nox analyzer Articles

  • Research NOx Analyzers

    ECO PHYSICS provides environmental experts with exceptionally sensitive and precise NOx measurement instruments. Please take a look at our newest press release on our research NOx analyzers below. Bound by the same laws of nature, ecology and physics are close associates in an on-going battle to preserve air quality around the globe. One of our planet's champions is Swiss-based ECO PHYSICS. The ...


    By ECO PHYSICS INC.

  • Why You Should Consider a Sample Conditioning Unit for Taking Low NOx Measurements When Using a Portable Emissions Analyzer

    Using state-of-the-art technology, we here at E Instruments create high-quality portable industrial combustion gas and emissions analyzers that are capable of taking precise, low NOx measurements for both NO and NO2. In particular, we recommend our sample conditioning unit to those of you who need to take accurate, low NOx or SO2 ...

  • Nadph oxidases nox-1 and nox-2 require the regulatory subunit nor-1 to control cell differentiation and growth in neurospora crassa

    We have proposed that reactive oxygen species (ROS) play essential roles in cell differentiation. Enzymes belonging to the NADPH oxidase (NOX) family produce superoxide in a regulated manner. We have identified three distinct NOX subfamilies in the fungal kingdom and have shown that NoxA is required for sexual cell differentiation in Aspergillus ...

  • Fast, simultaneous and continuous monitoring of NOx and NH3 in DeNOx applications

    In DeNOx systems using urea injection with ammonia (NH3) as a reducing agent, the flow rate and control of NH3 must be continuously adjusted and controlled to prevent excess NH3 emissions (slip), to reduce environmental impact and cost of reagents. To optimize this process, it is essential to use an emissions analysis system for simultaneous and continuous monitoring of NOx and NH3. For preparing ...


    By Environnement S.A

  • Forklift Emissions Analyzers

    Forklifts are commonly used in warehouses of various size and capacity for the movement and shipping of goods; however, the unoptimized engines can produce excess quantities of silent and deadly CO gas that can risk the health and safety of the workers. When forklifts are brought in for service usually the CO gas isn't measured. If the CO gas isn't measured and the engine properly optimized then ...

  • Sulfur Compounds Analyzer MEXA-1170SX

    The MEXA-1170SX is a continuous gas analyzer for sulfur compounds existing in engine emissions. It can measure SO2 concentration and the amount of total reduced sulfur compounds (TRS), such as H2S, separately. It can also measure the total sulfur compounds (TS) that contains both gaseous compounds and liquid compounds in PM, such as SO3. By utilizing ultra-violet fluorescence (UVF) method and ...


    By HORIBA Europe GmbH

  • AMETEK THERMOX Introduces the WDG-V Combustion Analyzer

    Abstract AMETEK THERMOX Introduces the 5th Generation THERMOX Combustion Gas Analyzer in a CONTROL Magazine Exclusive. WDG analyzers are based on a zirconium oxide cell that provides a reliable and cost-effective solution for measuring excess oxygen in flue gas as well as CO and methane levels.  Information from the Gas Analyzer allows operators to obtain the highest ...

  • MAXUM edition II - Total sulfur analyzer – Case Study

    To comply with environmental regulations in the production of low-level sulfur fuel, it is necessary to get reliable information about the product quality and sulfur content. The Siemens Maxum II, Total Sulfur on-line process gas chromatograph, provides this information in reliable manner using process suitable analytical procedures. The Total Sulfur solution applies a continuous sample ...

  • 5th-Generation Thermox WDG Flue Gas Combustion Analyzer

    "For more than 40 years, we have been a leader in combustion gas analysis," says Mike Fuller, divison VP of sales and marketing and business development for Ametek Process Instruments, "and we believe the WDG-V is the combustion analyzer of the future." WDG analyzers are based on a zirconium oxide cell that provides a reliable and cost-effective solution for measuring excess oxygen in flue gas as ...

  • NH3 Slip Monitoring in Fluidized-bed Catalytic Cracking Using the LDS 6 Gas Analyzer – Case Study

    Fluidized catalytic cracking (FCC) units are used in refineries to convert low value heavy oils into more valuable lighter compounds. Cracking units are sources of emissions of pollutants (e.g. NOx) and must comply with concentration permits set by local or federal authorithies. Modern technologies are applied to reduce the content of pollutants and to monitor certain gas compounds (here: NH3) in ...

