ph probe Articles

  • pH Probe Maintenance

    The success or failure of pH measurement depends on the proper application of the probe and proper subsequent maintenance of the probe. The procedures described within apply to the most common pH probe in use today and that is the flat surface combination pH probe. The most common failure mode associated with pH probes is breakage. The pH electrode is a very thin glass membrane that is easily ...


    By Digital Analysis Corp.

  • pH Electrode Architecture

    A pH Electrode can be compared to a battery in that an electrical voltage is generated between two points that is a function of water chemistry. In the case of a pH electrode the voltage potential is a function of the acidity or alkalinity of the solution in which it is immersed. Note: The terms pH electrodes and pH probes are often used synonymously, despite the fact that there are differences. ...


    By Digital Analysis Corp.

  • pH Adjustment - A Primer

    A brief review of the definition of pH, the pH scale, and some of the chemistry involved in pH Adjustment systems is provided below. For some this may be trivial, yet for many others this may be useful. The information provided below is typical of the background information we provide in our training classes / seminars. By Definition pH is the measure of free hydrogen activity in water and can be ...


    By Digital Analysis Corp.

  • Monitoring pH and ORP in a SHARON reactor

    This paper analyses the valuable information provided by the on-line measurements of pH and oxidation reduction potential (ORP) in a continuous single high ammonia removal over nitrite (SHARON) reactor. A laboratory-scale SHARON reactor equipped with pH, ORP, electric conductivity and dissolved oxygen (DO) probes has been operated for more than one year. Nitrogen removal over nitrite has been ...


    By IWA Publishing

  • Getting back to basics: What is pH?

    Getting back to basics: What is pH? The most used measure in wastewater treatment, and for good reasons The “potential of hydrogen” or “pH” is the measure of free hydrogen activity in water and thereby indicative of the measure of its free acidity or free alkalinity. Gauged on a numeric scale of 0-14, solutions with a pH of less than 7.0 are acids. ...

  • New Guide from METTLER TOLEDO on Increasing pH Sensor Lifetime

    Proper care of pH sensors can dramatically increase their lifetime. A new guide from METTLER TOLEDO explains, step-by-step, how Intelligent Sensor Management (ISM®) technology provides maximum lifetime for pH probes. Urdorf, Switzerland – Over time and through use, pH sensors are affected by their measuring environment and require cleaning, calibrations and adjustments to ensure ...


    By Mettler - Toledo Int. Inc

  • What are the key steps in measuring pH? Why do I need to calibrate?

    pH is a useful parameter which is used across all industries for quality control, environmental monitoring, lab work and much more. There are 10 key steps which should be followed to ensure pH measurements using a meter are accurate. pH is a useful parameter which is used across all industries for quality control, environmental monitoring, lab work and much ...


    By Camlab Limited

  • The effects of the ph-influenced structure on the dielectric properties of Kaolinite–water mixtures

    The properties of clay–water mixtures are reflected in their wide-frequency dielectric responses that result from different polarization mechanisms. This feature is useful in various soil science applications but has not been systematically investigated. The objective of this study was to characterize the broadband dielectric spectrum of kaolinite sediments with different charge properties and ...

  • Can I use two probes of the same type with a Hach HQ40D meter?

    Yes – two probes of the same type can be used with the Hach HQ40D. The Hach HQ40D is a multi meter with ...


    By Camlab Limited

  • Buy Smarter – what questions should you ask when buying a pH meter?

    When you’re looking to buy a pH meter, whether it’s to start measuring or to replace an existing meter, the range of brands and specifications available is huge. With so many options it can be difficult to know where to start, but taking a little time to choose carefully could save you a lot of time and money overall by making sure the meter you choose is right for ...


    By Camlab Limited

  • Impact parameters investigation of DNA immobilisation process on DNA sensor response

    This paper studies impact parameters of DNA sequence immobilisation on DNA sensor response. The parameters were examined including immobilisation time, carbon nanotubes concentration, DNA probe concentration and pH value. The DNA probe sequences were immobilised on surface of microelectrodes by using multi–walled carbon nanotubes (MWCNTs) as mediator. The hybridisation between DNA probe and DNA ...


