particulate emissions monitor Articles

  • Selection of Particulate Monitors

    The installation and operation of continuous particulate emission monitors in industrial processes has become well developed and common practice in industrial stacks and ducts over the past 30 years reflecting regulatory monitoring requirements. It supports requirements originating from LAPPC (Local Air Pollution Prevention and Control), IPPC (Integrated Pollution Prevention and Control), WID ...


    By PCME Ltd

  • The Use of Particulate Emission Monitors to Support Arrestment Plant Operation and Upkeep

    The operation of filtration type arrestment plant can be optimised by the effective use of Particulate Emission Monitors (eg Filter Leak Monitors and Filter Performance Monitors). Particulate Emission Monitors are installed throughout the broad spectrum of industrial processes to satisfy regulations (IPPC, Part B Guidance Notes, WID and LCPD) for emission limit enforcement. In addition, where ...


    By PCME Ltd

  • Continous Emission Monitoring (CEMs)

    Presented in Track B1: CEMs at EUEC 2011,January 31 Phoenix, Arizona   B1.1  | Particulate CEM for wet FGD plant William Averdieck |  Managing ...

  • Emission Testing and Monitoring

    Presented in Track B4: EMISSION TESTING & MONITORING at EUEC 2011, January 31 Phoenix, Arizona B4.1  | Update on PM2.5 and Condensable Particulate Matter Emissions Measurement Methods Larry Hottenstein |  Partner, Environmental Resources Management Following the promulgation of the PM2.5 ...

  • Practical Implementation of EN-14181in Particulate Monitoring - Case Study

    Introduction This case study summarises the results of implementing particulate monitoring according to EN-14181 in a municipal incinerator operated by SUA in Teesside, UK, with a ProScatter M type particulate instrument (Model PCME QAL 181). It also provides a comparison of results for monitoring the same stack with an ElectroDynamic particulate instrument (Model PCME QAL 991). This case ...


    By PCME Ltd

  • Total solution: Gas and particulate analysis in Cement industry

    Cement plants are increasingly required to install continuous emission monitoring systems (CEMS). While these represent a significant financial outlay, a range of other factors also need to be considered when selecting a suitable CEMS. To the inexperienced, selecting a suitable CEM can mistakenly be considered as simply ensuring that the applicable national regulations (eg MACT in the USA, ...


    By Environnement S.A

  • Global solution: Gas and particulate analysis in Cement industry

    Cement plants are increasingly required to install continuous emission monitoring systems (CEMS). While these represent a significant financial outlay, a range of other factors also need to be considered when selecting a suitable CEMS. To the inexperienced, selecting a suitable CEM can mistakenly be considered as simply ensuring that the applicable national regulations (eg MACT in the USA, ...


    By Environnement S.A

  • New laser-based dust emission monitoring system

    Abstract A new generation of continuous particulate matter concentration monitoring instruments is presented, covering a measuring range of 0 to 1000 mg/m3. The laser-based scattered light instrument gives an improved stability as well as excellent resolution in the low range. This enables high concentration measurement as well as especially low emission monitoring down to 0.01 mg/m3 with a ...


    By Sigrist-Photometer AG

  • Compliance to standards in continuous emissions monitoring case study

    Customer: Glass Manufacturer Application: Continuous Emissions Monitoring Service (CEMS) for Glass Manufacturing Background: A glass factory is required to ...


    By Ecotech Pty Ltd

  • Applied comprehensive NO2 and particulate matter dispersion modelling for Switzerland

    This paper presents the NO2 and Particulate Matter (PM) dispersion modelling for the whole of Switzerland. Air quality maps are computed for the year 2000 and future years. Future developments like the EURO-4 legislation on motor vehicles are taken into account. For all major source groups (road traffic, off-road traffic, industry, households, etc.), separate countrywide emission inventories with ...


