non-methane hydrocarbons analyzer Articles

  • Analyzing for Trace CO and CO2 using a Total Hydrocarbon Analyzer

    Untitled Document The purity of Specialty Gases is determined by the measurement of various contaminants including Total Hydrocarbons. Low level measurements of carbon ...


    By MOCON, Inc. - Baseline

  • Aliphatic and polycyclic aromatic hydrocarbons in sediments of Kaohsiung Harbour and adjacent coast, Taiwan

    Surficial sediment samples collected from Kaohsiung Harbour and its nearby coast were analyzed for aliphatic hydrocarbons and parent polycyclic aromatic hydrocarbons (PAHs). According to our results, the average total concentrations of n-alkanes (n-C12 to C35) and aromatics (15 PAHs) were 4.33 µg g–1 dry weight (ranged 0.46–22.60) and 0.59 µg g–1 dry weight (ranged 0.09–1.75), respectively. The ...


    By Springer

  • Accurately Measure Hydrocarbon (Oil/Grease) Levels in Produced Water in Under 15 Minutes

    Determining total hydrocarbon or oil/grease levels to ensure compliance with regulatory permit requirements for discharging produced water is a worldwide problem facing the oil and gas industry.   Ensuring compliance with these regulations and avoiding fines for non-compliant discharges requires more frequent wastewater measurements to determine the total hydrocarbon ...


    By Spectro Scientific

  • AMETEK THERMOX Introduces the WDG-V Combustion Analyzer

    Abstract AMETEK THERMOX Introduces the 5th Generation THERMOX Combustion Gas Analyzer in a CONTROL Magazine Exclusive. WDG analyzers are based on a zirconium oxide cell that provides a reliable and cost-effective solution for measuring excess oxygen in flue gas as well as CO and methane levels.  Information from the Gas Analyzer allows operators to obtain the highest ...

  • FTIR resolution requirements for industrial gas analyzers

    FTIR Spectroscopy is a widely used technique for gas analyses in industrial applications. It is a technique used in the semiconductor industry for measuring the purity of cleaning, etching, and epi-treatment gases used with various process tools, reactors, and abatement devices. Among chemical companies and R&D facilities, FTIR is applied to combustion thermodynamics and stack gas emissions; ...


    By CIC Photonics, Inc.

  • Analyzing sulfur in soil and sediment with handheld XRF

    Background Sulfur creates more than nasty odors. Exposure to low levels (0-10ppm) of hydrogen sulfide (H2S) causes irritation of eyes, nose, and throat; higher levels can cause headaches, dizziness, nausea and vomiting, coughing, and breathing difficulty. H2S and numerous other odor-causing compounds are generated as a result of organic material decomposition. In the case of the Muddy River in ...

  • `Evolving Climate Strategies among Asian Nations under CDM & JI at Hydrocarbon E &P Industry ----- Aligning Carbon Abatement Costs in Asian Emissions` Trading Scheme`.

    AbstractAsian Emissions' Trading Scheme (AETS) for CO2 capturing is one of the major components of Asian Climate Strategy for achieving Asian Kyoto Targets under UNFCCC. Besides trading emission allowances, linking between AETS and two flexible project mechanisms: 'Clean Development Mechanism' (CDM) and 'Joint Implementation' (JI) has been established at Hydrocarbon E&P Business, that opens ...

  • 5th-Generation Thermox WDG Flue Gas Combustion Analyzer

    "For more than 40 years, we have been a leader in combustion gas analysis," says Mike Fuller, divison VP of sales and marketing and business development for Ametek Process Instruments, "and we believe the WDG-V is the combustion analyzer of the future." WDG analyzers are based on a zirconium oxide cell that provides a reliable and cost-effective solution for measuring excess oxygen in flue gas as ...

  • GE Leakwise Application Notes: Oil Sheen Detection -- An Alternative to On-Line PPM Analyzers

    Introduction Discharge of hydrocarbons in industrial water is restricted by environmental authorities in most countries to a few parts per million (ppm). Environmental authorities currently monitor wastewater, stormwater, and cooling water discharges from ...


    By GE Analytical Instruments

  • On-Site TPH in Soil Measurements in less than 15 Minutes with Portable IR Analyzers

    On-site analysis of total petroleum hydrocarbon (TPH) concentration levels in soil are easily handled using the InfraCal TOG/TPH Analyzers manufactured by Wilks Enterprise, Inc.  The InfraCal TOG/TPH Analyzers are portable infrared (IR) analyzers that quickly determine TPH levels in less than 10-15 minutes, including the extraction.  Concentrations as low as 10 ppm to well over 10,000 - ...


