moisture monitoring Articles

  • Why You Should Monitor Groundwater?

    What is groundwater? Groundwater is water that is stored below the earth’s surface. When rain or other sources of water come into contact with the ground, the majority of it travels below the surface. Though much of this moisture is then absorbed by plants or returned to the atmosphere (through infiltration), some water will travel deeper beneath the surface – where it ...


    By Aquaread Limited

  • Monitoring the performance of moisture purifiers for process gases

    Problem Statement Moisture purifiers are a big aid in keeping moisture levels under control inside a process chamber. They are provided by manufacturers with certain life expectancies, which vary depending on the moisture content of the gas being purified. As a result, it is difficult to determine which gases have a high moisture content and which moisture purifier is becoming ...


    By CIC Photonics, Inc.

  • Continuous monitoring of moisture present inside a process chamber

    Problem Statement Moisture inside a process chamber is a big silent killer during wafer production. When production yield goes down, it is hard to pinpoint the source of the problem. Most of the time wafers need to be sent to labs for analysis, while production is stopped. If the problem is related to a high level of moisture inside the reactor, there are several factors that can cause ...


    By CIC Photonics, Inc.

  • Measurement of moisture in HBr

    Introduction Moisture in corrosive gases will accelerate the rate of metal corrosion in gas supply systems which, in turn, can lead to their premature failure. For this reason, it is important to monitor moisture levels in these gases. FTIR is an effective way to monitor for moisture in these corrosive gases. In order to determine low levels of moisture in corrosive gases, it is ...


    By CIC Photonics, Inc.

  • Sampling moisture in the soil profile

    Patterns of water replenishment and use give rise to large spatial variations in soil moisture over the depth of the soil profile. Accurate measurements of profile water content are therefore the basis of any water budget study. When monitored accurately, profile measurements show the rates of water use, amounts of deep percolation, and amounts of water stored for plant use.Experimental ...


    By METER Group, Inc.

  • Detection of moisture in ammonia gas

    Problem Statement As technologies advance, so does the request for ultra high purity ammonia. Ultra high purity (UHP) ammonia is used in the semiconductor industries, production of flat panel displays, and a number of other applications. Due to this rising interest in UHP ammonia, manufacturers are having to battle ammonia’s most prominent and damaging impurity--moisture. For ...


    By CIC Photonics, Inc.

  • Moisture in Oils: The Three-Headed Beast

    Abstract Moisture contamination in in-service lube oils is perhaps one of the most destructive forms of engine corrosion second only to particle contamination.  Water contamination in oil can be categorized into three forms of water; Free, emulsified, and dissolved.  All forms of water have direct consequences to the oil and gears of the engine, but indirect consequences as ...


    By Arizona Instrument LLC

  • High Quality Moisture Analysis for High Value Resins

    Whether you’re making syringes or turkey basters, pacemakers or milk jugs, maintaining the correct moisture content in your resins is essential to your production process. Join us February 9-11 in Anaheim, CA at Plastec West / MD&M West, booth 3920, and see why our instruments are considered the leaders in moisture analysis for the medical device ...


    By Arizona Instrument LLC

  • Determining levels of moisture permeation through Kalrez and Chemraz o-ring material

    Problem Statement As the manufacturers of corrosive resistant gas cells we are often called upon to design a system for the detection of moisture in various gases. Most of our requests are to detect moisture in the low ppb levels. This can be a rather difficult task to accomplish when the surrounding environment has high levels of moisture (humidity). There are several steps that we ...


    By CIC Photonics, Inc.

  • Moisture Audits & Analyser Performance Assessments at Woodside, Karratha - Case Study

    Woodside had been experiencing intermittent blockages in 4/5 S1406 LNG trains since September 2008 and had been unable to pinpoint the source of the problems. Repeated hydrate formations were leading to reduced productivity and the existing process monitoring instrumentation had failed to confirm moisture breakthrough on the beds. The site's existing Panametrics portable moisture analysers had ...

  • The Role of Soil Moisture on our Climate, Weather and Global Warming

    Global warming is a topic that has received much attention in the media, especially during the hot days of summer. The process by which carbon dioxide (CO ...

  • Thermal Patters Due to Moisture Accumulation within Exterior Walls

    In cold climates, air leakage is accompanied by moisture transport. When migrating through dew point temperatures, a considerable amount of moisture accumulation may occur depending on variables such as the duration of sub-zero exterior temperatures, building pressurization, wind effects and the level of interior relative humidity. Moisture accumulation may result in premature deterioration of ...

  • The benefits of monitoring compressed air

    Compressed air is used in many manufacturing processes for many different reasons, from the actuation and control of pneumatic valves and cylinders to the operation of process machinery and tooling. It can also be used as a transport medium for bulk materials or as a purge gas. For all its uses it is nonetheless expensive. This is why, through detailed monitoring, a business can enjoy the ...


    By Contrec Ltd

  • The benefits of monitoring compressed air

    Compressed air is used in many manufacturing processes for many different reasons, from the actuation and control of pneumatic valves and cylinders to the operation of process machinery and tooling. It can also be used as a transport medium for bulk materials or as a purge gas. For all its uses it is nonetheless expensive. This is why, through detailed monitoring, a business can enjoy the ...


    By Contrec Ltd

  • Noise Monitors and Meters

    Sound level meters Description and ApplicationsThe sound level meter is a lightweight instrument for the measurement of sound pressure level (SPL) in decibels. All ANSI-approved meters meet minimum requirements that include an A-weighted network, a slow-response meter characteristic, and a fully graduated scale with measurements ranging from 80 to 130 dBA. The Type II meter is most frequently ...

  • An analysis of extinction coefficients of particles and water moisture in the stack after flue gas desulfurization at a coal-fired power plant

    Two important factors that affect in-stack opacity—light extinction by emitted particles and that by water moisture after a flue gas desulfurization (FGD) unit—are investigated. The mass light extinction coefficients for particles and water moisture, kp and kw, respectively, were determined using the Lambert-Beer law of opacity with a nonlinear least-squares regression method. The ...

  • INFRARED TECHNOLOGY - It`s Use in Forensic Building Science to Solve Moisture Intrusion Problems

    This paper will focus discussion on the building envelope, the science behind the inspection, techniques for inspection, and verification of the findings. Because much of our work is pioneering, we will end by addressing the question 'Where do we go from here?' WHY USE INFRAREDA picture says a thousand words; infrared thermography is the only diagnostic technology that lets you instantly ...

  • Emission Testing and Monitoring

    Presented in Track B4: EMISSION TESTING & MONITORING at EUEC 2011, January 31 Phoenix, Arizona B4.1  | Update on PM2.5 and Condensable Particulate Matter Emissions Measurement Methods Larry Hottenstein |  Partner, Environmental Resources Management Following the promulgation of the PM2.5 ...

  • Pollution monitoring in Cement Industry

    The rising use of waste based fuels in the cement industry, both for economic and Environmental objectives, combined with the strengthening of air emission regulations around the world is pushing many operators to face a wider list of pollutants to monitor this, with associated costs. The design of appropriate solutions meeting local regulation is the key to maximize the cost benefit of the fuel ...

Need help finding the right suppliers? Try XPRT Sourcing. Let the XPRTs do the work for you