pipe-to-manhole Articles

  • Building Energy Modeling 101: HVAC Design and Operation Use Case

    A great deal of energy use in buildings goes toward heating, ventilation, and air-conditioning (HVAC). In 2015, HVAC consumed 15.5 quads. The first step in reducing HVAC energy use is reducing heating and cooling load—i.e., the amount of heat that needs to be added to or removed from a building—typically by reducing heat from equipment and lighting; minimizing unnecessary ...


    By US Department of Energy

  • What 2017 holds for Energy from Waste in the UK

    The UK’s EfW industry has enjoyed two decades of stable investment under the public private partnership (PPP)/public finance initiative (PFI) regime. This has led to a reduction in the amount of biodegradable household waste sent to landfill via the construction of local authority-backed EfW plants and contributed to an increase in recycling rates by incorporating facilities that remove ...


    By GPT Waste Management Ltd

  • 99% of Interceptor contamination remediated - Case study

    What is an Interceptor Tank? An interceptor tank is a trap used to filter out hydrocarbon pollutants from rainwater runoff. It is typically used in road construction and on petrol station forecourts to prevent fuel contamination of the water table via runoff. Petrol interceptors work on the premise that some hydrocarbons such as petrol and diesel float on the ...


    By Slick Solutions

  • How a Specialized Automatic Control Valve Solved Flooding

    The Colombian area of Antioquia creates much of its clean power from hydropower plants along the Guadalupe River. The Guadalupe IV hydroelectric plant generates power with three vertical axis turbines that discharge water below the river level. To prevent flooding, however, the plant needed a solution that ensured the ejector ...


    By Singer Valve Inc.

  • Control Algae and Improve the Water Quality in Waste Stabilization Ponds

    Due to population growth, accelerated urbanisation and economic development, the quantity of waste water generated is increasing globally. Mainly in low-income areas, a large proportion of the waste water is discharged directly in the environment. When the waste water is treated, the treatment plants may not remove certain pollutants that can have a negative impact on the people and ecosystem. ...


    By LG Sonic

  • Manhole Relining in the Keystone State

    Manhole Relining in the Keystone State Mt. Carmel (Pa.) Board of Trustees Turns to Epoxy Lining to Save Failing Structures Exerpts from Trenchless Technology Magazine, September 2005 issue Given that estimates for the total amount of sanitary sewer pipes in the United States top 500,000 miles, it is easy to understand how sometimes manholes can be overlooked. But manholes are a big ...

  • How Tempe Controls Manhole Odors

    Untitled Document Summary: The adjacent cities of Tempe and Mesa, Arizona, rely on a combined wastewater collection system comprising 434 miles of sanitary sewer lines and more ...


    By Calgon Carbon Corporation

  • Development and Deployment of a Real-Time Remote Continuous Monitoring System for Manholes

    A new system for the detection of septic sewer overflows (SSOs) and unauthorized intrusions of manholes has been developed jointly with public water agencies in San Diego County, California. The goal of the project is to provide detection of SSOs early enough to deploy personnel to provide preventative action. The system has been in operation since May of 2005 and has detected and, with field ...

  • The HERMES TECHNOLOGIE System For Manhole Cover Repair And Regulation On Streets

    The Problem Due to the heavy traffic or because of mistakes in the past construction and using wrong materials, we have the problem that manhole covers will collapse. On this way they become a dangerous area for the daily traffic. The Solution HERMES TECHNOLOGIE developed a System for easy workmanship including special materials and machines for ...


    By HERMES Technologie Ltd.

  • Balancing growth and conservation - Precast concrete manholes become part of the stormwater solution

    When American Fork, Utah, decided to approve construction of a 175-acre commercial center, the city engineers had to consider the environmental effect it would have on a 45-acre wetland right next door. Under the EPA´s Phase II Storm Water Rules, adapted in late 1999, almost any city large enough to require a storm sewer system must balance growth with the environmental impacts of ...


    By BaySaver Technologies, Inc.

  • M-Coating – drain & sewer spraylining the economical solution to manhole shaft renovation

    M-Coating – Procedure for renovating a manhole shaft using ERGELIT Kombina KS M-Coating is a new, innovative renovation technique for both round and rectangular drainage shafts from 500mm to 1200mm. It is based on over 15 years of the Hermes company’s experience. Using this centrifuge spray technique, walls of shafts up to 10 metres deep can be coated to a realistic thickness. ...


    By HERMES Technologie Ltd.

  • Quantitative pipe condition assessment with Pipe Penetrating Radar

    Abstract Pipe Penetrating Radar (PPR) is the underground in-pipe application of GPR, a non-destructive testing method that can detect defects and cavities within and outside mainline diameter (>18 in / 450mm) non-ferrous (reinforced concrete, vitrified clay, PVC, HDPE, etc.) pipes. The key advantage of PPR is the unique ability to map pipe wall thickness and deterioration including voids ...


    By SewerVUE

  • Biocorrosion in drinking water pipes

    Copper is widely used in drinking water distribution systems due to its relatively low cost and favorable mechanical properties. However, copper corrosion may generate copper concentrations exceeding the thresholds prescribed by international drinking water standards. In-situ measurements performed in an actual system found that the copper mass released under flowing water conditions (pipe ...


    By IWA Publishing

  • Intake Pipe Repair

    Major problems can cause catastrophic damages to a facility’s operations. The accumulative cost of: repairs, labor, and downtime can add up. This 24 inch diameter intake pipe, located at a U.S. Power Plant, was leaking above the ground just below the disc valve. The plant’s maintenance engineers needed a proven, reliable and economical solution to fix this ...


    By ENECON Corporation

  • ELiTE vacuum pipe lifter_Standard

    Product data sheet_Vacuum pipe lifter 12000kg ...


    By Schoenbeck GmbH & Co. KG

  • Quadratic approximations for pipe friction

    This paper develops quadratic approximations to the classical models of Darcy–Weisbach and Hazen–Williams for frictional head loss in water pipes. Key elements of the technique are selecting the approximation domain and minimizing the relative error. A comparison for individual pipes over a range of diameter, roughness, and Reynolds number showed that the approximation provides ...


    By IWA Publishing

  • Preventing & Thawing Frozen Pipes

    A “how-to” guide on preventing and thawing frozen pipes. As temperatures drop below freezing around the country, it’s important to be informed of the cold weather’s effect on your water pipes. When temperatures are below freezing, pipes in unheated areas are subject to freezing causing messy, and often expensive issues. Just one burst pipe running at 4-8 ...


    By WaterSignal

  • Combined application of Pipe Penetrating Radar and LIDAR for large diameter pipe inspection

    Abstract: Pipe Penetrating Radar (PPR) is the underground in-pipe application of ground penetrating radar (GPR), a non-destructive testing method that can detect defects and cavities within and outside mainline diameter (>18 in./450mm) non-metallic (reinforced concrete, vitrified clay, PVC, HDPE, etc.) underground pipes. Light Detection and Ranging (LIDAR) has become an accepted method for ...


    By SewerVUE

  • Corporate information_Ceramic clay pipe Industry

    Corporate information_ Schoenbeck GmbH & Co. ...


    By Schoenbeck GmbH & Co. KG

  • Measuring Strains in Buried Flexible Pipes

    A field measurement system is described for determining strains in buried flexible pipes. The microprocessor-based system obtains data that is subsequently analyzed on minicomputers or mainframe machines. The field system is also capable of analyzing the data using its own microprocessor provided that a graphics terminal is available. Numerical algorithms for analyzing the data are developed, and ...


    By ASTM International

Need help finding the right suppliers? Try XPRT Sourcing. Let the XPRTs do the work for you