portable infrared analyzer Articles

  • Simplified biofuels measurements with portable mid infrared analyzers

    Product quality begins at the production facility and extends to consumer filling station. Some process control or quality verification analyses can be done with quick and simple verification tests while others require more complete tests according to the ASTM or EN approved methods. Many crucial measurements can be performed by mid-infrared (IR) analysis. These measurements include free fatty ...


    By Spectro Scientific

  • Comply with Highly Regulated Oil in Water Measurements Using Portable Infrared Analyzers

    The Petroleum Industry – both offshore and onshore -- has regulations that limit the amount of oil in discharged water.  Fixed filter infrared (IR) analyzers have been used to test oil levels in produced water on drilling platforms for over 45 years for a number of reasons. On oil rigs where real estate is at a premium, infrared analyzers such as the Wilks InfraCal TOG/TPH ...


    By Spectro Scientific

  • New White Paper on FTIR multigas analysis

    Quantitech has announced the publication of a free White Paper on the simultaneous measurement of multiple gases in a wide variety of applications using FTIR (Fourier Transform InfraRed) technology. With the ability to measure almost any gas, FTIR monitoring technology is employed in an enormous variety of applications including Continuous Emissions Monitoring, Stack Testing, Process Control, ...


    By Quantitech Ltd

  • Portable Infrared Analyzers Provide On-Site Measurement of Oil and Grease Levels in Hydraulic Fracturing Water

    The amount of water used in and produced by hydraulic fracturing of shale gas wells is in the millions of gallons per well.  Whether the water is going to be taken off-site for disposal or reused for re-injection, the flowback or produced water needs pretreatment to remove any residual oil from the water.  Waiting for remote laboratory results to determine the oil level can take several ...


    By Spectro Scientific

  • The Effect of Biodiesel Feedstocks on Infrared Blend Measurements

    This White Paper addresses the common concern among biodiesel blenders and distributors as to whether or not biodiesel made from different feedstocks such as soy, waste vegetable oil or palm oil will affect the blend measurement.  The data presented, as well as the chemistry, shows that infrared measurements offer a reliable analytical technique for checking biodiesel blend. Portable ...


    By Spectro Scientific

  • Portable IR Analyzers Provide Petroleum & Wastewater Industries with Accurate Oil Content Measurements

    Fixed filter infrared (IR) analyzers have been used to test oil levels in produced water on off-shore and on-shore drilling platforms for well over 45 years. U.S. EPA methods 418.1 and 413.2 were used extensively on a worldwide basis until the Montreal Protocol called for Freon (the solvent used in the analysis) to be phased out. Infrared analysis using tetrachloroethylene (perchloroethylene) is ...


    By Spectro Scientific

  • A novel spectrometer design for process and handheld infrared spectral measurements

    Introduction Infrared spectroscopy offers many unique advantages for measurements within an industrial environment. Historically, the technique has been used for a broad range of applications from the composition of gas and liquid mixtures to the analysis of trace components for gas purity analysis. In cases where a well-defined method of analysis is involved, such as the measurement of ...


    By CIC Photonics, Inc.

  • Comparison of EN 14078 and ASTM D7371 infrared biodiesel methods

    Infrared (IR) analysis is the most widely used measurement technology for measuring biodiesel in diesel. Both EN 14078 and ASTM D7371 methods use infrared as the analytical method and more specifically FTIR (Fourier Transform Infrared) spectroscopy. Infrared is a common spectroscopic technique used for quantitative and qualitative analysis. In the biodiesel measurement, the fatty acid methyl ...


    By Spectro Scientific

  • Get Comparable ASTM/EN Data for Biodiesel Blend Measurements While Saving Time and Money using Portable IR Analyzers

    Both EN 14078 and ASTM D7371 methods for measuring the percent biodiesel in diesel fuel use infrared analysis as the analytical method and are based around using an FTIR spectrometer which has the capability to do a multitude of analyses besides the biodiesel in diesel measurement. This is great for a laboratory where various biofuels measurements are required. However, if the only measurement ...


    By Spectro Scientific

  • Portable IR Analyzer Provides ASTM Field Test Method for Measuring Soot Levels In Diesel Engine Lubricating Oils

    The InfraCal Soot Meter, from Wilks Enterprise, gives users an approved ASTM testing method for measuring the percent level of soot in diesel engine lubricating oils -- ASTM Method D7686-2011 entitled “Test Method for Field-Based Condition Monitoring of Soot in In-Service Lubricants Using a Fixed-Filter Infrared (IR) instrument.” While there is widespread disagreement on used-diesel ...


