oil encapsulator Articles

  • Laser induced release of encapsulated noble gas in SCHOTT receiver

    Thermo oil based parabolic through technology is limited to operational temperatures close to 400°C due to the decomposition of the heat transfer fluid and accompanying hydrogen permeation into the vacuum annulus. The presence of hydrogen in the annulus leads to an increase of thermal losses and a decrease in thermal efficiency. In order to overcome this so-called ‘hot tube ...

  • Hydraulic Oil Spill on Roadway

    Fuel Oil Soaked Wood. Contact was made to our office in May/2007 regarding the wood base underneath an oil/kerosene furnace system which, upon removal, it was discovered that kerosene had leaked and was somewhat permeated, leaving an odor. With over-time saturation of the wood, we recommended multiple treatments. After use of our Terracap 3000/4000 kit, we received the following in a letter: "I ...


  • Surface Decontamination of Crude Oil by DeconGel 1101 and 1102

    ABSTRACT Surface decontamination efficacy determination of DeconGelTM 1101 and 1102 on aluminum, stainless steel, and concrete surfaces contaminated with Crude Oil (polyaromatic hydrocarbons fraction) was performed with LC/MS (Liquid Chromatography/Mass Spectrometry) according to Environmental Protection Agency (EPA) SW-846 Methods: 3500C (sampling), 8321B (analysis), and 1654A (Analysis of ...


    By METIS Scientific

  • Surface Decontamination of Motor Oil by DeconGel 1101 and 1102

    Abstract Surface decontamination efficacy determination of DeconGel™ 1101 and 1102 on aluminum, stainless steel, and concrete surfaces contaminated with Motor Oil (polyaromatic hydrocarbons fraction) was performed with LC/MS (Liquid Chromatography/Mass Spectrometry) according to Environmental Protection Agency (EPA) SW-846 Methods: 3500C (sampling), 8321B (analysis), and 1654A ...


    By METIS Scientific

  • Ivey-sol technology has potential to increase oil recovery of oil-sands waste by 15-25 percent

    Alberta’s oil sands are comprised of one of the world's largest sources of bitumen, containing an estimated 1.6 trillion barrels. About two tonnes of oil sands must be dug up and processed to produce one barrel of oil. Oil sands recovery processes include extraction and separation systems to remove bitumen from sand and water. Separating the oil from the sand is difficult and costly, and getting ...


    By Ivey International Inc.

  • Surface Decontamination of PCBs (PCB-laden oil) by DeconGel 1101 and 1102

    Abstract Field testing aboard the USS Missouri maritime museum vessel showed that excellent surface decontamination was achieved by applying DeconGel™ 1102 onto contaminated surfaces, resulting in encapsulation of PCB contaminant by DeconGel's active components. For all contaminated surfaces tested, EPA PCB limit standards (Regulations 761.79, 761.123) of < 10 ug/100 cm2 were ...


    By METIS Scientific

  • Remediation of refinery waste, oil sludge from lagoons and contaminated soils - case study

    The first VacuDry plant installed at a refinery is designed to treat waste which has accumulated over the last decades, as well as waste that will be generated inside the refinery in the future. The semi-mobile system has a capacity of 1.5 to 2 tons per hour. The plant is designed for maximum flexibility and can treat different types of refinery wastes ranging from dry soil to wet centrifuge ...


    By econ industries GmbH

  • Selenium Removal

    The oil refinery was in search of a feasible solution for the removal of selenium. Discharge permit changes by the EPA require a reduction of 50% from current levels. Integrated Engineers, Inc. was given an opportunity to perform a feasibility test to determine a treatment process as well as estimated operational costs. The best process was to adjust the pH from 7.0 to 10.0 using caustic, ...


    By Integrated Engineers Inc.

  • Synthesis and characterisation of magnetic-luminescent composite colloidal nanostructures

    In this communication, we report a review of our works on luminescent and magnetic bifunctional structures in the nanoscale range. The synthesis and characterisation of various colloidal nanostructures such as Y3Fe5-xAlxO12-TRITC, γ-Fe2O3?Cs2Mo6Br14@SiO2 and γ-Fe2O3-QDs will be presented. At the outset, the first synthesis of aluminium substituted garnet Y3Fe5-xAlxO12 by the citrate gel process ...


