portable gas calibrator technology Articles

  • New White Paper on FTIR multigas analysis

    Quantitech has announced the publication of a free White Paper on the simultaneous measurement of multiple gases in a wide variety of applications using FTIR (Fourier Transform InfraRed) technology. With the ability to measure almost any gas, FTIR monitoring technology is employed in an enormous variety of applications including Continuous Emissions Monitoring, Stack Testing, Process Control, ...


    By Quantitech Ltd

  • How Often Should Gas Detectors be Calibrated and by Whom?

    Calibration frequency is one of the most commonly asked questions concerning the use of gas detection instruments. Common factors to consider when deciding how frequently to calibrate are: type of sensor, type of gas detector (fixed vs. portable), the required use and accuracy of the detector, manufacturer’s recommendations, how confident you are about the functioning of your instrument ...

  • Fixed Versus Portable Gas Detection – Which Is Better?

    Did you know that workers are needlessly injured every year as a result of leaking toxic or combustible substances? Such incidents are known to involve a wide range of hazardous gases (including ammonia, carbon monoxide, chlorine, hydrogen sulfide, hydrocarbon vapors and so on). The sad reality is that most of these accidents are avoidable if only the workplace is adequately monitored. This leads ...

  • Greenhouse gas emissions and reduction studies using a portable TDL gas monitor

    Boreal Laser's GasFinder is a portable open path gas monitor based on laser technology. GasFinder is uniquely suitable for studies of greenhouse gas emissions. It is specific to the gas of interest, provides one second response and has a broad dynamic range. GasFinder is permanently calibrated and is very small and light (less than 5kg). Alignment is easy and stable. No on-site electronic tuning ...


    By Boreal Laser Inc.

  • G100 portable CO2 incubator analyser for incubators gas readings

    The Geotech G100, which measures CO2 from 0-20%, is used to demonstrate accurate and repeatable CO2 readings of the atmosphere inside incubators. In just a few seconds an embryologist is able to take a reading from various incubators, all of which will have a different means of sampling the air inside an incubator, without fully opening the inner door and adversely affecting the environment. It ...


    By Geotech

  • Popular analysers are portable and rentable

    The MCERTS approved HORIBA PG-250 has been one of the most popular  instruments in Ashtead Technology’s fleet of rental equipment for a number of  years. Jay Neermul, the company’s Environmental Product Manager says “This  is because it is able to analyse CO, NO/NOx, SO2 and CO2 using standard  reference methods in a portable instrument that can be easily and ...


    By Ashtead Technology Ltd

  • Gas detector communication technology for offshore oil and gas platforms

    In few applications is safety as important as on offshore oil and gas platforms. Explosive hazards from hydrocarbon gases and vapours are an ever-present risk, whilst toxic hydrogen sulphide gas and depleted oxygen environments can pose significant risks to personnel. Gas detectors are therefore essential to provide dependable early warning of gas hazards. Gas detectors are permanently installed ...

  • FTIR gas monitor for diverse applications

    QUANTITECH, a leading supplier of environmental monitoring instrumentation, has recently supplied EURO Environmental Services in Ireland with a transportable Gasmet FTIR multiparameter gas analyser which EURO Environmental's Managing Director Geoff Fitzpatrick says, “is proving invaluable in many varied applications across a broad selection of industries.” With headquarters in Drogheda in Ireland ...


    By Quantitech Ltd

  • Understanding the Benefits of Fixed Gas Detection

    "Fixed gas detection is an essential method of ensuring maximum protection for personnel and plant. There are a variety of technologies available for a multitude of applications. Understanding fixed gas detection is the first step in providing safety." What is fixed gas detection? Fixed gas detection is installed with the aim of providing continuous, area and personnel protection. ...


    By a1-cbiss

  • Danger and Detection of Hydrogen Sulphide Gas in Oil and Gas Exploration and Production

    A rig worker smells rotten eggs near the well head, rubs his itchy eyes as he investigates the frosty pipe connections. After a few moments, he believes all is fine as he no longer smells the tell-tale hydrogen sulphide odour. In this scenario, we can only hope the worker recognises the danger and quickly leaves the site. Oil fields, especially mature ones, can produce hydrogen sulphide gas ...

