multi-frequency pipe locator Articles

  • Relining with corrugated steel pipe, Mississauga, ON

    Owner: Ministry of Transportation, Ontario Consultant: Morrison Hershfield Contractor: Underground Services Limited Location: Mississauga, Ontario With over 320,000 vehicles per day the intersection of Highways 401, 403 and 410 in Mississauga, Ontario, is one of the busiest in North America. At the same location can be ...


    By Armtec

  • Plugging `hot` pipes in extreme environments

    Some of the world's most intricate infrastructure is found in power plants, chemical plants, refineries, and other factories that use and combine industrial chemicals. The piping for fuel, chemical transport, water supply, and cooling needs is typically very complex and subject to high temperatures and pressures. And since plants are harsh environments, it's a given that piping needs regular ...


    By Petersen Products Company

  • Characteristics of pipe-scale in the pipes of an urban drinking water distribution system in eastern China

    Pipes that carry drinking water have gradually aged. Events occurring with increasing frequency, such as substandard water quality in residential taps, red water, and black water, reveal the deterioration of the chemical stability of a drinking water distribution system (DWDS). Pipes in the DWDS serving City S, located in eastern China, were sampled to analyze the concentration and ...


    By IWA Publishing

  • Multi-sensor inspection robot shows benefits of pipe penetrating radar - Case Study

    Pipe penetrating radar (PPR), the in-pipe application of ground penetrating radar (GPR) is one of the most promising quantitative pipe condition assessment technologies to emerge in recent years. With most of the underground pipe infrastructure reaching the end of their design life there is a need to provide measurable data in order to establish the extent of rehabilitation required or the timing ...


    By SewerVUE

  • Case study - Successful trunk main correlations in Australia, the land of long pipes

    The Aquasscan TM Successfully locates leaks at distances over 1KM in Sydney. The Gutermann Aquascan TM (Trunk Main) correlator provided a series of high performance correlations in trials performed in Sydney, Australia.  Sydney Water provided a 1.2 KM of 600mm OD Steel trunk main for a series of tests to be performed to evaluate the performance.  The testing was administered ...


    By Gutermann AG

  • Identifying Low-Frequency Tonal Noise in Windy and Noisy Conditions - Case Study

    Problem A large LNG gas facility (approximately 300m x 150m) producing 300 000 tons of LNG annually is situated in a terminal area with the nearest populated area at a distance of around 1 km. Within the gas production facility, a low-frequency tonal noise at around 500 Hz is generated causing complaints from nearby neighbours. The tone imposes a more stringent noise requirement on the ...


    By Norsonic AS

  • Filming Low-Frequency Structure Born Noise With Acoustic Camera - Case Study

    Problem An apartment complex consists of five floors, with several apartments over four floors, and an attic on the top floor. In the attic an air circulation system is installed to provide circulation in the bathroms of all the apartments in the building. The circulation system is driven by an air fan distributing air through pipes going to all apartments. The air pipes are cemented in ...


    By Norsonic AS

  • Green–blue water in the city: quantification of impact of source control versus end-of-pipe solutions on sewer and river floods

    Urbanization and climate change trends put strong pressures on urban water systems. Temporal variations in rainfall, runoff and water availability increase, and need to be compensated for by innovative adaptation strategies. One of these is stormwater retention and infiltration in open and/or green spaces in the city (blue–green water integration). This study evaluated the efficiency of ...


    By IWA Publishing

  • Failing Brine Piping Replaced at World`s Largest Ion Exchange Membrane Plant

    Fabricated Plastics Limited is headquartered in Maple, Ontario, located on the northern outskirts of Toronto. One of North America's largest custom composite and dual laminate fabrication companies. Fabricated Plastics is dynamic, energetic, creative and resourceful. Engineering design, problem solving and fabrication are world class with the result that Fabricated Plastics is frequently invited ...


    By Fabricated Plastics Limited

  • Optimized Pipediver Platform Making Waves As Advanced Condition Assessment Tool For Metallic Pipes

    Pure Technologies (Pure) never says no to an engineering challenge. If a client has a particular pipeline assessment or monitoring challenge to overcome in order to make a rehabilitation decision, we’ll do whatever it takes to help ...