    By Spectro Scientific

  • Portable Infrared Analyzers Provide On-Site Measurement of Oil and Grease Levels in Hydraulic Fracturing Water

    The amount of water used in and produced by hydraulic fracturing of shale gas wells is in the millions of gallons per well.  Whether the water is going to be taken off-site for disposal or reused for re-injection, the flowback or produced water needs pretreatment to remove any residual oil from the water.  Waiting for remote laboratory results to determine the oil level can take several ...


    By Spectro Scientific

  • Case study - NAPL forensics analysis at refinery site in Kansas

    An environmental consultant at Subsurface Environmental Solutions, LLC used Sitelab to fingerprint a large plume of Non Aqueous Phase Liquids (NAPL) located at a former oil refinery in Kansas. The plume is commingled with gasoline, diesel, crude oil and other petroleum products. Sitelab’s portable UVF-3100D analyzer is fitted with optical filters which can measure the C6 to C10 gasoline ...


    By Sitelab Corporation

  • Analysis of Natural Gas Products by GC / TCD / FID

    The complex mixture of condensible hydrocarbons and permanent gases in a natural gas product has historically been separated on gas chromatographs equipped with dual columns and a switching valve. The light gases are separated from heavier compounds on a molecular sieve column, which is then backflushed onto a suitable column to separating the rest of the mixture. The Buck Scientific Model 910 ...


    By Buck Scientific Inc

  • Oil in frac water testing

    The amount of water used in and produced by hydraulic fracturing of shale gas wells is in the millions of gallons per well. Whether the water is going to be taken off site for disposal or reused for re-injection, the flowback or produced water needs pretreatment to remove any residual oil from the wa-ter. Waiting for remote laboratory results can take several days to a week. The InfraCal TOG/TPH ...


    By Spectro Scientific

  • Natural Gas: Complete Analytical Solution

    Chromatotec® has developed in its Research & Development laboratories, a new instrument for hydrocarbon (C1-C6+) measurements and calorific values as well as WOBBE index computation. This analyzer is based on chromatography principle using a Thermal Conductivity Detector (TCD). The sample will be separated into the column and quantified by the detector. A difference of thermal ...


    By Chromatotec Group

  • Expert insight: test method basics for oxidizer permit requirements

    Whenever a new oxidizer is installed to control Volatile Organic Compound (VOC) emissions, the question often comes up: What test method should I use to demonstrate that the device meets permit requirements?   Most states allow you the choice of three EPA Test Methods: 18, 25 and 25A. Of these, use of Method 25A is usually the most desirable, for a few reasons. One, Method 25A provides real ...

  • A novel spectrometer design for process and handheld infrared spectral measurements

    Introduction Infrared spectroscopy offers many unique advantages for measurements within an industrial environment. Historically, the technique has been used for a broad range of applications from the composition of gas and liquid mixtures to the analysis of trace components for gas purity analysis. In cases where a well-defined method of analysis is involved, such as the measurement of ...


    By CIC Photonics, Inc.

  • Waste Fuel Case History

    The Customer The company engages in the design, manufacture, and sale of machinery for decomposing petroleum-based materials. The company uses microwave technology for recovering hydrocarbons and fossil fuels from sources, such as tires, oil shale, capped wells, coal, automotive shredded residue, municipal solid waste, shale deposits, and waste oil streams. The ...

  • Triad expedites brownfields redevelopment in Fairbanks

    The Fairbanks North Star Borough (FNSB) used Triad in 2006-2007 to assess environmental conditions at a municipal property along the Chena River in Fairbanks, AK. FNSB accelerated the site investigation as part of a brownfields assessment grant received from the U.S. EPA in 2005. Low-level contamination had been identified onsite in past investigations, but its extent and impact on future ...

  • Biodegradation of MTBE Utilizing A Magnesium Peroxide Compound: A Case Study.

    ABSTRACT: A patented magnesium peroxide compound was recently employed at an underground storage tank facility to increase the available oxygen in the groundwater for the biodegradation of fuel hydrocarbons. The objective of this remedial effort was to substantially reduce the dissolved-phase concentrations of BTEX and MTBE and to arrest further migration of the dissolved fuel hydrocarbon plume. ...


    By REGENESIS

Need help finding the right suppliers? Try XPRT Sourcing. Let the XPRTs do the work for you