polymer dosing pump Articles

  • Optidose polymer

    Maintaining a minimum concentration of an effective dispersant polymer is crucial in an alkaline cooling water treatment program. The problem is knowing exactly how much polymer is available in the cooling water to combat fouling and corrosion of heat transfer equipment. Many years of research and effort have gone into the development of a method for tracing the concentration of polymers. Rohm ...


  • BM Respirometry Study Toxicity & Biodegradability of a Refinery polymer stream, when treated in the activated sludge process of the plant - Case Study

    This “batch system” respirometer consists of: a single thermostatically controlled vessel, divided into two interconnected compartments with closed recirculation loop between the two. A constant air flow is supplied via a ceramic diffuser in the conditioning compartment, and a combined oxygen/temperature sensor in the reaction compartment controls the DO and temperature. Both ...


    By SURCIS, S.L.

  • Pumping Polyelectrolyte in waste water treatment

    The Challenge An industrial waste water treatment company required a cost effective solution to pumping polyelectrolyte. The plant engineers approached Verderflex distributor, Global Pumps Australia, for a solution to the following problems: Existing helical rotor pumps were expensive to run and maintain The replacement pump would have to be able to ...

  • Mono nov tailors pumping solutions for allied colloids

    Based in Bradford, Allied Colloids’ Engineering Equipment division is responsible for providing customers withthe appropriate technology to ensure that the chemicals manufactured by its production division are utilised efficiently. A number of pumps were required to fulfil two main duties on the flocculant preparation and dosing rigs; a largerpump to transfer the mixed and aged flocculant at ...


    By NOV Mono - Mono Pumps Ltd

  • Verderflex Peristaltic Industrial Pumps excel in diverse applications

    Verderflex Industrial peristaltic pumps are extremely robust pumps, ideal for heavy duty operations on intermittent or continuous duty cycles. They are a simple to use, easy to control, versatile and reliable way to pump liquids. Verderflex Industrial pumps can be used in a broad range of applications: Anaerobic Digestion Sludge Transfer Verderflex pumps were specified due ...

  • Peristaltic Pumps - A lot more than just heavy duty

    By design, the peristaltic pump is ideal for the dependable handling of abrasive, corrosive, viscous, high density and high solid content fluids. It thrives in those applications where other types of pump fail. Water and waste water industries, mining and chemical processing are all prime markets for this workhorse. But being equal to the tough demands of these applications is far from its only ...

  • Whole Life Costs and pumping Technology – Peristaltics Increasingly Out on Top

    Untitled Document Whole life costs are playing an ever-more important role in pump selection by the water and wastewater industry. Interestingly, energy use is no longer the ...

  • Rotomite 6000 dredge system - centennial coal-case study

    Centennial Coal's Mannering Colliery mine averages over 1M tons of coal per year when operating at full capacity. The mine's run-off ponds' sludge issues prompted Centennial to contact Dredging Solutions, SRS Crisafulli's Dealer in Australasia, and an experienced dredging contractor.  Dredging solutions deployed the Crisafulli Rotomite 6000 auger suction dredge system because of the ...


    By SRS Crisafulli, Inc.

  • High Rate Clarifier Start-up and Operation in Shreveport, Louisiana

     ABSTRACT In 2004, the city of Shreveport received permits from the Louisiana Department of Environmental Quality and the U.S. Environmental Protection Agency to construct and operate a high rate clarifier (HRC) at both the North Regional and Lucas wastewater treatment plants. The HRC provides wastewater treatment for flow in excess of the peak plant capacities. Each HRC unit uses ...

  • City of Stromsburg, Nebraska - Case Study

    In May 2011, AdEdge Water Technologies was selected among other vendors by Miller & Associates to supply a turnkey arsenic and manganese treatment system for the Village of Stromsburg, Nebraska. Arsenic levels in the water ranged from 0.0178 mg/L to 0.0276 mg/L and the manganese levels fluctuated between 0.05 mg/L and 0.12 mg/L, well above the EPA maximum contaminant levels of 0.010 mg/L ...

