pipe maintenance Articles

  • How Does a Water Flow Meter Work?

    A water flow meter is a device that measures the amount of water flowing through a pipe. There are several water flow meter technologies to choose from depending on the water measurement application, maintenance requirements, and budgetary terms.  Each of these types of water flow meters has a unique principle of operation, specific application benefits, and overall ...


    By Sierra Instruments, Inc.

  • Clarifier maintenance

    Clarifiers are expensive, to buy or repair, and their downtime can be costly in fines imposed by regulatory agencies and in community ill will. Regular maintenance, an annual inspection of the mechanism and an occasional touchup of the paint or coating system are simple and inexpensive proactive steps that will usually prevent most problems. Three components of all clarifiers require maintenance: ...


    By WesTech Engineering, Inc.

  • Checklist for Boiler Maintenance

    Boilers play a crucial role at industrial facilities and it is imperative that they be safely and properly maintained. Routine boiler maintenance can help prevent unplanned shutdowns and outages, increase the efficiency of the boiler and cut operating costs, and ensure that the facility is in full compliance with all laws and regulations governing boiler safety. What follows is a boiler ...


    By STI Group, Inc.

  • Maintenance for septic tanks

    Septic tanks are widely used for on site sewage treatment for domestic homes which are not connected to the sewer system. Little attention is given to the septic tank until there are problems such as smells or poor drainage or ponding on the surface. A little maintenance of the septic tank can be very helpful in maintaining performance of the septic tank. The outflow from a septic tank percolates ...


    By Biofuture Ltd

  • Everything Depends on Pressure And Maintenance

    Energy and cost efficiency of biological treatment plants Every biologically working sewage plant needs a compressed air station for the oxygen supply of the aeration basin. This station only works at the highest possible energy efficiency level if excessive plant pressure through the subordinated system, excessive intake temperatures due to insufficient aeration and deaeration, and ...

  • Pump Maintenance Know-How

    It’s no secret that a pump that runs at peak efficiency uses less fuel, experiences less downtime and costs less to operate. The time you spend maintaining your pump is actually an investment in its lifetime performance and value. In fact, there are many ways that a diligently maintained pump can reduce your costs, while increasing efficiency. For instance, by ensuring your pump investment ...


    By Gorman-Rupp Co.

  • The daily maintenance of slurry pump

    1) TheSlurry pump suction piping system does not allow leakage phenomenon, into the pool pump can pump through the grille Multi-stage pumps should be consistent with requirements ...


  • The Asbestos Management and Maintenance Program

    STEP ONE: ASSESSMENT AND SURVEYThe first step of the Asbestos Management Program is to do an asbestos survey to assess the location, identify the type of asbestos, the condition of the asbestos and identify a maintenance record. This asbestos inventory or assessment is usually carried out by an independent consulting firm. This assessment or survey will include: Identification and location of the ...


  • Cleaning & maintenance management

    Mercury is a known neurotoxin that is extremely toxic even in small amounts. It directly affects the central nervous and renal systems, causing developmental delays, motor and brain problems like those associated with autism. Mercury’s hidden danger also lies in when at room temperature and exposed, it vaporizes readily. Once it has become an aerosol, it is absorbed into the lungs and ...


  • Intake Pipe Repair

    Major problems can cause catastrophic damages to a facility’s operations. The accumulative cost of: repairs, labor, and downtime can add up. This 24 inch diameter intake pipe, located at a U.S. Power Plant, was leaking above the ground just below the disc valve. The plant’s maintenance engineers needed a proven, reliable and economical solution to fix this ...


    By ENECON Corporation

  • Combined application of Pipe Penetrating Radar and LIDAR for large diameter pipe inspection

    Abstract: Pipe Penetrating Radar (PPR) is the underground in-pipe application of ground penetrating radar (GPR), a non-destructive testing method that can detect defects and cavities within and outside mainline diameter (>18 in./450mm) non-metallic (reinforced concrete, vitrified clay, PVC, HDPE, etc.) underground pipes. Light Detection and Ranging (LIDAR) has become an accepted method for ...


    By SewerVUE

  • In-pipe monitors turn dreams into reality

    In-pipe monitors turn dreams into reality The quality of tap water has improved enormously in recent decades, but for largely technological reasons, until recently, knowledge of water quality between the treatment works and the tap has been an almost impossible dream for water treatment and distribution network managers. In this article, Jo Cooper, Product Specialist at Intellitect Water, will ...


    By Intellitect Water Ltd

  • Flame Arrester Maintenance - Offshore Oil Platforms

    Poorly maintained, corroded or damaged flame arresters may not be capable of providing the explosion protection they were designed for. If your flame arresters look anything like these then you need to contact us immediately. Flame arresters are used to protect people, plant and equipment by suppressing in-pipe deflagrations and detonations, preventing a flame from entering or leaving a pipe or ...

  • Residential Sewer and Drain Pipe Line Repairing by Pipe Bursting Method

    One responsibility a homeowner must accomplish is the regular maintenance and repairs around the house. The scale goes up according to how pressing the problem is. Decisive action must be done for emergency situations, especially when it comes to sewer line emergencies. As soon as you notice the pipes leaking or backing up, you’ll need to immediately have it inspected and repaired. If not, ...


    By TRIC Tools Inc.

  • Safety Manual of The Plugco In Pipe Plugs

    Stay Clear While the Plug Under Pressure!!! The End User must read and understand this Plugco Safety Manual before using the plug. The failure of a plug for any reason including improper maintenance, installation or use can result in bodily injury, death and/or property damage! 1-BEFORE USING THE PLUG [1.1] Read and understand this Plugco ...


    By PLUGCO

  • Using InfoNet to manage a planned sewer maintenance program

    OnSite is a framework contractor for Severn Trent Water, one of the ten water service companies of England and Wales. The company is one of the project coordinators for the utility’s planned sewer maintenance programme and one of three framework contractors working in very close collaboration on its CCTV survey and sewer cleansing program. In addition the company undertakes man-entry surveys, ...


    By Innovyze

  • Unique technology for monitoring piped water

    INTELLITECT WATER has launched a unique, highly innovative drinking water monitoring technology that will revolutionise the delivery of drinking water. The new technology monitors the quality of water in pipeline distribution networks and for the first time provides reliable data to protect the integrity of the water quality, to enhance customer satisfaction and to improve operational efficiency. ...


    By Intellitect Water Ltd

  • Plugging `hot` pipes in extreme environments

    Some of the world's most intricate infrastructure is found in power plants, chemical plants, refineries, and other factories that use and combine industrial chemicals. The piping for fuel, chemical transport, water supply, and cooling needs is typically very complex and subject to high temperatures and pressures. And since plants are harsh environments, it's a given that piping needs regular ...


    By Petersen Products Company

  • Sustainable, Low-maintenance Disinfection for Onsite Systems

    Most of the regulations applicable for onsite wastewater treatment system are based on the use of native soil for effluent dispersal. However, there are more and more situations where dispersal of effluent in native soil is impossible: repairs of existing systems on undersized lots for implementation of required dispersal fields: sites located in soils having low permeability: or where the ...


    By Premier Tech Aqua

  • Seven Maintenance Considerations for Stormwater Filtration Systems

    All stormwater BMP’s will require maintenance at some time or time interval. Long-term maintenance costs and maintainability are very important considerations. Here are some other things you should consider when discussing maintenance of your stormwater filtration system. 1. Evaluate availability of maintenance contracting. It is the nature of filters to occlude with ...

Need help finding the right suppliers? Try XPRT Sourcing. Let the XPRTs do the work for you