point gas detector Articles

  • Ammonia Vent Line Gas Detector

    The LPT-A Vent Line Ammonia Transmitter (P/N: LPT-A-VLT-NH3-S) is designed for continuous monitoring of ammonia levels in the vent lines of refrigeration systems caused by equipment failure or system over pressurization. Slow leaks of refrigerant can be costly over time and a dangerous situation could present itself if a high pressure release were to occur. The VLT provides continuous, ...

  • Survey of standards related to gas detectors

    Recent events both on- and off-shore shine a bright light on the need for attention to safety and to hazard reduction, prevention, and mitigation. Errant combustible or toxic gases can injure and kill quickly. Therefore, mitigation of these hazards must be fast and sure. Globally, governmental and regional authorities take gas detection and system integration very seriously and require that the ...

  • Benefits of HART Communication-Enabled Gas and Flame Detectors

    Catastrophic results can occur when a fire or a flammable/toxic gas release goes undetected in any petrochemical facility. For early warning and prompt hazard mitigation, flame detectors and gas detectors are essential tools. Clear, usable, diagnostic information from these detection instruments is extremely valuable in ensuring the devices are properly maintained, tested, and poised to protect ...

  • A Guide to Gas Detector Tubes. Your Questions Answered

    Gas detector tubes are easy to use, are low cost, and the method is intrinsically safe, allowing it to be deployed in all industries. Because detector tubes don’t require calibration, users see the benefits of this technology over electronic gas detectors due to their ease of ...


    By a1-cbiss

  • Selecting and Placing Gas Detectors for Maximum Application Protection

    Many industrial processes involve dangerous gases and vapors: flammable, toxic, or both. With the different sensing technologies available, and the wide range of industrial applications that exist, selecting the best sensor and locating them properly for the job at hand can be a challenge. To ensure a high level of safety, know the latest sensing technologies, which technology is best for the ...

  • IR Gas Detector Provides Rapid Response

    The advanced Model IR400 Point IR Combustible Gas Detector from General Monitors features an industry-leading three-second T90 response time to the presence of combustible hydrocarbon-based gases, which allows plant operators to respond quickly to gas leaks and ...


    By General Monitors

  • Laser gas detector systems for greenhouse gas emissions monitoring

    Two types of portable laser based gas detector for measuring emissions of the greenhouse gases carbon dioxide (CO2) and methane (CH4) from oil and gas operations are described. A scanning open path detector was developed within a Cooperative Research and Development Agreement (CRADA) with the USEPA. This system scans multiple paths across an area source in rapid succession, enabling calculation ...


    By Boreal Laser Inc.

  • Gas detector communication technology for offshore oil and gas platforms

    In few applications is safety as important as on offshore oil and gas platforms. Explosive hazards from hydrocarbon gases and vapours are an ever-present risk, whilst toxic hydrogen sulphide gas and depleted oxygen environments can pose significant risks to personnel. Gas detectors are therefore essential to provide dependable early warning of gas hazards. Gas detectors are permanently installed ...

  • Safety Systems Depend on Reliable Field Sensors (Emphasis on Fire and Gas Detectors)

    Abstract Because not all hazards are the same, identifying and quantifying the hazard is the starting point in choosing sensing technology. Not all detectors are the same, and they should be selected according to their ability to detect the hazard. This paper gives a broad summary of technologies that provide users reliable responses to hazardous conditions, that minimise false ...

  • Portable laser gas detector systems for landfill CH4 and CO2 monitoring

    There has recently been a marked increase in interest in detecting and quantifying emissions of the greenhouse gases (GHG) carbon dioxide (CO2) and methane (CH4) from landfills in North America and Europe. The primary drivers for this increased interest are: new and pending legislation requires demonstrated reductions in GHG emissions; permits to expand existing facilities require more accurate ...


    By Boreal Laser Inc.

