natural gas burner Articles

  • Are GAS-FIRED Burner Technologies Really The Best Choice for ISTR Cleanups?

    Its an exciting time. In-Situ Thermal Remediation (ISTR) shows great promise and has proven to be an extremely effective method for cleaning a wide range of Contaminants of Concern (COC’s) at contaminated sites. Most recently, gas-fired soil heating technologies are entering the market with promises of much cheaper natural gas heating, faster setup and heating times, less heaters required ...


    By Soil-Therm Equipment, Inc.

  • Development of Low noise landfill gas flare

    Summary: Increasing requirements of the environmental standards and planning permission conditions create more challenges to the equipment providers. Environment Agency guidance demands low emission levels and local planners put low noise levels in their conditions for landfill sites. Achieving both at the same time with conventional equipment was found problematic. Biogas Technology has ...


    By Biogas Technology Limited

  • Fire prevention measures in gas fired boiler’s operation

    Gas fired boiler is a kind of industrial boiler using natural or coal gas as fuel,its fuel is risky,especially,fire leakage in the operation is easy to ...


  • Why high temperature combustion of landfill gas?

    Due to the accumulation of knowledge and the tightening of environmental law, the landfill technology has increasingly become concerned with the management of trace compounds in landfill gas. With landfill gas, contamination is through sulphur, chlorine, fluorine, halogenated hydrocarbons and heavy metals. Other trace elements such as volatile organic compounds (VOC), impose environmental ...


    By Hofstetter BV

  • Tips for turning a coal fired boiler to gas fired boilers

    Smog has been a heated topic among the word. Therefore , gas fired boiler substitute for coal fired boiler become a trend to protect the environment.Since the boiler is a large thermal equipment ,it is requires attention to security incidents in the transformation .Here are some tip from ZG about turning a coal fired boiler to gas fired boiler. First , when turning a coal fired boiler to gas ...

  • Maxsys Fuel System generates 6% savings on Gas Fired Steam Raising Boilers at Mondi Packaging

    Mondi is one of the world’s leading international paper and packaging groups with a substantial global presence, employing 34,000 people at 112 sites across 34 different countries. The company is continually striving for a consistent high level of improvement in environmental performance in all its operations, making efficient use of raw materials and energy, while focusing on innovation ...


    By Maxsys Fuel Systems Ltd

  • Adwest Technologies flameless retox rto oxidizers with acid gas scrubbers for cost effective voc & odor abatement

    Adwest Technologies, Inc. provides cost effective Flameless Regenerative Thermal Oxidizers (RTO) with acid gas scrubber systems for cost effective VOC and odor abatement from malodorous VOC processes including food processing, rendering, petfood, biopharma spray dryer, bakery oven, composites, foundry, biogas, sludge dryers and waste water treatment plants (WWTP) off gas applications.  ...

  • Redundant combustion plant for Novartis

    Type     HOFGAS®- IFM4c/2200/1500/60/180 Commissioning     2004 Site     Novartis (Basel, CH) Situation In order to prevent production failure due to missing redundancy in the flue gas clean up, Novartis required an additional system. During different production processes exhaust air load with organic components is formed. ...


    By Hofstetter BV

  • Saving waste in the boiler house

    Burner technology has improved greatly in recent years. Older Burners had a series of cams and levers that were calibrated to provide specific amounts of air for a particular rate of firing. Being mechanical items, these wore and sometimes required calibration. They, therefore, had to be regularly serviced and calibrated. Generally, new burners use frequency controlled motors and cams to open air ...


    By EBE Engineering Ltd.

  • Monitoring Air/Fuel Mixtures in Glass and Glass Fiber Manufacturing case study

    Measurement of Premix Gas. To produce the desired flame in a glass forehearth or when making fiberglass (glass fiber) insulation, an air/fuel pre-mixer is used. The pre-mixer combines compressed natural gas or propane with air and this mixture is then piped to the process burners At the burner, a fuelrich or fuel-lean flame is produced depending on the air/ fuel ratio selected. In many ...

