oxygen monitoring control system Articles

  • Oxygen Monitors for the New Millennium

    Oxygen monitors have become a required piece of safety equipment for many industrial and laboratory environments, where the release of certain toxics can create an area unsafe for living beings (human or animal).  When making a purchasing decision on any oxygen detection monitor, one need look no further than the sensor cell found at the heart of the monitor.  While each oxygen ...

  • Boiler Dissolved Oxygen Control

    DISSOLVED OXYGEN CHEMISTRY Dissolved Oxygen (DO) is a measure of the amount of oxygen, usually thought of as a gas, that is dissolved in a liquid such as water. Oxygen is essential to life and is also the most common element found taking part in corrosion reactions. DO can be thought of as the fuel needed for the corrosion process to proceed. It is the corrosion reactions that necessitate ...


    By IC Controls Ltd.

  • Oxygen Monitor for FOUPs in Semiconductors and Cleanrooms

    Over time, the contamination control requirements in the semiconductor industry have become more stringent. Employees now must spend more time adhering to cleaning protocols to preserve the sanitary nature of the environment and comply with regulations. The front-end unified pod (or FOUP) began appearing in semiconductors in the 1990s, serving as a transportation box to safely and ...

  • Changes to guidelines for oxygen monitoring in Italy

    New guidelines for the storage of nitrogen have been established in Italy which highlight changes to oxygen monitoring procedures. These guidelines are approved by the Italian National Transplant Centre, which is a technical ...


    By Analox Sensor Technology

  • Air Separation Plants and the Use of Oxygen Monitors

    Air separation plants are critical for many different industries, from clean energy to manufacturing. Nowadays, cryogenic is the most common type of distillation used to separate air into its component gases - nitrogen, oxygen, and inert gases including helium and argon. If your industry relies on air separation for product development or manufacturing, then knowing how the process works is ...

  • Automated oxygen analyzer application systems- automatic oxygen controller improves efficiency of ultrasonic atomising of solder powder

    In the past most industrial solder pastes were made using oxidised powder produced by simple air atomisation. Pressure to improve the control of the size range of solder pastes, and to avoid the use of corrosive halide fluxes, has led to a demand for lower oxide levels. In addition increased use of automated oxygen analyzer application systems has led to much more critical specifications for ...


    By Systech Instruments Ltd

  • ppb Dissolved oxygen measurement

    Dissolved oxygen (D.O.) measurement is one indicator of water quality because oxygen is a common element contributing to corrosion reactions. This corrosion reaction provides the need for low level D.O. control since dissolved oxygen is responsible for costly replacement of piping and equipment by corrosive attack on metah. what is Dissolved Oxygen? Dissolved axygan (D.O.f is the ...


    By IC Controls Ltd.

  • Continuous Oxygen Monitor Detects Leaks in Nitrogen Dewar Storage

    Extremely low maintenance oxygen (O2) monitor designed to continuously monitor confined spaces for low oxygen levels available from PureAire Oxygen Monitors. PureAire Oxygen Monitor is suitable in all environments containing nitrogen, helium, argon, or any cryogenic gases. PureAire is unaffected by temperature, humidity, barometric pressure, or any environmental changes. The instrument displays ...

  • PureAire Combines Oxygen and CO2 Sensors to provide a Dual Gas Monitor to the Marketplace

    As a recognized leader in O2 safety monitoring, PureAire recently explored the need for an O2 monitor where carbon dioxide is used. There are four key cryogenic gases; nitrogen, helium, argon, and carbon dioxide (CO2), which can create an oxygen deficient atmosphere. Material Safety Data Sheets (MSDS) covering cryogenic gases cite that a cryogenic leak can create an unsafe ...

  • Gas Monitoring for Ventilation Control and Energy Management

    The growing demand for underground and enclosed parking and maintenance garages (resulting from limitations on land availability) has increased the awareness and need for proper ventilation and control systems. In addition, increased health and safety programs have only added to the concerns of toxic and combustible gases in confined or enclosed spaces. Historically, ventilation and make-up air ...


    By Arjay Engineering Ltd.

