particle monitoring equipment Articles

  • Office Printers Emit Ultra fine particle pollution

    We’ve heard quite a bit about particulate matter PM10s and PM2.5s as components of air pollution that we are exposed to on a daily basis. Recent research papers are highlighting the dangers of ultra fine particles (UFPs), which have a diameter of less than 0.1 micrometres (or 100 nanometres). By contrast, the diameters of particulate pollution from PM10s and ...


    By Commercial Air Filtration

  • Automated Oil Particle Analysis Helps Prevent Gearbox Failures

    The major issue for premature failure in wind turbine gearboxes is bearing failure, which leads to gearbox failure. A wind turbine gearbox will not survive if the oil is not clean and especially if the hard ferrous particles are not removed from ...


    By Spectro Scientific

  • The Master of Hydrant Flow Test Equipment

    Our range of hydrant flow test equipment offers many benefits that provide data that you can rely on. Here are 10 reasons why. 1. Record ...

  • Why monitor dust in the workplace?

    Almost any place of employment can present a potential threat to health and safety from airborne particulates and aerosols. It is important to note, however, that dust hazards are not necessarily visible to the human eye and that the finest particles can represent the greatest threat because of their ability to travel deepest into the lungs. Effective monitoring is therefore key to the ...


    By Ashtead Technology Ltd

  • Media expansion monitoring improves filtration

    In municipal surface water treatment plants, optimum filter performance is a crucial component. Filtration is the primary treatment process at water treatment plants, and backwashing is the primary means to keep filters functioning properly to produce safe drinking water for the public. Since 2000, Entech Design, Inc. has used underwater acoustic sensing technology to monitor filter media ...


    By Entech Design, Inc.

  • Did You Know that GRIMM Measuring Stations are Equipped with Lufft Weather Sensors?

    Do you already know our system partner GRIMM Aerosol Technology? Their aerosol measuring systems are in use all over the world where the focus lies on inorganic and organic aerosols as well as greenhouse gase. In the following article we present you three spectacular applications in the deepest jungle, on a frosty mountain peak and in a busy metropolitan area… About GRIMM Aerosol Technik ...

  • Oxygen Monitor for FOUPs in Semiconductors and Cleanrooms

    Over time, the contamination control requirements in the semiconductor industry have become more stringent. Employees now must spend more time adhering to cleaning protocols to preserve the sanitary nature of the environment and comply with regulations. The front-end unified pod (or FOUP) began appearing in semiconductors in the 1990s, serving as a transportation box to safely and ...

  • New laser-based dust emission monitoring system

    Abstract A new generation of continuous particulate matter concentration monitoring instruments is presented, covering a measuring range of 0 to 1000 mg/m3. The laser-based scattered light instrument gives an improved stability as well as excellent resolution in the low range. This enables high concentration measurement as well as especially low emission monitoring down to 0.01 mg/m3 with a ...


    By SIGRIST - PHOTOMETER AG

  • Silver Membranes in Monitoring Respirable Crystalline Silica

    Crystalline silica, most commonly found in the form of quartz, is a basic component of the earth; it’s found in soil, sand granite, and other minerals. During many industrial processes, crystalline silica is released as particles that are 100 times smaller than beach sand.1 Due to their size, these mineral particles cannot easily be cleared by human lungs. Instead, they persist in the ...


    By Sterlitech Corporation

  • Air Separation Plants and the Use of Oxygen Monitors

    Air separation plants are critical for many different industries, from clean energy to manufacturing. Nowadays, cryogenic is the most common type of distillation used to separate air into its component gases - nitrogen, oxygen, and inert gases including helium and argon. If your industry relies on air separation for product development or manufacturing, then knowing how the process works is ...

  • OSU Researchers Deploy Stevens Equipment in Study of Green Infrastructure Treatment for Groundwater Runoff

    Stormwater runoff pollution is a serious issue that faces almost every urban and suburban environment. In older city infrastructure, runoff from roofs, parking lots, and streets flows directly into the sewer system and must be handled by the municipal wastewater treatment facility, increasing the amount of work the system must undertake. For the past 30 years, the infrastructure for stormwater ...