  • A Comparison of Point Sensors and Open Path Monitors For Toxic Gas (esp. HF) Monitoring

    Point Sensors Ion Mobility Spectroscope (IMS) – a gas sample is ionized by a radioactive source (Ni63). Differences in ion drift under the influence of an applied electric field produce a spectrum that is dependent on the mass, charge, and shape of the component ions. The detector signal and strength is tuned to the drift time of the ion of interest (in this case HF) and signal strength is ...


    By Boreal Laser Inc.

  • Honeywell gas detectors serve emergency backup role in U.S. rocket launch to destroy spy satellite

    A U.S. Standard Missile 3 (SM-3) enabled by Honeywell technology recently shot down a rogue U.S. spy satellite in space carrying over 1000 pounds of hydrazine, a highly toxic chemical used in rocket fuel. Meanwhile, Honeywell Analytics gas detection technology played a critical backup role in the operation: the company’s Single Point Monitor (SPM) was deployed at over 25 FEMA locations throughout ...


    By Honeywell Analytics, Inc.

  • Not All Hazards are the Same: Design considerations for matching flame and gas hazards to detector technologies

    Not all flame and gas hazards in facilities are the same, therefore the detection technology chosen should be specific to the type of hazard to be detected. How do users select technologies to see certain fires or detect certain gases? The intent of this paper is to give a broad introduction to the selection and use of flame and gas detector technologies. We will answer questions such as these: ...

  • Compressed Gas Safety Guide

    Use and storage of any compressed gas under high pressure can be extremely dangerous if proper gas handling procedures are not observed. Moreover, chemical characteristics of specialty gases themselves can pose serious health hazards if containment is not tightly controlled. Paying close attention to a compressed gas product’s technical and safety information is invaluable for maintaining a safe, ...

  • The latest ground Gas monitoring innovations

    The latest Ground Gas monitoring innovations   The traditional methodology for ground gas monitoring has been ‘spot monitoring’ – taking event readings at various set times to predict the sub surface gas regime on both on Brownfield and Landfill sites.     This methodology is in general current practice under both the EU Landfill Directive ...


    By Shawcity Limited

  • Understanding the Benefits of Fixed Gas Detection

    "Fixed gas detection is an essential method of ensuring maximum protection for personnel and plant. There are a variety of technologies available for a multitude of applications. Understanding fixed gas detection is the first step in providing safety." What is fixed gas detection? Fixed gas detection is installed with the aim of providing continuous, area and personnel protection. ...


    By a1-cbiss

  • Monitoring flammable gas in boiler houses

    The most common fuels in use for space and water heating are Oil, Natural Gas and Liquid Petroleum Gas (LPG). By far the most popular, clean and cost effective solutions are utilising Natural Gas or LPG. The traditional safety measure derived from the time of oil fired boiler houses is the use of a fusible link placed above the each boiler. The fusible link is intended to melt if it becomes ...

  • Upgrading from Pellistor Gas Sensors to Infrared Technology

    In this article Andy Avenell, Crowcon’s Fixed Systems Product Manager, considers the shift towards infrared (IR) gas sensor technology in the oil and gas industry. Abstract Flammable gases and vapours can present considerable dangers in many industrial applications, none more so than the processes involved in extracting, transporting and processing oil and gas. Fast and reliable ...

  • Developing Technologies to Detect Hydrogen Sulfide (H2S) Gas

    Abstract Hydrogen sulfi de (H2S) gas can cause nausea, headaches, unconsciousness, and death. Industries struggle to detect this deadly substance before it harms workers or communities. Safety system manufacturers have developed detectors that sense the H2S quickly and accurately. This paper illustrates, in general terms, considerations in effective placement of H2S detectors: ...

  • Is your Plant as tight as you think? Leak Detector for extremely toxic Gases, a Field Test Report

    Leak detection of commodity gases in chemical plants is a day-to-day practice. The sensor technology available for this application is field proven and reliable. No question about it, existing sensors will do the job. However, in plants manufacturing or handling extremely toxic substances, the picture is different. For example, take phosgene. The existing sensor technology for leak detection ...

Need help finding the right suppliers? Try XPRT Sourcing. Let the XPRTs do the work for you