  • Direct fired thermal oxidizer - Aluminum manufacturer

    Epcon has extensive experience in designing and building Air Pollution Control Systems for the Aluminum Industry. The Problem The company had a direct fired afterburner and a gas fired rotary kiln. The kiln would de-oil the aluminum scrap and the offgas would go to the afterburner. The design of the system was over 20 years old and very fuel ineffficient.   ...


    By Epcon Industrial Systems, LP

  • Cost-Effective NOx Control for Air-Preheated Systems

    New advancements in combustion control technologies, such as flue gas recirculation (FGR) and low NOx burners (LNB), have made it possible to achieve ultra low NOx levels without using expensive post-combustion flue gas clean-up technology. For some natural draft units it may be possible to meet the most stringent of the NOx regulations with cost-effective combustion control technologies. For ...

  • Determining flammability of SpillFix Universal Organic Absorbent

    SpillFix Universal Organic Absorbent is an industrial absorbent product made from natural coir (coconut husk). Flammability tests (as detailed below) have determined that the product is a Not Readily Combustible Solid, and is unlikely to catch fire even after absorbing flammable spills. Determining Flammability The tests for determining ...

  • Soil remediation system - Trailer mounted portable afterburner

    The Problem A major Vapor & Odor Control company needed a portable solution to clean the soil leftover at old fuel stations. portable afterburner The Process Soil Remediation Afterburners & Oxidizers are manufactured to treat soil containing contaminates such as petroleum hydrocarbons, with diesel oil, gasoline, ...


    By Epcon Industrial Systems, LP

  • Client - Oil Refinery, Eastern Europe

    Project - Heavy Oil Pre-Heater As part of an overall facility upgrade this major oil refinery decided to seek ways of reducing its heavy oil pre-heating costs. A proposal was submitted that would enable waste heat from the refinery to be used as the source to safely pre-heat the stored heavy oil. The solution proposed the use of a gas to water recovery unit coupled to two heat pipe ...


    By Econotherm UK Ltd

  • Trailer Mounted Afterburner for Soil Remediation

    The Problem A major Vapor & Odor Control company needed a portable solution to clean the soil leftover at old fuel stations. The Process Soil Remediation Afterburners & Oxidizers are manufactured to treat soil containing contaminates such as petroleum hydrocarbons, with diesel oil, gasoline, aromatic hydrocarbons, solvents and many other ...


    By Epcon Industrial Systems, LP

  • Case study - Spindle utilities module

    Business Situation The existing method of tracking utility usage at these industrial laundries was highly manual, unreliable, and time consuming. Total utility consumption from bills was entered into large spreadsheets and analyzed over periods that were often 3 months or more in arrears. The report merely told managers what they already knew—they had overspent on natural gas; ...


    By Dober Chemical Corp

  • Minimizing Operating Costs in VOC Abatement Equipment

    Untitled Document As governmental regulations of environmental emissions become more restrictive, the average concentration of Volatile Organic Compounds (VOC's) has decreased as more ...

  • Common Treatment Technologies for Nonhalogenated VOCs in Air Emissions/Off-Gases

    Three technologies that are most commonly used to treat nonhalogenated VOCs in air emissions/off-gases are carbon adsorption, catalytic oxidation, and thermal oxidation. Carbon adsorption is a remediation technology in which pollutants are removed from air by physical adsorption onto the carbon grain. Carbon is 'activated' for this purpose by processing the carbon to create porous particles with ...

  • NOx in Non-Utility Industries - Part II - Control options and monitoring methodology

     This the second in a two-part series. Part I, which appeared in our June 2001 issue focuses on air emission origins of nitrogen oxides (NOx) in non-utility industries. Choice of the NOx control technology is dependent on many factors, including regulatory requirements, technical feasibility, cost and public perception. Figure 1, compiled based on publications [1-5], presents a summary of ...


Need help finding the right suppliers? Try XPRT Sourcing. Let the XPRTs do the work for you