  • High resolution environmental monitoring to support the development of water quality legislation - Case Study

    Aquaread Ltd, an award winning British manufacturer of multi-parameter water quality test equipment, are supplying monitoring equipment and research funding to support the development of improved water quality guidelines across Europe. The research is being conducted in collaboration with scientists at the Aquatic Research Centre at the University of Brighton, and is already influencing ...


    By Aquaread Limited

  • Work Safely in Dusty Environments

    Dust is a term used to describe all airborne particles – these can be wood, stone, flour, concrete, grain, mould or asbestos particles as well as fumes and chemicals. Many activities create dust. Larger dust particles get lodged in the nose and throat while the smaller more dangerous particles get lodged deep in the lungs – these dust particles are the ones that can cause fatal ...


    By DustWatch CC

  • Selecting an Air Sampler for Bioaerosol Collection

    Indoor Air Quality (IAQ) investigators should select cost effective, efficient and the highest quality samplingequipment for evaluation of indoor environments. Particle impaction onto an adhesive surface (non-viable) or into culture media (viable) are the most widely used techniques to evaluate the presence and levels of airborne bioaerosols, particularly in non-industrial indoor environments. ...

  • Case study - Safety, Protection against corrosion and cabinet pressurisation in refineries

    The environment in a refinery is highly corrosive. This makes it necessary to deploy control systems not only to protect staff but also to protect the equipment controlling the processes, in order to ensure their reliability. Bioconservacion has equipment that is specially designed for the safety of staff, and for protecting against corrosion in control rooms and cabinet pressurisation equipment. ...


    By Bioconservacion SA

  • TopAir`s Laminar Bench

    TopAir is the flagship brand of Statitech Ltd., a leading manufacturer of cleanroom products since 1999. One of TopAir’s premier product lines includes the laminar bench. The laminar bench is a combination stainless steel worktop that provides a smooth, clean surface and an overhead airflow/filter system that removes unacceptable particles from the air before they reach the work area. ...


    By TopAir Systems

  • Surface flows from images: ten days of observations from the Tiber River gauge-cam station

    Fully remote surface flow measurements are crucial for flow monitoring during floods and in difficult-to-access areas. Recently, optics-based surface flow monitoring has been enabled through a permanent gauge-cam station on the Tiber River, Rome, Italy. Therein, a system of lasers and an internet protocol camera equipped with two optical modules afford video acquisitions of the river surface ...


    By IWA Publishing

  • Black Carbon – the elephant in the room!

    Traditionally, ambient particulates have been measured gravimetrically according to their size. However, in this article Jim Mills, Managing Director of Air Monitors, will demonstrate that the time has come to change or at least augment the way ambient particulates are monitored and regulated. Air Monitors has supplied most of the UK's ambient monitoring network, but Jim will explain why the ...


    By Air Monitors Ltd.

  • Biodiesel versus diesel: a pilot study comparing exhaust exposures for employees at a rural municipal facility

    Many organizations interested in renewable, domestic energy have switched from petroleum diesel to biodiesel blends for use in transportation and heavy-duty equipment. Although considerable evidence exists on the negative health effects of petroleum diesel exhaust exposures in occupational settings, there has been little research examining biodiesel exposures. Working collaboratively with a local ...

  • Oil Analysis for Hydraulic Systems

    Hydraulic systems are used in industrial, mobile and aviation applications to transmit power to operate equipment. They are incredibly efficient, compact, and lightweight relative to a mechanical equivalent. Hydraulic fluids transmit force in the system, and as such are carefully chosen by the system maker. Chemical stability, high flash and fire points, viscosity, and oxidation resistance are ...


    By Spectro Scientific

Need help finding the right suppliers? Try XPRT Sourcing. Let the XPRTs do the work for you