  • Case study – bakery application

    Introduction Clean Water Technology, Inc. is the creator of the Gas Energy System (GEM), the most advanced primary treatment system on the market. The GEM System provides superior reduction of total suspended solids (TSS), biological and chemical oxygen demand (BOD/COD), fats, oils and grease (FOG) and turbidity. Challenge A renowned Bakery and Savory manufacturer in Southern ...


    By Clean Water Technology, Inc.

  • One of the largest ipp power plants in the middle east uses membrane desalination for boiler feed water

    The Facility Sidi Krir Unit 3 & 4 Power Plant, developed by InterGen and Edison SpA, is located about 30 kilometers west of Alexandria, Egypt. It is a natural gas fired power plant and at 685 MW generating capacity, is the largest IPP thermal power plant in the Middle East. The plant consists of two power blocks, which share a common membrane based Seawater Desalination system ...

  • Case Study - ADC (Eastanglia) Ltd.

    Key facts Company ADC (Eastanglia) Ltd. Location Bonnets Lane, PE188JE Wisbech England Web www.adceastanglia.co.uk Simon Moos solution AVC/DOD - On-site dewatering Customer profile ADC (East Anglia) Ltd. is based with their ...


    By Simon Moos Maskinfabrik A/S

  • Wastewater-Solids Dewatering Odor Control - Case Study

    Background The Milan Wastewater Treatment Plant, located just south of Moline, Illinois, is a 1.7 MGD (6,434 m3/day) activated sludge facility with an average wastewater flow of 700,000 gpd to 800,000 gpd. This facility dewaters primary sludge using a belt filter press (Figure 1). The press operates an average of three times per month, 8 hours per day at a pump rate of 100 gpm. The ...


    By Carus Corporation

  • Wastewater Treatment at Meat Processing Plant - Case Study

    The client Our client produces and sells a variety of beef products, including fresh, frozen, canned, both vacuum packed or packaged in a protective atmosphere. They also offer a completerange of cuts and processed hamburgers, ready pre-cooked meals, veal cutlets, grilled and roasted products. The company is the market leader in the frozen hamburger sector, with an annual production ...


    By IDRAFLOT

  • Meat processing case study

    Design & Build of a Wastewater Treatment Plant The client Our client produces and sells a variety of beef products, including fresh, frozen, canned, both vacuum packed or packaged in a protective atmosphere. They also offer a completerange of cuts and processed hamburgers, ready pre-cooked meals, veal cutlets, grilled and roasted products. The company is the market leader in ...

  • CH#826 - Municipal Oxidation Ditch

    BackgroundThe treatment plant at this Midwestern City is a well operated facility treating approximately 1.1 mgd municipal waste from the surrounding community. Over the past several years the publicly owned treatment works has consistently been able to produce an excellent quality effluent with respect to BOD, suspended solids, ammonia and phosphate. To achieve this level of treatment, the ...


    By BIO-SYSTEMS International

  • Miller Argent case study

    On the hills above Merthyr Tydfil, Miller Argent is undertaking a highly ambitious land reclamation scheme that is also involving the extraction of coal by opencast methods. Known as the 'Ffos-y-fran Land Reclamation Scheme', this is the third and final phase of the East Merthyr Reclamation Scheme which is expected to run for another 17 years. The reclamation works will include the removal of ...


    By Partech (Electronics) Ltd.

  • Egg plant treatment in Belgium

    DESCRIPTION OF WASTEWATER TREATMENT FACILITY Between 3 and 4 million eggs are broken daily, 5 days a week, to produce egg-white, egg-yolk, and some mixed egg products for a total of 900 - 1000 tons of end-products per week. All is done under the highest hygienic standards. The wastewater treatment plant was built 10 years ago, when the egg breaking capacity was at 1.5 million eggs per day and ...


    By BluePlanet Labs

Need help finding the right suppliers? Try XPRT Sourcing. Let the XPRTs do the work for you