    By Pure Technologies

  • Multiple-fault detection in water pipelines using transient-based time-frequency analysis

    Pipe faults, such as leakage and blockage, commonly exist in water pipeline systems. It is essential to identify and fix these failures appropriately in order to reduce the risk of water pollution and enhance the security of water supply. Recently, transient-based detection methods have been developed for their advantages of non-intrusion, efficiency and economics compared to traditional ...


    By IWA Publishing

  • Dynamic Lateral Response of a Pile Group in Clay

    A series of lateral dynamic loading tests were conducted on a rigid concrete cap supported by nine 273-mm-diameter steel pipe piles in a square group. The piles were driven 13.7 m into a layered deposit of overconsolidated clay. A linear inertial mass vibrator applied horizontal constant-rate frequency sweep and steady state loadings from frequencies above the first mode resonance to frequencies ...


    By ASTM International

  • Looking for Clues: Hamilton Demonstrates Value of Condition Assessment Program During Investigation of Critical Watermain

    In late 2015, the City of Hamilton, Pure Technologies (Pure) and Robinson Consultants worked together to perform an external investigation of a pipe section in the Woodward Greenhill Transmission Main (WGTM) to gain understanding of what was causing degradation in a specific geographical area. A 2014 condition assessment ...


    By Pure Technologies

  • Case study - Woodroffe Avenue Transmission Main - Ottawa, Ontario

    Service: SoundPrint AFO PureRobotics Client: City of Ottawa Project Date: 2011 Location: Ottawa, Ontario, Canada Type of Pipeline: Water Transmission Main Diameter: 48-inch (1200mm) Pipe Material: PCCP The Woodroffe Avenue Transmission Main in Ottawa, Ontario experienced a major failure in January 2011 which opened a large hole across three traffic lanes causing major ...


    By Pure Technologies

  • What’s New? Maximizing The Life Of Aging Metallic Pipelines With Modern In-Line Technology

    Maximizing the life of aging pipelines has long been a challenge in North America. Owners of large diameter water and wastewater infrastructure face particular condition assessment challenges, owing to factors such as financial constraints, environmental concerns and access restrictions, which compound the problem. While desktop studies can help identify pipes with a likelihood and consequence of ...


    By Pure Technologies

  • Underground, underwater, under stress: Town of Longboat Key puts SmartBall tool to unusual pipeline condition test

    When much of your critical sewer pipeline lies buried under a bay of shimmering ocean water, the challenges required to assess its condition may seem daunting. That task faced the Town of Longboat Key, an affluent retirement community located on the barrier island of the same name off the west coast of Florida. Sensitive to environmental, health and safety issues, ...


    By Pure Technologies

  • Non-contacting solution for Plugged off flow meters in the oil patch - Case Study

    For years Petrobakken Energy Ltd. used inline turbine flow meters to track the flow rate of oil recycled to treaters. But with a high concentration of wax and sand in the oil, the turbine meters were quickly plugging off. The line had to be shut down at least once a day and the turbine flowmeters disassembled for cleaning. This was troublesome and expensive. Petrobakken knew there had to be a ...


    By Greyline Instruments Inc.

  • Organoclay-filled reactive core mat dnapl remedial barrier proves succesful case study

    Project : Koppers Wood Treatment Facility Location : Guthrie, KY Products : Reactive Core Mat Background: This is a case study of an active wood-treatment plant that has operated in southwestern Kentucky since 1913. Historically, creosote dripped from treated rail cross ties following their removal from a pressure cylinder. ...


    By CETCO

  • Huckabay Ridge

    Location: Stephenville, TX Online date: November 2006 Acquisition Date: November 2010 In 2010 Element Markets acquired the largest anaerobic digestion facility in North America through its wholly owned subsidiary EM Biogas. The Huckabay Ridge Anaerobic Digestion Project, located in a large dairy community in Stephenville, Texas, turns manure ...


    By Element Markets LLC

  • PE-Recycling at its very best case study

    The Pipelife Group is a leading manufacturer of plastic pipe systems in Europe. The company's flagship products are created at its Stathelle facility in Norway, where PE pipeline pipes hundreds of meters long and up to 2.50 meters in diameter are produced for use throughout the world. Since the beginning of this year, production waste that accumulates has been shredded and recycled with a ...


    By WEIMA

Need help finding the right suppliers? Try XPRT Sourcing. Let the XPRTs do the work for you