portable combustion analyzer Articles

  • Comparative Evaluation of Test Methods for Reciprocating Engines; EPA Reference Methods vs. Portable Analyzer

    Abstract This is a comparative evaluation of errors in testing engines using reference methods and portable analyzers. New Mexico Environment Department (NMED) Air Quality Bureau has published a guidance document, Standard Operating Procedure (SOP), Use of Portable Analyzers in Performance Tests. EPA provides guidance on reference method testing in 40 CFR 60, Appendix A. This document is ...


    By Trinity Consultants

  • Detecting Gases: What You Can`t Smell Can Hurt You

    Walking through a drill-site area, a worker smells rotten eggs and stops tor a minute or two to assess where a gas leak might exist. Rubbing his itchv eves as he investigates further, he notices that he no longer smells the tell¬tale hydrogen sulphide odour. He does not realize that the gas has deadened his olfactory senses and unless he leaves the area within seconds, he could lose ...

  • Advances in flashpoint testing: economic impact

    Flashpoint testing is one of the oldest methods of the ASTM D02 Committee on Petroleum Products and Lubricants, which was formed in 1904. The most prevalent standards are ASTM D56 (Tag Method), D92 (Cleveland Method), and D93 (Pensky-Martens Method). These classical techniques, commonly referred to as open-cup and closedcup methods, share a common principle: A test flame is lowered into the ...

  • Lead in Paint and Soil in Karnataka and Gujarat, India

    Blood lead surveys in several areas of India have found very high percentages of children with elevated blood lead levels. Fifty-three percent of children under 12 years of age in a sevencity screening had blood lead levels equal to or greater than 10 μg/dL, the level currently considered elevated by the U.S.  Centers for Disease Control and Prevention (CDC). A number of these surveys ...

  • A novel spectrometer design for process and handheld infrared spectral measurements

    Introduction Infrared spectroscopy offers many unique advantages for measurements within an industrial environment. Historically, the technique has been used for a broad range of applications from the composition of gas and liquid mixtures to the analysis of trace components for gas purity analysis. In cases where a well-defined method of analysis is involved, such as the measurement of ...


    By CIC Photonics, Inc.

  • Selecting and Placing Gas Detectors for Maximum Application Protection

    Many industrial processes involve dangerous gases and vapors: flammable, toxic, or both. With the different sensing technologies available, and the wide range of industrial applications that exist, selecting the best sensor and locating them properly for the job at hand can be a challenge. To ensure a high level of safety, know the latest sensing technologies, which technology is best for the ...

  • Preparing for EPA’s mandatory reporting of greenhouse gases rule

    Recent action by the US EPA to finalize the Mandatory Reporting of Greenhouse Gases (GHG) Rule means that environmental managers must now seriously examine whether they are fully prepared to address the imminent requirements. This article provides some assistance by summarizing key points regarding the final versus proposed rule, providing clarification on key questions that have arisen since the ...


    By Trinity Consultants

  • FTIR gas analysis improves container safety

    Introduction Entry to freight containers represents a significant hazard to staff responsible for inspection, stuffing or destuffing because of the large number of airborne chemicals that can be present. Research in Germany and the Netherlands found hazardous levels of gases and vapours in around 20% of all containers and this level of contamination is now accepted as commonplace. It ...


    By Gasmet Technologies Oy

  • Is your Plant as tight as you think? Leak Detector for extremely toxic Gases, a Field Test Report

    Leak detection of commodity gases in chemical plants is a day-to-day practice. The sensor technology available for this application is field proven and reliable. No question about it, existing sensors will do the job. However, in plants manufacturing or handling extremely toxic substances, the picture is different. For example, take phosgene. The existing sensor technology for leak detection ...

Need help finding the right suppliers? Try XPRT Sourcing. Let the XPRTs do the work for you