mercury discharge requirement Articles

  • Is there mercury in your industrial wastewater discharge?

    An assessment of sampling locations for three industrial wastewater effluent piping systems is presented. The assessments provided demonstrate that by installing sampling ports at the appropriate location along an effluent stream’s piping system, truly representative samples can be collected. These real and accurate results scientifically prove that a specific industrial wastewater ...


    By Practical Applications, Inc.

  • The application of Flow Injection Technology to automating cold vapor MERCURY analyses

    This document describes the application of flow injection technology to cold vapor mercury analyses. It can be obtained from PerkinElmer by requesting method number ENVA-100. Appendices 1 and 2 show letters from the US EPA indicating acceptability through the Alternate Test Program for both drinking water and wastewater sample analysis. 1.0 Scope and Application 1.1 This ...


    By PerkinElmer, Inc.

  • Mercury Removal from Nerve Gas Ton Container Rinse Waters

    IE was retained by a United States Army subcontractor to perform a process determination with analytical verification for the treatment of the rinse water from decontaminated nerve gas agents. The Pentagon Munitions Deconstruction Committee (PMDC) fully reviewed and approved the process developed. The wastewater was generated from the rinsing of 2,000-pound (ton) containers in a punch/drain/rinse ...


    By Integrated Engineers Inc.

  • Remediation of mercury contaminated industrial site for future expansion - case study

    70,000 tons of mercury contaminated soil and building rubble have to be cleaned in an industrial facility in the south of France until 2013. For the realization of this remediation work, an econ industries VacuDry® 12,000 has been in operation since early 2011. After the treatment the mercury free soils can be re-used on-site as building material. A similar but smaller econ industries ...


    By econ industries GmbH

  • Pilot-scale demonstration of the hybrid zero-valent iron process for treating flue-gas-desulfurization wastewater: Part I

    The hybrid zero-valent-iron (hZVI) process is a novel chemical treatment process that has shown great potential in previous laboratory and field bench-top scale tests for removing selenium, mercury and nutrients from various industrial wastewaters. In this study, a pilot-scale demonstration was conducted to continuously treat 3.8–7.6 L/min (1–2 gpm) of the flue-gas-desulfurization ...


    By IWA Publishing

  • Multiple stage scrubbing and adsorption system for Incinerator exhaust at an industrial waste processing plant

    Challenge Monroe Environmental was called upon to purify a 20,000 CFM exhaust stream that was being discharged from an industrial waste incinerator at 2000° F. The pollutants that needed to be removed were: Fine Ash Particulate HCL Gas Mercury Dioxins The combination of soluble and solid pollutants, coupled with the ...

  • Wastewater Metals Removal

    Industrial Wastewater Treatment Success Stories Wastewater Treatment Metals Removal Ton Nerve Gas Agent Container Rinse Waters ...


    By Integrated Engineers Inc.

  • Heavy Metals Water Testing Powered by DNA

    Water pollution is a worldwide problem affecting developing and developed countries alike. Heavy metal contaminants are one prevalent type of water pollutant. They are persistent in the environment once d is charged and removal from source waters is necessary to ensure a clean drinking water supply. The problem of heavy metal pollution arises from several sources. Heavy metals such as uranium can ...


    By ANDalyze

  • Chlor-Alkali Plants Industry - Pollution Prevention Guidelines

    Introduction Pollution Prevention Guidelines to provide technical advice and guidance to staff and consultants involved in pollution-related projects. The guidelines represent state-of-the-art thinking on how to reduce pollution emissions from the production process. In many cases, the guidelines provide numerical targets for reducing pollution, as well as maximum ...


    By The World Bank

  • Minergy GFT Permitting Feasibility Report

    A 39-mile stretch of the Fox River and portions of Green Bay in northeastern Wisconsin (the Fox River site) are contaminated with polychlorinated biphenyl (PCB) laden sediment. The contamination was caused by historical effluent discharges from paper mills manufacturing and/or recycling carbonless paper that utilized dyes dissolved in PCBs. PCBs are the primary contaminant of concern; however ...


