oil absorbent mat Articles

  • Secondary Oil Containment at US Army Corps of Engineers - Big Bend Dam - Case Study

    Big Bend Dam takes its name from the unique bend in the Missouri River seven miles upstream from the dam. Construction of the dam began in 1959 and the embankment was completed in July 1963. Big Bend dam is 95 feet (29 m) high and 10,570 feet (3,220 m) in length. Power generation began at the facility in 1964 and the entire complex was completed by 1966. The hydroelectric plant generates ...


    By Albarrie Canada Limited

  • UV disinfection for enhanced oil recovery and other oilfield applications

    One of the biggest challenges facing oil companies today is how to extract more oil from the discoveries made in the last 40 years. Estimates vary, but approximately 66% of the discovered oil gets left in the ground. The International Energy Agency has estimated that if, in the next 20 years, this figure could be reduced to 50%, then this would increase the world's recoverable oil by 1.2 trillion ...


    By atg UV Technology

  • Solving waste oil management and removal problems in power generating plants

    If your plant is like most, it is doing a good job of preventing oily water waste and waste oils from escaping into the environment. But at what cost? As labor resources dwindle, operating and maintaining drainage systems, oil separators, and sometimes inadequate oil removal equipment is expensive. Paying higher than needed costs for waste oil disposal, filtration and water treatment due to these ...


    By Oil Skimmers, Inc.

  • Overview of Rotating Disc Electrode (RDE) Optical Emission Spectroscopy for In-Service Oil Analysis

    Introduction The basis of modern oil analysis is the use of optical emission spectroscopy (OES) to measure the ppm (parts per million) levels of wear metals, contaminants and additives in oil samples. Whatever else an oil lab may measure, a multi-elemental analysis is the core of in-service oil analysis. This paper gives an overview of Rotating Disc Electrode Elemental Spectroscopy and its ...


    By Spectro Scientific

  • Emergency response and clean-up of a diesel leak: manufacturing facility

    Project: Emergency response and clean-up of a diesel leak Client: Confidential manufacturing company Services: Emergency response planning, environmental assessment, regulator liaison, remediation design Summary: Through rapid site characterisation and expert decision making ESI minimised the environmental damage ...

  • BioCycle world

    The Climate Action Reserve (CAR) Board of Directors unanimously adopted the Organic Waste Digestion (OWD) Project Protocol, which provides a standardized approach for quantifying, monitoring and verifying greenhouse gas (GHG) reductions from organic waste diversion projects. Development of the OWD protocol was described in a detailed article in last month’s BioCycle, “GHG Reductions From Organic ...


    By BioCycle Magazine

  • Moving difficult-to-handle bulk materials with flexible screw conveyors

    Flexible screw conveyor systems can be engineered to transport bulk materials that tend to pack, cake, smear, break apart or fluidize, and can prevent the separation of blended products. Flexible screw conveyors (Fig. 1) are suitable for most bulk materials, from sub-micron powders to large pellets, both free-flowing and non-free flowing. They are capable of conveying bulk materials at any angle ...


    By Flexicon Corporation

  • The number one thing we can do to protect Earth’s oceans

    Marine governance favors consumption and commerce over conservation. Here's what we can do about it. When New England fishers complained of working harder and harder to catch fewer and fewer fish, Spencer Baird assembled a scientific team to investigate. Though a fishery failure would once have seemed inconceivable, Baird wrote in his report, “an alarming decrease of the ...


    By Ensia

Need help finding the right suppliers? Try XPRT Sourcing. Let the XPRTs do the work for you