    By Inderscience Publishers

  • Roadside particulate levels at 30 locations in the Kathmandu Valley, Nepal

    Roadside particulate levels (PM10) at 30 locations throughout the Kathmandu Valley, Nepal are reported. There were seven sampling cycles from January to December 1999. PM10 levels ranged between 1000 and 6000 µ/m³ for 1-h sampling. There was no consistent trend in PM10 levels with respect to monitoring cycle, average precipitation or wind speed. There is no WHO ...


    By Inderscience Publishers

  • Formation of atmospheric nitrate under high Particulate Matter concentration

    This study was primarily initiated to understand the consistently moderate levels of nitrogen oxides (NOx) in Indian cities in spite of increasing NOx emissions. The research objective was to understand NO3? formation as a NOx function, and other atmospheric constituents. For this purpose, air quality ...


    By Inderscience Publishers

  • Study of particulates and metallic elements at a farm sampling site in central Taiwan

    The total suspended particle (TSP) concentration, dry deposition and wind speed were measured with a PS-1 sampler, a dry deposition plate and a Weather Monitor II (#7440), respectively, at the Experimental Farm of Thunghai University in Taiwan. Taiching Industrial Park, Taichung Cong Road (traffic) and a hospital incinerator are close to the sampling site. The sampling time was from August 2001 ...


    By Inderscience Publishers

  • A Special Issue of the Journal of the Air & Waste Management Association on the Particulate Matter Supersites

    This special issue of the Journal of the Air & Waste Management Association contains 15 peer-reviewed scientific papers from the specialty conference Particulate Matter Supersites Program and Related Studies, which was held in February 2005 in Atlanta, GA. Other peer-reviewed papers will appear in companion issues of the Journal of Geophysical Research, Aerosol Science and Technology, and ...

  • Metal Coating Emission Control

    The use of regenerative thermal oxidizers is expanding into applications where they wouldn’t have been considered years ago, says Mike Scholz As the first generation of oxidizer systems in the industry nears the end of their service life, many canmaking plants face repair or replacement of their existing air pollution control systems. Like many others in the industry, a Silgan canmaking ...

  • Dust monitoring

    Generally, two different approaches are used to measure the amount of dust deposited on a surface; Determination of the soiling of a surface, by a change in its properties; Determination of the quantity of dust deposited, by weight. WHAT IS DUST? Dust is a generic term used to describe fine particles that are suspended in the atmosphere. Dust comes from a wide variety of sources, including soil, ...


    By Queensland Laboratory

  • Long-term simulations of particulate matter in Europe on different scales using sequential nesting of a regional model

    A regional model system for the simulation of air quality in Europe (EURAD) has been employed for long-term calculations of atmospheric pollutants on different scales. The model allows sequential nesting. Starting with a domain covering most of Europe, the nesting procedure was used to scale down the simulations to a highly populated and industrialized area, namely NorthRhine-Westphalia (NRW). ...


    By Inderscience Publishers

  • Mesoscale controls on particulate matter pollution for a mega city in a semi-arid mountainous environment: Tehran, Iran

    Tehran, the mega-city capital of Iran, suffers from high concentrations of PM10 throughout the year. Emissions from transport combined with mesoscale atmospheric features related to the mountainous terrain lead to a distinctive diurnal pattern in concentrations. Air quality data from monitoring stations show that the highest concentrations of PM10 are in the morning and evening periods, ...


    By Inderscience Publishers

  • Reduced Emissions for Landfill Gas Installations

    The use of landfill gas as a source of renewable energy is increasing. For environmental and safety reasons, the owners of the waste storage sites have to strictly monitor and control the construction, operations, and emissions generated. Sulzer offers solutions to control these emissions within the limits given by the government. Landfill gas is similar to natural gas, but it is created by ...


    By Sulzer

  • Assessment of levels and “health-effects” of airborne particulate matter in mining, metal refining and metal working industries

    The increased awareness of occupational health, hygiene and safety in recent years has resulted in improvement of working conditions and in reducing workers’ exposure to many toxic substances. However, substantial hazards remain, the number of cases of occupational illness due to hazardous exposure is still high, and new cases will continue to occur if there are no further improvements. During ...

Need help finding the right suppliers? Try XPRT Sourcing. Let the XPRTs do the work for you