  • Overview of ECO PHYSICS Products and Markets

    ECO PHYSICS AG manufacturers a wide variety of chemiluminescence NOx analyzers for industry, combustion research, atmospheric research and medical research. A look at our markets and products gives an impression of our ...


    By ECO PHYSICS INC.

  • Reaching Euro VI emissions limits

    The requirements of low and lowest detectable exhaust analysis has prompted Eco Physics to launch a broad range of analyzers for NO/NOx detection. Emissions tuning is one of the targets of the EURO VI regulations as well as US EPA 2010, which are: Reduction of Particulate Matter (PM) and reduction of Nitrogen Oxides (NOx). In the past 15 years – since the first European regulation for exhaust ...


    By ECO PHYSICS INC.

  • Insitu analysis of ammonia slip and water vapor using a tunable diode laser for SCR/SNCR optimization and boiler tube surveillance in power plants

    ABSTRACT Environmental Regulations driven by the 1990 Clean Air Act require Power Plants to reduce NOx emissions. SCR's and SNCR's reduce NOx emission by injecting ammonia into the combustion flue gas. which ideally reacts with the NOx to form H?0 and Nj. The efficiency of the SCR SNCR is determined by monitoring the outlet for excess NH3. referred to as NH3 slip. The flue gas sample ...

  • LAN Connectivity for Modern Process Instruments

    Process instruments such as gas analyzers are data sources, which feed a multitude of users. In general,the instruments provide these data analog or digitized through an RS232 interface. However, the datatransfer by this interface has to be located close to the controlling PC, because RS232 is designed forshort distances only. Beyond, the PC has to be dedicated and opts as master. With a ...


    By ECO PHYSICS INC.

  • Why measuring the ambient NO2 without conversion?

    Nitrogen oxides NOx are pollutants that may have particular impact in terms of greenhouse gases, acidifying air etc ... issuance increased significantly since 1950 with the massive development of transport and industries. It therefore becomes necessary to provide measures always safer these pollutant gases, and to know the reliability of results. Currently, 60% of emissions of NO and NO2 are ...


    By Environnement S.A

  • Weekday/Weekend Differences in Ambient Air Pollutant Concentrations in Atlanta and the Southeastern United States

    Abstract The authors quantified changes between mean weekday and weekend ambient concentrations of ozone (O3) precursors (volatile organic compounds [VOC], carbon monoxide [CO], nitric oxide, and oxides of nitrogen [NOx]) in Atlanta and surrounding areas to observe how weekend precursor emission levels influenced ambient O3 levels. The authors analyzed CO, nitric oxide (NO), and NOx ...

  • Navigating NSPS subpart Db for boilers: a case study

    Over the past year, Trinity assisted a chemical company with the permitting and installation of a new 220 MMBtu/hr package boiler. The new natural gas-fired boiler replaces coal-fired units that were installed in the 1940s. Navigating through the numerous, and at times conflicting, regulatory requirements applicable to such a unit has been challenging. With careful planning and implementation, ...


    By Trinity Consultants

  • Pollution monitoring in Cement Industry

    The rising use of waste based fuels in the cement industry, both for economic and Environmental objectives, combined with the strengthening of air emission regulations around the world is pushing many operators to face a wider list of pollutants to monitor this, with associated costs. The design of appropriate solutions meeting local regulation is the key to maximize the cost benefit of the fuel ...


    By Environnement S.A

  • A comparative study of three different assimilable organic carbon (AOC) methods: results of a round-robin test

    Easily assimilable organic carbon (AOC) is frequently used for the assessment of the biological stability of drinking water, which is an important consideration in the control of bacterial growth in distribution networks. The first AOC bioassay was developed in 1982 and is based on growth of two bacterial strains (Pseudomonas fluorescens P17 and Spirillum spp. NOX) in ...


    By IWA Publishing

  • Combustion optimization by fast excess air control – Case Study

    Combustion is the conversion of primary chemical energy contained in fuels into heat through the process of oxidation at high temperatures. The oxygen required for the combustion is supplied as part of the combustion air that is fed to the process. In ideal (stoichiometric) combustion the amount of oxygen supplied to the process is just sufficient to burn all combustibles completely. In real ...

Need help finding the right suppliers? Try XPRT Sourcing. Let the XPRTs do the work for you