    By Minergy Corporation Limited

  • Automated Treatment System Used to Solve a Costly and Environmentally Critical Wastewater Problem for an East Coast Utility

    BACKGROUND Hydrocarbon and particulate contamination in wastewater is a well-known environmental hazard.  Due to tightening environmental regulations, an ever-increasing source of such contamination in major cities comes from water collected from underground utility vaults and manhole water.  This contaminated water, contains a smorgasbord of potential contaminants from transformers, ground ...


    By Walchem, Iwaki America Inc.

  • RoHS Directive: Industry Group Challenges Exemption Recommendations

    A group of industry associations has told the European Union Commission it does not agree with recommendations on how to handle Pack 9 exemptions under the Restriction of Hazardous Substances (RoHS) Directive. The Cross-Industry Project, also known as the Umbrella Project, includes over 34 industry associations around the world. The group submitted their feedback in July 2016, shortly ...


    By Assent Compliance Inc.

  • Dosing and mixing of powdered activated carbon for flue gas applications

    Subject: Powdered activated carbon (PAC) is dosed in dry powder form into flue gas for the removal of dioxins, furanes, mercury and other heavy metals from flue gases. Gericke supplies complete solutions for the handling of bulk solids. These complete installations are characterized by their clean, accurate, trouble- and dustfree operation. Application: Furnaces, incinerators, sinter ...


    By Gericke

  • Phosphate Fertilizer Plants Industry - Pollution Prevention Guidelines

    Introduction Pollution Prevention Guidelines to provide technical advice and guidance to staff and consultants involved in pollution-related projects. The guidelines represent state-of-the-art thinking on how to reduce pollution emissions from the production process. In many cases, the guidelines provide numerical targets for reducing pollution, as well as maximum ...


    By The World Bank

  • Landfill leachate treatment

    Landfills are categorized by regulations in three types: industrial, municipal, and hazardous. Individual landfills may be further differentiated by the types of waste which they accept. All landfills are required to be capped, usually occurring at the end of each day. The cap is typically 6-8” of soil. The cap reduces odor and loss due to wind. At the closing of the landfill, a permanent ...


    By WesTech Engineering, Inc.

  • Activated carbon mat utilized in subaqueous cap on major superfund site case study

    Project: Stryker Bay Location: Duluth, MN Products: GAC Reactive Core Mat® (GAC = Granular Activated Carbon) Background: Stryker Bay was heavily polluted from the late 1800s through 1962. The harbor area was ringed with tar and coke plants, heavy industry and slaughterhouses that all discharged industrial waste into the ...


    By CETCO

  • An Introduction to Bioremediation and its Applications

    A variety of toxic chemicals, metals, and effluents are created and used in industrial processes. These elements need to be degraded to ensure that they do not harm the environment when disposed. A specialized process and equipment are required to perform this task. This is where bioremediation comes in. What is Bioremediation, and what are its Types? In simple ...


    By HPI Processes, Inc.

  • Toxicity Identification Evaluation (TIE) as a Tool for Water Quality Management

    Whole effluent toxicity (WET) testing has evolved into a critical element of many National Pollutant Discharge Elimination System (NPDES) permits issued to both industrial and municipal dischargers. Over 6,500 dischargers to both fresh and salt waters are required to conduct toxicity tests to determine if their effluent might be potentially toxic to organisms in the receiving system. While ...


    By AECOM

  • The Importance of Wastewater Treatment for Your Facility: Is it Necessary?

    Whether you own, operate, or help manage a municipal or industrial facility that deals with wastewater, it’s important to understand how wastewater treatment can play a significant role in the overall health of your business. This is an important part of the process to consider, as ignoring it could earn your company various fines or lawsuits and pose a potential threat to public health. ...


    By SAMCO Technologies, Inc.

  • The Use of Data and Models for Assessing the Equilibrium Partitioning Approach for Analysising Environmental Quality Standards in the Water Column and in the Sediments

    Article 16 of the Water Framework Directive (EC 2000) mandates the European Commission (EC) to select priority substances (PS) and identify priority hazardous substances (PHS) with a provision to review the list of PS at the latest four years after the entry into force of the WFD. Furthermore, the EC has to propose measures to control and reduce point and diffuse sources ...


Need help finding the right suppliers? Try XPRT Sourcing. Let the XPRTs do the work for you