nitrogen oxide removal catalysts Articles

  • Recovery of Precious Metal Catalysts - A New Process Using Supercritical Water Oxidation

    Up to now, the recovery of precious metals used as catalysts in chemical processes has involved the use of incineration. Now, however, a British-Swedish joint venture has developed a process which uses supercritical water oxidation instead, which provides many economic and environmental advantages. Precious metals are used extensively in catalysts in a wide range of industrial chemical processes. ...

  • A study on ruthenium-based catalysts for pharmaceutical wastewater treatment

    Ruthenium-based catalysts were prepared by a saturation-dip method. Their catalytic activity was evaluated by a catalytic wet oxidation (CWO) process. The ruthenium-based catalysts were used to purify organic pharmaceutical wastewater with high concentration pyridine and pyridine derivatives that have high chemical oxygen demand (COD). In the CWO process, organic pharmaceutical wastewater was ...


    By IWA Publishing

  • Electro-thermal treatment optimization of high concentration ammonia nitrogen by gaseous oxidation in liquid phase (GOLP)

    This study is focused on optimizing the treatment parameters for high concentration ammonia using gaseous oxidation in liquid phase (GOLP). The conversion of ammonia was achieved electro-thermally over mono-crystalline silicon supported CoOx catalyst. The experimental results demonstrated that factors including the co-anions, pH of the solutions, air flowrate and the current showed apparent ...


    By IWA Publishing

  • Nitrogen Oxide Technology Gives American Superconductor an Economical, Environmentally Friendly Treatment Solution

    Untitled Document The installation of Bionomic Industries Inc.'s (Mahwah, NJ) innovative ScrubPac™ BIONOxSOLVER abatement system is enabling American Superconductor ...


    By Bionomic Industries Inc.

  • Nitrogen Oxide Technology gives American Superconductor an economical, environmentally friendly treatment solution

    The installation of Bionomic Industries Inc.'s (Mahwah, NJ) innovative ScrubPac. BIONOxSOLVER" abatement system is enabling American Superconductor Corporation to treat the nitrogen oxide (NOx) emissions from a calcination process at its new, high temperature superconductor manufacturing facility (Devens, MA), in a cost-effective, environmentally responsible way. Bionomic Industries' ...


    By Bionomic Industries Inc.

  • Nitrogenous Fertilizer Plants Industry - Pollution Prevention Guidelines

    Introduction Pollution Prevention Guidelines to provide technical advice and guidance to staff and consultants involved in pollution-related projects. The guidelines represent state-of-the-art thinking on how to reduce pollution emissions from the production process. In many cases, the guidelines provide numerical targets for reducing pollution, as well as maximum ...


    By The World Bank

  • Adsorption and photocatalytic degradation of malachite green by vanadium doped zinc oxide nanoparticles

    Herein the degradation of malachite green (MG) dye from aqueous medium by vanadium doped zinc oxide (ZnO:V3%) nanopowder was investigated. The specific surface area and pore volume of the nanopowder was characterized by nitrogen adsorption method. Batch experimental procedures were conducted to investigate the adsorption and photocatalytic degradation of MG dye. Adsorption kinetics ...


    By IWA Publishing

  • Synthesis, activity and thermal stability of gold nanoparticle on modified nh4-y type zeolite for cooxidation

    Carbon monoxide (CO) is a gaseous pollutant which enters the atmosphere from four major sources: fossil fuel combustion and industrial emissions, biomass burning, oxidation of CH4, and oxidation of hydrocarbons. The presence of CO causes problems to human health, particularly in cases of locally high concentrations, and affects the oxidizing capacity of the troposphere. Automobile emissions are ...


    By University of Tehran

  • Chemical Aspects of NOX Scrubbing

    With the passage of the 1990 Clean Air Act Amendments, many chemical and metal industries and utility producers will now be required to further limit the amount of NOX (Nitrogen Oxides) produced. NOX is a precursor to ozone in the atmosphere, and is believed to be a major contributor to acidic deposition (acid rain). Formation of ozone: NO2 + Hv ...


