parametric emissions monitoring Articles

  • The Pros and Cons of Predictive, Parametric, and Alternative Emissions Monitoring Systems for Regulatory Compliance

    This paper closely examines the pros and cons of using predictive, parametric, and alternative monitoring techniques for regulatory compliance. While many predictive and parametric monitoring systems are less expensive to install and operate than CEM systems and demonstrate exceptional relative accuracy test results, this paper will provide the reader with a better understanding of the ...

  • Parametric study of the dispersion aspects in a street-canyon area

    Most modern cities practically consist of street canyons, making monitoring of the level of their pollution an important issue. In this study, a Computational Fluid Dynamics (CFD) simulation of pollutant dispersion was performed for a real, complex-geometry street canyon for various wind directions and speeds. Typical street-canyon effects – like the formation of a longitudinal vortex for wind ...


    By Inderscience Publishers

  • Proposed boiler MACT sets aggressive emission limits

    On June 4, 2010, U.S. EPA proposed National Emission Standards for Hazardous Air Pollutants (NESHAP) for industrial, commercial, and institutional boilers and process heaters at both major and area sources of hazardous air pollutants (HAP) emissions.  EPA proposed separate rules for units at major sources of HAP emissions (greater than 10 tons per year [tpy] of any single HAP and/or greater ...


    By Trinity Consultants

  • Automating CFD for non-experts

    ABSTRACT The focus of the paper is on demonstrating how it is possible to automate complex CFD simulations using scripting language around and within the structure of the CFD command files. To illustrate this, the concept of an atmospheric pollution case is used and, more specifically, that of a water treatment plant. The code that is used is CFX-5 with PERL as a scripting ‘language’.The ...


    By IWA Publishing

  • EPA Proposed “Franken-MACT” for Utilities

    EPA published the highly anticipated proposed Maximum Available Control Technology (MACT) Standard for the utility sector (40 CFR 63 Subpart UUUUU). When considered together with the growing list of proposed and final rules impacting the utility sector (Transport Rule/Cross-State Rule, Coal Combustion Byproducts Rule, Cooling Water Intake Rule, Regional Haze Rule, revised National Ambient Air ...


    By Trinity Consultants

  • Is it better to burn or bury waste for clean electricity generation?

    The use of municipal solid waste (MSW) to generate electricity through landfill-gas-to-energy (LFGTE) and waste-to-energy (WTE)projectsrepresentsroughly14%ofU.S.nonhydrorenewable electricity generation. Although various aspects of LFGTE and WTE have been analyzed in the literature, this paper is the first to present a comprehensive set of life-cycle emission factors per unit of electricity ...


    By Novo Energy, LLC

  • Navigating NSPS subpart Db for boilers: a case study

    Over the past year, Trinity assisted a chemical company with the permitting and installation of a new 220 MMBtu/hr package boiler. The new natural gas-fired boiler replaces coal-fired units that were installed in the 1940s. Navigating through the numerous, and at times conflicting, regulatory requirements applicable to such a unit has been challenging. With careful planning and implementation, ...


    By Trinity Consultants

  • Cementing the PC MACT

    On September 9, 2010, the U.S. EPA promulgated the final amendments to the National Emissions Standard for Hazardous Air Pollutants from Portland Cement Manufacturing Industry (40 CFR 63 Subpart LLL), also known as the PC MACT. EPA’s self-proclaimed “historic” rulemaking includes some important implications for cement manufacturers and other sources that may be subject to ...


    By Trinity Consultants

  • New air quality rules challenge oil & natural gas industry

    EPA Administrator signed a suite of proposed new air regulations affecting both the Production/Processing and Transmission/Storage sectors of the oil and natural gas industry. The proposed rules mandate the use of emission controls as well as work practices through two different air regulatory programs – New Source Performance Standards (NSPS) and National Emissions Standards for Hazardous ...


    By Trinity Consultants

  • Actio at tip of the green manufacturing revolution

    What began as an idea in a technology clean room has evolved into a globally-sought software platform system for the modern, environmentally-regulated marketplace. Actio Corp. was co-founded in 1996 by former college classmates — Russ McCann, a veteran high-tech entrepreneur from Silicon Valley, and Kal Kawar, a chemical engineer and industrial hygiene expert. McCann said the company was ...


    By Actio Corporation

  • EPA finalizes boiler NESHAP

    EPA published the final National Emission Standards for Hazardous Air Pollutants (NESHAP) for industrial, commercial, and institutional boilers and process heaters at both major and area sources of hazardous air pollutants (HAP) emissions. EPA developed separate rules for units at major sources of HAP emissions (greater than 10 tons per year [tpy] of any single HAP and/or greater than 25 tpy of ...


    By Trinity Consultants

  • Mercury Control Demonstrations

    C1.1 | Halogens and Sulfur in Coals and their Influence on Co-benefit Mercury Capture Bernhard Vosteen | President, Vosteen Consulting Gmbh Not only the range of the coal mercury content itself, but also the range of the native halogen and sulfur contents in coal are of great influence on co-benefit mercury capture, wet and dry. The ...

Need help finding the right suppliers? Try XPRT Sourcing. Let the XPRTs do the work for you