  • Monitoring the variations of the oxygen transfer rate in a full scale membrane bioreactor using daily mass balances

    Oxygen transfer in biological wastewater treatment processes with high sludge concentration, such as membrane bioreactor (MBR), is an important issue. The variation of α-factor versus mixed liquor suspended solids (MLSS) concentration was investigated in a full scale MBR plant under process conditions, using mass balances. Exhaustive data from the Supervisory Control And Data Acquisition (SCADA) ...


    By IWA Publishing

  • Why it is important to measure Dissolved Oxygen in aeration lanes

    Dissolved Oxygen is a key parameter in the efficient treatment of waste water during the secondary treatment stage; the point at which organic waste is oxidised to form carbon dioxide, water and nitrogen compounds. It is important to act on accurate ...


    By Partech (Electronics) Ltd.

  • Oxygen Release Compound - Canada Case Study

    EHC-O Oxygen Releasing Compound - ES&E Magazine (May 2007) A whimsical comment by the author Michael McClary compels one to realize that more intuitive processes can be overlooked when considering technology’s abilities to improve our natural environments. He said: “Irrigation of the land with seawater desalinated by fusion power is ancient. It’s called rain.” In situ treatment of ...


  • Why it is important to measure Dissolved Oxygen in aeration lanes

    Dissolved Oxygen is a key parameter in the efficient treatment of waste water during the secondary treatment stage; the point at which organic waste is oxidised to form carbon dioxide, water and nitrogen compounds. It is important to act on accurate measurements of Dissolved Oxygen in activated sludge plants for the following reasons: To ...


    By Partech (Electronics) Ltd.

  • Reduced order model monitoring and control of a membrane bioreactor system via delayed measurements

    Activated sludge treatment is one of the most widely used processes for wastewater treatment (WWT). These systems are built with sufficient design margin to allow changes in loading and process conditions. This is necessary and prudent to overcome limitations in measurement, monitoring and controlling of WWT process parameters at the desired frequency. Online sensors for mixed liquor suspended ...


    By IWA Publishing

  • Use of online nutrient monitoring for automatic aeration and nitrate recycle pump control

    The Northside Wastewater Treatment Plant (WWTP) in Kinston, NC was expanded and upgraded in 2006 for biological nutrient removal (BNR) to meet limits of 3 mg/L total nitrogen (TN) and 1 mg/L total phosphorus (TP). In addition to the traditional approach of controlling the blowers based on dissolved oxygen (DO) readings, the City decided to implement an aeration basin blower control system using ...

  • NOx in Non-Utility Industries - Part II - Control options and monitoring methodology

     This the second in a two-part series. Part I, which appeared in our June 2001 issue focuses on air emission origins of nitrogen oxides (NOx) in non-utility industries. Choice of the NOx control technology is dependent on many factors, including regulatory requirements, technical feasibility, cost and public perception. Figure 1, compiled based on publications [1-5], presents a summary of ...


  • Sophisticated control system - effective ozone generator

    At the Freshwater Institute in Shepherdstown, West Virginia (USA) they are convinced that ozone water treatment is essential to optimize production in water recirculating aquaculture systems (RAS). Scientists at the Freshwater Institute have been studying ozonation for years but have never before used such a sophisticated ozone generator as the Primozone® Ozone Generator. The Freshwater ...


    By Primozone Production AB

  • Pure Oxygen Plus Nitrification? Biowin Modeling Plus Full-Scale Experience

    ABSTRACT High Purity Oxygen (HPO) activated sludge treatment and nitrogen removal do not have to be mutually exclusive. Some HPO activated sludge treatment facilities in relatively warm climates must address recently implemented or upcoming regulatory changes that require reduction of effluent nitrogen discharge levels. The 48.75 mgd capacity (annual average) Hollywood Southern Regional ...

  • Biofuels Gas Monitoring

    The Customer The Company is one of the world’s leading developers and producers of advanced fuels and green chemicals. The Process The Company uses a gasification process that breaks down wood chips, waste and other feedstock using plasma technology. The process produces a uniform synthetic gas (syngas) that is used to power their turbine engines. ...

Need help finding the right suppliers? Try XPRT Sourcing. Let the XPRTs do the work for you