    By Spectro Scientific

  • Portable IR analyzers: the ideal measurement solution for biofuels blend quality and wastewater testing

    Two challenges facing the biofuels industry involve compliance with blend quality standards and wastewater regulations. According to a study done by the National Renewable Energy Laboratory, 1 the chief problem found with biodiesel blends was inaccurate blend ratios. Retail customers and fleet managers do not typically worry about whether the blend ratio is correct until a problem occurs. For ...


    By Spectro Scientific

  • On-Site TPH in Soil Measurements in less than 15 Minutes with Portable IR Analyzers

    On-site analysis of total petroleum hydrocarbon (TPH) concentration levels in soil are easily handled using the InfraCal TOG/TPH Analyzers manufactured by Wilks Enterprise, Inc.  The InfraCal TOG/TPH Analyzers are portable infrared (IR) analyzers that quickly determine TPH levels in less than 10-15 minutes, including the extraction.  Concentrations as low as 10 ppm to well over 10,000 - ...


    By Spectro Scientific

  • Comply with Permit Levels for Fats, Oil and Grease in Wastewater using Portable IR Analyzers

    Wilks InfraCal TOG/TPH Analyzers provide accurate, on-site analysis to help regulators and industry reduce the discharge of fats, oil and grease in wastewater.  On-site testing with the portable mid-IR InfraCal Analyzer gives results in 10 minutes and eliminates the wait for off-site lab results.  It is simple enough for an operator with minimal training to do the analysis. Stricter ...


    By Spectro Scientific

  • Infrared Analysis Reduces Regulatory Fats, Oil and Grease (FOG) Testing Costs and Provides Fast Results

    Wastewater professionals who are enforcing industrial effluent standards for fats, oil and grease (FOG) either must perform numerous gravimetric tests or spend a considerable amount of money with a contracted testing laboratory.  Infrared analysis. using portable instruments such as the InfraCal TOG/TPH Analylzers -provides an alternative which will significantly reduce costs and ...


    By Spectro Scientific

  • On-Site Ethanol in Gasoline Blend Analysis Saves Money and Eliminates Uncertainty in Fuel Blends

    The use of ethanol as a gasoline additive has increased dramatically over the past few years and will likely continue to increase.  For fuel blenders, this means an added challenge to avoid an incorrect blend that could lead to regulatory fines, loss of customer confidence and damage to equipment.  A quick on-site analysis with a portable mid-infrared based analyzer, such as the Wilks ...


    By Spectro Scientific

  • New ASTM Test Method Offers Quick and Easy Oil and Grease Measurement for Water and Soil Samples

    Onsite Field Measurement of Oil and Grease A quick and easy field analysis method for determining oil and grease concentration levels is important for both offshore oil platforms and soil remediation sites.. Prior to the Montreal Protocol, infrared (IR) analysis using Freon as an extraction solvent was a widely used field and laboratory method. In 1999, the U.S. EPA promulgated Method 1664A ...


    By Spectro Scientific

  • On-Site TPH in Soil Measurements

    On-site analysis of total petroleum hydrocarbon (TPH) concentration levels in soil are easily handled using the InfraCal TOG/TPH Analyzers manufactured by Wilks Enterprise, Inc.  The InfraCal TOG/TPH Analyzers are portable infrared (IR) analyzers that quickly determine TPH levels in less than 10-15 minutes, including the extraction.  Concentrations as low as 10 ppm to well over 10,000 - ...


    By Spectro Scientific

  • Oil in frac water testing

    The amount of water used in and produced by hydraulic fracturing of shale gas wells is in the millions of gallons per well. Whether the water is going to be taken off site for disposal or reused for re-injection, the flowback or produced water needs pretreatment to remove any residual oil from the wa-ter. Waiting for remote laboratory results can take several days to a week. The InfraCal TOG/TPH ...


    By Spectro Scientific

  • New White Paper features Solvents for Oil and Grease in Water Measurements

    A White Paper entitled, “Solvent Choices for Infrared Testing of Oil and Grease in Water” was recently published by Wilks Enterprise, Inc.  Infrared (IR) analysis is widely used worldwide for determining the amount of oil and grease in water as it is a cost-effective measurement technique that can be easily done on-site or in a laboratory.  Since water is a strong absorber ...


    By Spectro Scientific

  • Accurately Measure Hydrocarbon (Oil/Grease) Levels in Produced Water in Under 15 Minutes

    Determining total hydrocarbon or oil/grease levels to ensure compliance with regulatory permit requirements for discharging produced water is a worldwide problem facing the oil and gas industry.   Ensuring compliance with these regulations and avoiding fines for non-compliant discharges requires more frequent wastewater measurements to determine the total hydrocarbon ...


    By Spectro Scientific

Need help finding the right suppliers? Try XPRT Sourcing. Let the XPRTs do the work for you