the oil of the 21st Century." The accuracy and magnitude of this statement is resonating worldwide. ...

  • Hong Kong Hospital Authority selects IQAir filtration systems for the fight against SARS

    In February of 2003, newspapers began reporting a rapidly spreading atypical pneumonia. Now identified as severe acute respiratory syndrome or SARS, this highly contagious condition is caused by a new coronavirus for which there is no specific antiviral treatment. While the epicentre of the outbreak was China, the disease spread quickly across Asia and to North America (especially Canada) with a ...


    By Commercial Air Filtration

  • Bell & Gossett introduces new hydronic pump selection criteria to maximize system efficiency

    Energy and maintenance expenses account for approximately 75 percent of the life-cycle costs of a centrifugal pump. With a growing emphasis on reducing energy consumption driven by government regulation and businesses seeking operational and financial efficiencies, HVAC system designers are seeking system solutions that maximize efficiencies while reducing costs. To address this demand and the ...

  • Port of London Authority Tidal Monitoring System - POLATIDE 5: Detailed - Case Study

    Introduction: Valeport and OceanWise have designed and delivered a complete tidal monitoring system, including tide gauges, telemetry equipment, servers, databases, system control, data management and display software, to the Port of London Authority. The system was installed in October 2013 and rigorous testing completed in February 2014.  Background: ...


    By Valeport Ltd

  • Pumping at Subzero Temperatures

    Pumping of cryogenic (low-temperature) products is important for many applications, especially in the field of liquefied natural gas (LNG). The Sulzer J-unit is a special sealing system for cryogenic pumps. It was invented more than 60 years ago. The evolution of the J-unit design since then has been impressive and has now resulted in a recently filed patent application by Sulzer. ...


    By Sulzer

  • Pumps are the heart of heat-transfer plants

    Manufacturers in a variety of industries depend on heat-transfer plants to heat or cool their machines and apparatus. German firm heat11 GmbH & Co. KG specializes in heat-transfer plants of virtually all types. The chemical industry uses their installations for controlling the temperature of reactors and during the production of color pigments and liquid crystals. In the plastics industry, ...


    By ALLWEILER GmbH

  • Processing technology for radioactive wastes

    For 20 years now, AVA has been delivering innovative mixers, dryers, and systems for environmental and processing technologies. The treatment of highly contaminated materials has always been one of our core competencies. For more than 10 years, AVA Technology has been applied for the processing of radioactive wastes. The application of AVA mixers and reactors may be divided into two main ...


    By AVA - Huep GmbH u. Co. KG

  • Temperature and leak monitoring boosts safety and reliability

    Amcor Flexibles Singen GmbH is a manufacturer of printed and unprinted aluminum-based packaging materials and an experienced technical applications specialist. Its plant in Germany, equipped with rolling mills and finishing equipment, turns out approximately 200 million square meters of aluminum foil in various grades every year. High-performance drying equipment is essential for Amcor’s ...


    By ALLWEILER GmbH

  • Polyurethane Foam/Isocyanate

    Polyurethane Foam/Isocyanate Isocyanate is one of the components in broadly all foam products, such as foam mattresses, inner liners in cars, cushioning in car seats, chairs, and sofas. The hard qualities are used for insulation of houses, machines, tubes, etc. As a matter of curiosity we can also mention the green foam in which flowers for decorations are stuck. There are various ...


    By DESMI A/S

Need help finding the right suppliers? Try XPRT Sourcing. Let the XPRTs do the work for you