  • Field Detection of Chlorinated Alkenes in Well Water using the FROG-4000 Portable GC - Case Study

    Introduction Defiant’s FROG 4000, a portable GCPID system, was used to identify and determine the concentration of chlorinated alkenes in several extraction wells located in Tacoma Washington. Split samples were taken at each well and sent to an offsite lab for analysis. This case study examines the field exercise and highlights the high degree of agreement between the offsite lab and ...


    By Northern ANI Solutions Ltd.

  • FTIR gas analysis improves container safety

    Introduction Entry to freight containers represents a significant hazard to staff responsible for inspection, stuffing or destuffing because of the large number of airborne chemicals that can be present. Research in Germany and the Netherlands found hazardous levels of gases and vapours in around 20% of all containers and this level of contamination is now accepted as commonplace. It ...


    By Gasmet Technologies Oy

  • Chlorine Dioxide gas detection: A comprehensive guide

    Introduction Some years agoago, the bleaching process in the paper industry was changed from using Chlorine (Cl2) as bleaching agent to Chlorine dioxide (ClO2). This was a challenge forThis posed a major challenge to industrial hygienists, as there were no sensors or detectors available that were specific to Chlorine dioxide: There was no sensor technology for gas detectors available that ...

  • Selecting and Placing Gas Detectors for Maximum Application Protection

    Many industrial processes involve dangerous gases and vapors: flammable, toxic, or both. With the different sensing technologies available, and the wide range of industrial applications that exist, selecting the best sensor and locating them properly for the job at hand can be a challenge. To ensure a high level of safety, know the latest sensing technologies, which technology is best for the ...

  • Wastewater Treatment Plant Monitors Greenhouse Gas Emissions

    Globally, little attention is paid to gaseous emissions from wastewater treatment processes. This contrasts greatly with the regulatory monitoring that is applied to the quality of water emissions from such facilities. However, in Helsinki, Finland, a large municipal wastewater treatment facility continuously monitors its emissions of greenhouse gases (GHGs) to help in the city’s efforts to ...


    By Gasmet Technologies Oy

  • Follow toxic gas standards for a smoother project

    Toxic gases, such as Hydrogen Sulfide and Sulfur Dioxide, can injure and kill quickly. Therefore, mitigation of these hazards must be fast and sure. The United States Occupational Safety and Health Administration (OSHA) and other authorities take detection of these gases very seriously. The American National Standards Institute/ American Petroleum Institute (ANSI/API) and ISA industry standards ...

  • Gas analysers support management of Swindon fire

    The capability to convene a multi-agency Air Quality Cell (AQC) was established in England in 2009 following the Buncefield Oil Storage Depot incident. A review of this event identified the need to rapidly co-ordinate the acquisition, analysis and interpretation of air quality data in major incidents. Arrangements have been made in England to bring together experts from the Environment Agency ...


    By Quantitech Ltd

  • 7 Factors to Help Maintain a Healthy Gas Leak Detection Programme

    We’ve put together seven important factors that are worth considering before, during and after use of gas leak detection equipment. Whether investing in refrigerant gas leak detection equipment as part of compliance for the F-Gas Regulations or for one of the other many benefits that gas leak detection offers, it is important to be aware of the key factors that can be put in place to help ...


    By a1-cbiss

  • FTIR analyser improves anaesthetic gas detection at Torbay Hospital

    A unique gas measurement technology has enabled South Devon Healthcare’s Pharmacy Manufacturing Unit (PMU) at Torbay Hospital to conduct highly effective and detailed analysis of anaesthetic gases in a variety of hospital locations. The primary function of the PMU’s quality control department is to check active ingredient levels and sterility in manufactured pharmaceutical ...


    By Gasmet Technologies Oy

  • FTIR gas analyzers support management of fire at UK waste facility

    The capability to convene a multi-agency Air Quality Cell (AQC) was established in England in 2009 following the Buncefield Oil Storage Depot incident. A review of this event identified the need to rapidly co-ordinate the acquisition, analysis and interpretation of air quality data in major incidents.  Arrangements have been made in England to bring together experts from the Environment ...


    By Gasmet Technologies Oy

Need help finding the right suppliers? Try XPRT Sourcing. Let the XPRTs do the work for you