  • Innovative Ammonia Control case study

    Ammonia has increasingly become more of a regulatory concern. Ammonia emissions into the atmosphere have been linked to the formation of fine particulate matter, while ammonia emissions in wastewater are restricted because of the negative affect the chemical has on rivers, lake, and aquifers. Many sources of biofuels contain ammonia or can create ammonia during processing. The following case ...

  • A Breath of Fresh Air for Your

    As the full effect of the Federal Clean Air Act (CAA) Amendments continue to impact today’s industry, many companies will be required to install new or additional air pollution control equipment.  With over two decades of proven success, catalytic oxidation is a popular method for controlling volatile organic compound (VOC) emissions.During the past 25 years, industry has made progress in ...


    By The CMM Group, LLC

  • NOx in Non-Utility Industries - Part II - Control options and monitoring methodology

     This the second in a two-part series. Part I, which appeared in our June 2001 issue focuses on air emission origins of nitrogen oxides (NOx) in non-utility industries. Choice of the NOx control technology is dependent on many factors, including regulatory requirements, technical feasibility, cost and public perception. Figure 1, compiled based on publications [1-5], presents a summary of ...


  • The Chemical Aspect of NOx Scrubbing

    With the passage of the 1990 Clean Air Act Amendments, many chemical and metal industries and utility producers will now be required to further limit the amount of NOx (Nitrogen Oxides) produced. NOx is a precursor to ozone in the atmosphere, and is believed to be a major contributor to acidic deposition (acid rain). Formation of ozone: NOx is produced in a variety of ...


    By CR Clean Air Group, LLC

  • Case study - Kiln emission control technologies

    Overview A specialty ceramic material manufacturer in the United States operates several custom-built furnaces in their manufacturing process.  Sometimes referred to as kilns, these high-temperature process devices are generally a major source of air pollutants and require an abatement technology to meet environmental regulations with the state or federal agencies.  As is the ...

  • The Right Mix for Clean Air

    Reducing air pollution is an increasingly important topic all around the world. Many governments—also in developing countries—set new limits for emissions such as nitrogen oxides in flue gas. Sulzer offers advanced mixing technology for flue gas cleaning. The installation in a large power plant shows that these high-performance mixers can cope with the most difficult requirements. ...


    By Sulzer

  • Managing Water Pollution

    Untitled Document Equipment and ideas abound for cleaning up plant wastewater and polluted groundwater Groundwater, surface water, wastewater, drinking water: ...


  • Petroleum Refining Industry - Pollution Prevention Guidelines

    Introduction Pollution Prevention Guidelines to provide technical advice and guidance to staff and consultants involved in pollution-related projects. The guidelines represent state-of-the-art thinking on how to reduce pollution emissions from the production process. In many cases, the guidelines provide numerical targets for reducing pollution, as well as maximum ...


    By The World Bank

  • Retrofitting diesel engines: reducing the emissions of our ideal power source

    Over the past several years, Avogadro Environmental has been working with a number of clients to develop proactive environmental programs as part of their EPA Performance Track and ISO 14001 management systems.  Many client companies that are proactively implementing measures to reduce their environmental footprint are looking for ideas.  Diesel engine retrofits for off-road stationary and mobile ...

  • Nature’s Own - Biofiltration process offers promise of (near) energy-free pollution abatement

    A filter could be described as any substance through which liquid is passed to remove suspended impurities. Although a “biofilter” is actually not a filter, “biofiltration” is on the threshold of finding a market as a compliance solution for air pollution regulations after a number of false starts. Biofilters have long been used as a means for reducing objectionable odors in Germany, the ...


  • Treatment Options for Molten Sulfur Storage

    Documento sin título ...


    By Merichem Company

Need help finding the right suppliers? Try XPRT Sourcing. Let the XPRTs do the work for you