process gas detector Articles

  • Survey of standards related to gas detectors

    Recent events both on- and off-shore shine a bright light on the need for attention to safety and to hazard reduction, prevention, and mitigation. Errant combustible or toxic gases can injure and kill quickly. Therefore, mitigation of these hazards must be fast and sure. Globally, governmental and regional authorities take gas detection and system integration very seriously and require that the ...

  • A Guide to Gas Detector Tubes. Your Questions Answered

    Gas detector tubes are easy to use, are low cost, and the method is intrinsically safe, allowing it to be deployed in all industries. Because detector tubes don’t require calibration, users see the benefits of this technology over electronic gas detectors due to their ease of ...


    By a1-cbiss

  • A Four Channel Gas Detector for Wastewater Treatment Plants

    Common hazardous gases found in wastewater treatment plant facilities are hydrogen sulphide, methane, ammonia, carbon monoxide, chlorine and oxygen deficiency. Some facilities may also use ozone, chlorine dioxide or sodium hypochlorite with the chlorine during the sanitization treatment process. Furthermore, sulphur dioxide is often used to de-chlorinate the water once the treatment process is ...

  • IR Gas Detector Provides Rapid Response

    The advanced Model IR400 Point IR Combustible Gas Detector from General Monitors features an industry-leading three-second T90 response time to the presence of combustible hydrocarbon-based gases, which allows plant operators to respond quickly to gas leaks and ...


    By General Monitors

  • Benefits of HART Communication-Enabled Gas and Flame Detectors

    Catastrophic results can occur when a fire or a flammable/toxic gas release goes undetected in any petrochemical facility. For early warning and prompt hazard mitigation, flame detectors and gas detectors are essential tools. Clear, usable, diagnostic information from these detection instruments is extremely valuable in ensuring the devices are properly maintained, tested, and poised to protect ...

  • Selecting and Placing Gas Detectors for Maximum Application Protection

    Many industrial processes involve dangerous gases and vapors: flammable, toxic, or both. With the different sensing technologies available, and the wide range of industrial applications that exist, selecting the best sensor and locating them properly for the job at hand can be a challenge. To ensure a high level of safety, know the latest sensing technologies, which technology is best for the ...

  • Laser gas detector systems for greenhouse gas emissions monitoring

    Two types of portable laser based gas detector for measuring emissions of the greenhouse gases carbon dioxide (CO2) and methane (CH4) from oil and gas operations are described. A scanning open path detector was developed within a Cooperative Research and Development Agreement (CRADA) with the USEPA. This system scans multiple paths across an area source in rapid succession, enabling calculation ...


    By Boreal Laser Inc.

  • Gas detector communication technology for offshore oil and gas platforms

    In few applications is safety as important as on offshore oil and gas platforms. Explosive hazards from hydrocarbon gases and vapours are an ever-present risk, whilst toxic hydrogen sulphide gas and depleted oxygen environments can pose significant risks to personnel. Gas detectors are therefore essential to provide dependable early warning of gas hazards. Gas detectors are permanently installed ...

  • PureAire Universal Gas Detector Offers Protection Against Toxic Levels of Ammonia

    In March of 2016, an ammonia gas leak at a seafood processing plant in Boston left one worker dead. The fumes at the plant were so powerful that firefighters could not promptly enter the scene to mitigate the gas leak and try to save the staff member until much later. Reports show that 5,300 pounds of ammonia gas leaked out of the plant. If you work with ammonia at your facility, learn ...

  • Safety Systems Depend on Reliable Field Sensors (Emphasis on Fire and Gas Detectors)

    Abstract Because not all hazards are the same, identifying and quantifying the hazard is the starting point in choosing sensing technology. Not all detectors are the same, and they should be selected according to their ability to detect the hazard. This paper gives a broad summary of technologies that provide users reliable responses to hazardous conditions, that minimise false ...

  • A Two Channel Gas Detector for Monitoring Hazardous Gases in the Workplace

    The potential for exposure to hazardous gases is a concern in many workplace environments. To ensure the safety of the workers, equipment, and the facility, areas presenting a gas hazard should be monitored by gas detectors. Commercial buildings that share a warehouse with manufacturing and/or service work in the back and offices in the front are a prime place for harmful gases and vapours ...

  • Improved HF monitoring in Primary Aluminium Smelters with Laser Gas Detectors

    Primary aluminium smelting generates large amounts of hydrogen fluoride gas (HF). Concerns for worker safety and ambient air quality require that HF be monitored at several locations in smelters. Historically, a variety of methods have been used for HF monitoring. Cassette samplers and wet chemistry techniques, coupled with complex and expensive ...


    By Boreal Laser Inc.

  • Leak detection in semiconductor fab gas processes

    Problem Statement Often times in semiconductor fabs moisture levels are monitored to ensure that products aren’t damaged by excess moisture in the process. If there are above normal levels of moisture, pinpointing the source of that moisture can be difficult. The moisture could be evolving from impurities in gas tanks or leaks in the sampling lines. One way to avoid downtime ...


    By CIC Photonics, Inc.

  • New Process Gas Analyzer for the Measurement of Water Vapor

    KEYWORDS TDLAS, WMS, Laser Spectroscopy, Water Vapor Measurement, Gas Analyzer ABSTRACT A new analyzer for the measurement of water vapor concentration based on Tunable Diode Laser Absorption Spectroscopy (TDLAS) was developed. The water-vapor line at 1854-nm was selected for the measurement, and the performance of the system was evaluated on different ...

  • Not All Hazards are the Same: Design considerations for matching flame and gas hazards to detector technologies

    Not all flame and gas hazards in facilities are the same, therefore the detection technology chosen should be specific to the type of hazard to be detected. How do users select technologies to see certain fires or detect certain gases? The intent of this paper is to give a broad introduction to the selection and use of flame and gas detector technologies. We will answer questions such as these: ...

  • Gas safety in confined spaces

    A confined space is any space large enough for someone to enter and perform assigned work, which has limited means of entry or exit, and which is not designed for continuous worker occupancy. This covers just about every industry, including utilities, construction, hydrocarbon exploration and processing, petrochemicals, marine, agriculture, food processing and ...

  • Gas Safety in Confined Spaces

    Introduction A confined space is any space large enough for someone to enter and perform assigned work, which has limited means of entry or exit, and which is not designed for continuous worker occupancy. This covers just about every industry, including utilities, construction, hydrocarbon exploration and processing, petrochemicals, marine, agriculture, food processing and brewing, as ...

  • Gas safety in confined spaces

    An engineer repairs buried cables; a plant manager enters a small plant room; a contractor inspects the lining of a sewage pipe.  All these personnel face a common danger, despite working in widely different industries.  Gas-related injury poses a serious threat in any confined space where the free movement of air is limited.  ...

  • Gas Safety in Confined Spaces

    Introduction An offshore worker ensures a vessel is safe to enter; a plant manager enters a small plant room; a contractor inspects the lining of a sewage pipe.  All these personnel face common dangers, despite working in widely different industries.  Gas-related injury poses a serious threat in any confined space where the free movement of air is limited. A confined space ...

  • Monitoring the performance of moisture purifiers for process gases

    Problem Statement Moisture purifiers are a big aid in keeping moisture levels under control inside a process chamber. They are provided by manufacturers with certain life expectancies, which vary depending on the moisture content of the gas being purified. As a result, it is difficult to determine which gases have a high moisture content and which moisture purifier is becoming ...


    By CIC Photonics, Inc.

Need help finding the right suppliers? Try XPRT Sourcing. Let the XPRTs do the work for you