    By Inderscience Publishers

  • Grade `A` remediation - selective phase transfer technology cleans up college in Moncton, New Brunswick

    Remedialing sensitive areas or population dense areas can be tricky at the best of times. So it's important to utilize a remediation technology with a proven record of reducing environmental and health and safely risks in order to avoid associated legal liability for project stakeholders, among other reasons. Ivey International Inc. is a Canadian company with offices in Campbell River, B.C., ...


    By Ivey International Inc.

  • Remediation of silty-clay hydrocarbon contaminated site using Ivey-sol selective phase transfer technology

    Earlier this year, Ivey International Inc. secured its first remediation project in Alberta using its Ivey-sol Selective Phase Transfer Technology (SPTT). This patented technology is being used to treat extensive soil and groundwater contamination at an active service station in Red Deer, Alberta. With a residential area nearby, the environmental sensitivity is relatively high. Unfortunately, ...


    By Ivey International Inc.

  • THE ISSUE: An Overlooked & Underlying Source of

    According to and as of the 2000 U.S. Census, there are 105 million 'occupied' households in the United States. Each household is disposing of Fats, Oils and Greases (FOG) and other Household Hazardous Wastes (HHW), as the EPA refers to them, at the approximate rate of One (1) gallon per month through various methods; some legal and some not. The currently mandated methods and policies ...


  • NORMs contamination treatment using Ivey-sol technology

    NORMs (naturally occurring radioactive materials) are found almost everywhere, and many natural materials, such as the earth’s crust, contain such radioactive materials. So what happens when oil and gas activities such as petroleum refining and natural gas extraction, disturb such radioactive material? They can alter the natural background radiation — the radiation that we are naturally exposed ...


    By Ivey International Inc.

  • Liberating contaminants for easy recovery

    The number one challenge associated with most site remediation designs and methodologies is that 90-95 per cent of all environmental contaminants are present in an adsorbed phase onto soil and bedrock surfaces within both saturated and unsaturated zones. Contaminants, including hydrocarbons (LNAPL), chlorinates (DNAPL) and heavy metals, are sorbed onto the substrates and so have reduced mobility ...


    By Ivey International Inc.

  • Rapid blending of nutraceuticals in a restricted space

    Although vitamins and minerals have long been a mainstay in health maintenance, a new category of health maintenance products has created an entirely new market over the last two decades. The term "nutraceutical" was first defined in 1989 by Stephen DeFelice, M.D. as "... food, or parts of a food, that provide medical or health benefits, including the prevention and treatment of disease." Since ...

  • Axion: is ‘storing’ waste plastics better than burning?

    As global temperatures head for potentially catastrophic levels, landfilling rather than burning waste plastics might be better for the environment, suggests Keith Freegard, Director of Axion Polymers. Landfill or incineration: what is the best disposal route for our waste plastic materials? Large numbers of energy-from-waste (EfW) plants exist right across Europe and many of ...

  • Canada’s Other Energy Boom – Energy infrastructure is on the move.

    When it comes to energy infrastructure, Canada is on the move. Of course, that may seem like nothing new, given Canada’s lengthy energy history, particularly in the oil and gas industries. In this latest chapter, however, electricity is playing a major role. A confluence of factors have helped spur the need for more generation, which in turn is driving still another form of energy ...


    By GLOBE Foundation

  • New life for the artificial leaf?

    Research in laboratories around the world is moving the promise of artificial photosynthesis closer to reality Sandwiched between rows of bottled chemicals and racks of drying glassware on the third floor of Harvard University’s Mallinckrodt laboratory, four thumbnail-size bits of pinstriped silicon hang from a thin ...


    By Ensia

Need help finding the right suppliers? Try XPRT Sourcing. Let the XPRTs do the work for you