    By Inderscience Publishers

  • Near field optical microscopy: a brief review

    Near Field Optical Microscopy (NSOM) has evolved into a mature member of the family of scanning probe microscopy. In this article, we briefly go over the principle of NSOM, its breakthroughs and setbacks. We will describe some of the most commonly used NSOM modalities and conclude with the recent advances based on optical nanoantennas. We will then highlight the potential of this high–resolution ...


    By Inderscience Publishers

  • Komax teflon lined mixer simplifies acid injection for power plant

    A major source of waste water in many power plants is the waste stream that results from ion exchange used for demineralizing the boiler feed water. The alkaline regeneration waste stream produced by the ion exchange process requires the addition of an acid to this stream before discharge from the plant. Regulatory authorities typically require the effluent to have a near neutral pH before ...


    By Komax Systems, Inc.

  • Investigation of the use of TiO2 doped with metal ions in water disinfection

    This research was conducted to improve titanium dioxide by transition metal doping using cooper. Sol gel method was used to prepare metal doped TiO2. Titanium isopropoxide and commercial TiO2 P25 were employed as catalyst precursor. The role played by the varied preparation parameters such as doping level and pH of solution discussed with respect to the final photoreactivity. Photoreactivity was ...


    By IWA Publishing

  • Continuous emission monitoring and control of packed tower odor control systems using the sycamore CEM

    ABSTRACT Packed-tower chemical scrubbers, with sodium hydroxide (caustic) and sodium hypochlorite (bleach), are commonly used to treat foul air from wastewater treatment processes. The available control mechanisms include a pH probe and controller for the sodium hydroxide feed, an oxidation reduction potential (ORP) probe with a controller toestablish the bleach feed, and proprietary ...

  • Results of heavy metals and other water quality levels in tap water from Çan sourced from Ağı Dağı (Mt. Ağı) (Çanakkale, Turkey)

    In this study, the concentrations of heavy metals Pb, Cu, Zn, Cd, Ni, Fe, Mn and Cr were determined using an inductively coupled plasma and optical emission spectrophotometer (ICP-OES), and water quality parameters pH, temperature, and conductivity were measured using the YSI 556 MPS water probe. The water samples were collected monthly from five different street tap water points sourced from ...


    By IWA Publishing

  • Treatment of kraft evaporator condensate using a thermophilic submerged anaerobic membrane bioreactor

    The feasibility of using a thermophilic submerged anaerobic membrane bioreactor (SAnMBR) for kraft evaporator condensate treatment was studied at 55±1°C over 6.5 months. Under tested organic loading rate of 1–7 kg COD/m3 day, a soluble COD removal efficiency of 85–97% was obtained. The methane production rate was 0.35±0.1 L methane/g COD and the produced biogas was of excellent fuel quality with ...


    By IWA Publishing

  • Water quality in the Arosa Bay

    Background One of the great impediments to further development of shellfish aquaculture in the north-west region of Spain isa perception that industry expansion and tourism could have negative environmental effects on the coastal waters. Especially the bay around Villagarcia de Arosa is very famous because of its excellent areas for shellfish farming. The government of Spain is ...

  • Design and Evaluation of a Flow Pump System for Column Testing

    The design of the equipment components of a flow pump system for the measurement of solute (effluent) breakthrough curves from soil columns is described. In addition, the performance of the system in terms of the effects of equipment components and temperature on measured differential pressure fluctuations across soil specimens is illustrated. The flow pump for the system provides continuous flow ...


    By ASTM International

  • Two environmental laboratories, 1 private and 1 government, optimize automation and ROI with investment in BOD/Titrate duo (case study)

    MANTECH INC. is a leading manufacturer of automated multi-parameter, titration, BOD and COD laboratory instruments. Both a Private and Government Environmental Laboratory required optimized return on investment for both automated BOD/CBOD and automated multi-parameter systems. They each invested in the MANTECH BOD/Titrate Duo. Background Each laboratory identified ...


    By MANTECH INC.

Need help finding the right suppliers? Try XPRT Sourcing. Let the XPRTs do the work for you